成品油储罐内的腐蚀及防护

对成品油储罐内各部位腐蚀情况进行了介绍，说明了产生腐蚀的原因和腐蚀机理。介绍了油罐内防护技术，采用节点加固，降低边缘应力，可减缓油罐金属腐蚀速度；对选用油罐内防腐涂料的原则进行了阐述。     

Fire performance of wood (Pinus radiata) treated with fire retardants and a wood preservative

In this work, we co‐formulated an oil‐borne copper naphthenate/permethrin wood preservative system with synthetic polymer‐based fire‐retardant additives prior to the impregnation of Pinus radiata sapwood. We evaluated what effect, if any, the preservative had upon the fire performance properties of the fire retardants and whether the fire retardants impacted on the fungicidal and termiticidal efficacy of the preservative. The fire retardants included halogenated and phosphorus‐based systems. A mass loss calorimeter, in conjunction with a thermopile, was used to measure the time to ignition and the peak heat release rate (PHRR) from which the fire performance index (FPI) was determined. The preservative properties were evaluated using termite and soil‐block decay bioassays. In summary, we found that the rate of fire growth was reduced when the fire retardants were used in combination with the wood preservative. We also found that the PHRR was a better determinant of fire performance than the FPI. The performance of the wood preservative was enhanced against fungal decay and termite attack when used in combination with the fire retardants. The fire retardants also demonstrated some wood preservative properties of their own. Copyright © 2008 John Wiley & Sons, Ltd.     

基于ANSYS的铸嘴流体耦合场三维有限元仿真分析

作者用大型有限元分析软件ANSYS对铸嘴内稳态层流铝熔体进行仿真分析。实现了三维建模。解决了三维热一流耦合求解的问题，得到铝流体的速度、压力及温度的分布图。分析了铸嘴出口速度和温度的分布规律及其对连续铸轧的影响。     

超低渗广谱油层保护技术在板深51区块的应用

板深51区块存在压力敏感地层，在非目的层井段存在大段高渗低压砂岩，而目的层又属于高压低渗地层，属于难采油气田。室内进行的砂床滤失量、砂床封堵带承压能力、岩心封堵带的承压能力及油气层保护效果实验表明，在超低渗钻井液中增加固相含量，能够提高超低渗透膜结构强度，提高地层承压能力，降低砂床侵入深度，增强保护油气层效果，而且有选择性地增加有用固相效果更佳。基于这一理论，研究成功了超低渗广谱屏蔽暂堵油层保护技术，并在板深51区块长22—15井和长23—17K井进行了试验应用。该技术的关键是依据地层特性确定复配暂堵剂。长22-15井和长23-17K井射孔后未经过压裂、酸化、排液处理，获自喷高产，尤其是长22-15井形成自喷油流，创油田单井试采产量最高记录。应用结果表明，超低渗广谱保护油气层钻井液技术封堵隔层的承压能力强，很大程度地提高了漏失层的承压能力和破裂压力，较好地解决了含多套压力层系长裸眼段钻井过程中发生的漏失、井喷、卡钻、油气层保护等技术难题。     

MC^2电缆介质结构及阻抗分析

本文将用数学和实验两种方法证实MC～2电缆不仅能保证特性阻抗变化不超出电缆技术规范。而且能保证在设计频率范围内电缆结构反射损耗最小。     

东海西湖凹陷探井钻井完井液技术

介绍了东海西湖凹陷的储层特征。在分析探井储层损害原因的基础上，提出了优化的海水钻井完井液体系。两口井应用表明，储层保护效果明显。     

流体在环形狭缝中流动时园柱体的微振动

本文讨论了在两个园柱体的环形狭缝中不可压缩流体的流动．在一定的假设下，运用流体力学方程和流体对柱体的作用方程，导出了附加质量和转动惯量、振动频率和衰减系数．并对文（１）中的某些结果进行了必要的修正．     

Evaluation of Serum Volume Losses During Long-Term Storage

Aliquots of serum collected in a large case-control study of cervical cancer were stored at −70°C for up to 4 years during implementation of the study. When 500 μL serum aliquots were thawed in preparation for carotenoid and vitamin A assays, volumes were noticeably variable and fell below 500 μL in the majority of the samples. We were concerned about evaporation/sublimation during storage of the samples because loss of water would concentrate the analytes of interest. We evaluated the use of density and sodium ion concentration measurements to confirm its occurrence. We found that serum density was an unreliable indicator of extent of volume loss since the anticipated increases in density due to evaporation were of the same magnitude as inter-individual variation in serum density. In contrast, Na⁺ concentration is tightly regulated and would rise if water had been lost from the samples. In a representative sample of serum aliquots from the case-control study, 24 of 25 vials contained less than 500 μL of serum. The mean sodium ion concentration (138.1 ± 3.6 mmol/L) was within the normal range for human serum of 136–145 mmol/L, and no correlation was observed between serum volume and Na⁺ concentration. These results strongly suggest that the observed low volumes were not due to evaporative losses. Instead, the variably low volumes of serum aliquots were probably due to pipetting errors in the initial aliquotting resulting from the use of air-displacement pipettes.     

高砂比压裂技术研究

应用由美国ＮＳＩ公司引进的“ｓｔｉｍｐｌａｎ”拟三维压裂设计软件，对影响裂缝内支撑剂铺置浓度的诸因素进行了灰色关联度分析，从中找出了主要的影响因素。并以高砂比压裂的技术指标为依据，研究了在目前压裂工艺水平下，进行高砂比压裂所必须遵循的原则。文中还对国内的高砂比压裂进行了实例分析，进一步论证了文中的观点。     

乙烯裂解炉辐射段流动与燃烧的三维数值模拟

用计算流体力学软件Fluent6.2对中国石油化工股份有限公司燕山分公司E-BA-107乙烯裂解炉辐射段内的流动和燃烧做了三维数值模拟研究。为保证计算的准确性,使用GAMBIT2.2软件建立了与裂解炉实际尺寸完全一致的几何模型;在计算过程中采用了标准k-ε湍流模型、离散坐标辐射模型和有限速率/涡流耗散燃烧反应模型等计算模型。通过模拟计算得到了裂解炉炉膛内的温度、烟气流速及烟气组成的分布:底部燃烧器和侧壁燃烧器的燃烧使附近的炉墙处于温度分布均匀的高温区,为裂解反应提供了均匀的辐射墙面;炉管底部比其他部位的温度低;底部燃烧器的高速射流产生的旋涡可为炉管提供一定的对流热;出口烟气的平均温度和组成的模拟计算值与设计值接近,表明数值模拟有较高的精度,具有实际意义。