Power Dissipation in Spintronic Devices Out of Thermodynamic Equilibrium

Quantum limits of power dissipation in spintronic computing are estimated. A computing element composed of a single electron in a quantum dot is considered. Dynamics of its spin due to external magnetic field and interaction with adjacent dots are described via the Bloch equations. Spin relaxation due to magnetic noise from various sources is described as coupling to a reservoir. Resulting dissipation of energy is calculated and is shown to be much less than the thermal limit, ∼kT per bit, if the rate of spin relaxation is much slower than the switching rate. Clues on how to engineer an energy efficient spintronic device are provided.     

On the hollowness ratio effect on the dynamics of a spinning Rayleigh beam

The analytical solutions of a spinning Rayleigh beam with rotatory moment inertia and gyroscopic effect are presented in this paper. The critical speeds can be written analytically in a function of the length-to-radius ratio (l) defined by the beam's length over its outer radius and the hollowness ratio (α) defined by the hollow area over the total area of the cross section. The sensitivity analyses show that the critical speed is decreasing with l, but increasing with α. Moreover, α is more sensitive to the critical speeds. The design of a spinning beam should therefore be emphasized more on the hollowness factor. Contrary to common belief, only finite critical speeds exist and the number is independent of the boundary conditions. It increases monotonically with l, but decreases with α. The steady state unbalanced response can therefore be expressed analytically by the finite precessional modes and the corresponding generalized coordinates.     

Nutrient removal performance of an anaerobic–anoxic–aerobic process as a function of influent C/P ratio

The laboratory scale anaerobic–anoxic–aerobic (A²O) process fed with synthetic brewage wastewater was designed to investigate the effects of changing feed C/P ratio on the performance of biological nutrient removal (BNR) processes. In the experiment, the influent chemical oxygen demand (COD) concentration was kept at approximately 300 mg L^?1 while the total phosphorus concentration was varied to obtain the desired C/P ratio. Results showed that when the C/P ratio was lower than 32, phosphorus removal efficiency increased as C/P ratio increased linearly, while when the C/P ratio was higher than 32, the P removal efficiency was maintained at 90–98%, and effluent P concentration was lower than 0.5 mg L^?1. However, regardless of the C/P ratio, excellent COD removal (90% or higher) and good total nitrogen removal (75–84%) were maintained throughout the experiments. It was also found that very good linear correlation was obtained between COD uptake per unit P released in the anaerobic zone and C/P ratio. In addition, the P content in the wasted activated sludge increased with the decrease in the C/P ratio. Based on the results, it was recommended that the wastewater C/P ratio and its effects be incorporated into BNR design and operational procedures, appropriate C/P ratios were used to achieve the effluent treatment goals. Copyright © 2005 Society of Chemical Industry     

利津地区深层沙三、沙四段油藏测试评价

利用测试资料，将利津地区深层沙三、沙四段油藏分为5种油藏类型：①高压、低-极低渗、导数曲线后期上翘、地层存在非均质性的油藏；②高压、低渗、无污染、双孔介质的油藏；③高压、低-中渗、无-轻微污染的复合油藏；④常-高压、低渗、有污染的油藏；⑤常-高压、极低渗、无污染、干层的油藏。最后对利津地区深层沙三、沙四段各种类型油藏进行了评价，认为利津地区深层沙三、沙四段自然产能较低，一般需要进行改造措施来提高渗透性，提高产能。     

小高层剪力墙结构开洞设计探讨

小高层建筑需通过剪力墙开洞(结构开洞)降低侧向刚度,本文对开洞部位以及墙肢和连梁设计提出一些看法,供设计人员参考。     

低熔封接玻璃组成及其发展

综述了低熔封接玻璃的组成特点，给出了大量低熔玻璃组成实例，批出了低熔封接玻璃的封接低温化和无铅化发展方向，磷酸盐玻璃是首选组成之一。新的制备工艺和新的玻璃形成体系将对封接玻璃发展起着十分重要的作用。     

降低氧化铝生产中熟料折合比的探讨

在氧化铝生产过程中，熟料折合比是烧结法一项重要的综合性指标，本文通过对熟料折合比的定义、计算公式的剖析，分析了生产过程中影响熟料折合比的主要因素，对有效降低熟料折合比的措施进行了探讨。     

Scanning electron microscope electron detector with a radial type discrete dynode electron multiplier

A discrete dynode electron multiplier with radial flux of electrons was built and tested in the range of low‐voltage scanning electron microscopy as a backscattered electron detector of topographic contrast. The multiplier collects backscattered electron emitted in a specific range of take‐off angles and over the whole azimuth angular range enabling large solid collection angle. Multipliers with different dynode shapes were studied theoretically with the use of the software for particle optics and three assemblies were built and tested experimentally. The gain estimation, assessment of the type of detected electrons (secondary electron or backscattered electron), imaging the spatial collection efficiency and signal‐to‐noise measurements were performed.     

耀江大厦顶层屋面热泵的振动治理

本文通过耀江大厦27层屋面上六台热泵振动治理前后的振动和噪声测试数据的对比，简要阐述了安装在屋面上热泵的振动影响的程度和范围、产生振动影响和固体噪声传递的原因，并介绍了热泵双层隔振的方法和隔振效果。     

低温吸附法脱除一氧化碳中甲烷的实验研究

在液氮温度下,采用吸附剂CNA X进行低温脱甲烷动态吸附实验,结果表明CNA X在液氮温度下可以将一氧化碳中0 1%左右的甲烷脱除到10×10-6。