人群头发元素分布及某些特征研究

本文介绍用堆中子活化分析法测定人群头发中I、Br、Mg、Mn、Cu、Na、V、Cl、Al、Ca、S等11种元素。研究人发中元素分布特征、相关性特征、性别年令分布特征。方法学中还从法庭科学应用角度介绍同一性识别中差异率和重合几率的双判据方法。     

基于小波的实时烟雾检测*

传统的离子式、吸气式、光电式等烟雾检测器在大空间中检测烟雾时,会受到发射信号与接收信号之间的距离、平面角度、精确对准等限制,无法对整个空间的烟雾状况进行描述.新的方法通过监测区域的摄像机拍摄的视频图像序列,进行小波变换,分析图像帧在时域和空域的频率特性,来确定被监测区域是否有火灾烟雾的发生.实验证明该方法不受空间高度、热障、易爆、有毒等环境的限制,并且有灵敏度高、抗干扰力强、适用范围广等特点.     

电感电容损耗电阻的讨论

通过对电容电感阻抗的测量，发现实验值偏离理论值。定性地分析了误差的来源，得出的结论是电感电容内部的损耗电阻随着频率的变化而变化，变化方向相反而并非相同。     

萃取预分离法分离富铕中钇矿新工艺

采用一种新的串级萃取方式--萃取预分离法分离富铕中钇矿的新工艺.原料首先流入十几的三出口预先粗分离工艺,其萃余液La～Gd(TbDy)直接流入Nd/Sm工艺;中间出口流入(Gd)Tb～HoY(Er)Gd～Dy/Ho～LuY细分离工艺;出口负载有机相(Ho)Er～LuY流入Gd～Dy/Ho～LuY的洗涤段.结果表明,新工艺的粗分离工艺将占原料约70%的La～Gd(TbDy)预分离掉,使流入Gd～Dy/Ho～LuY工艺的稀土量减少约70%;由于Gd～Dy/Ho～LuY分组的萃余液GdTbDy含Ho2O3小于0.03%,省去原工艺的GdTbDy/HoY分离;新工艺的处理能力提高30%,酸碱消耗减少20%以上,贵重稀土元素Eu和Tb的存槽量大大减少.     

FC-26高中油型加氢裂化催化剂的工艺研究

抚顺石油化工研究院研制开发的新一代FC -2 6高中油型加氢裂化催化剂 ,以W -Ni为加氢组分 ,以无定型硅铝为主载体 ,并添加改性分子筛。工艺研究及工业应用结果表明 ,FC -2 6催化剂活性及中油选择性高 ,稳定性好 ,原料适应性强 ,具有广阔的应用前景。     

Response of the seated human body to whole-body vertical vibration: biodynamic responses to sinusoidal and random vibration

The dependence of biodynamic responses of the seated human body on the frequency, magnitude and waveform of vertical vibration has been studied in 20 males and 20 females. With sinusoidal vibration (13 frequencies from 1 to 16 Hz) at five magnitudes (0.1–1.6 ms^? 2 r.m.s.) and with random vibration (1–16 Hz) at the same magnitudes, the apparent mass of the body was similar with random and sinusoidal vibration of the same overall magnitude. With increasing magnitude of vibration, the stiffness and damping of a model fitted to the apparent mass reduced and the resonance frequency decreased (from 6.5 to 4.5 Hz). Male and female subjects had similar apparent mass (after adjusting for subject weight) and a similar principal resonance frequency with both random and sinusoidal vibration. The change in biodynamic response with increasing vibration magnitude depends on the frequency of the vibration excitation, but is similar with sinusoidal and random excitation.     

Response of the seated human body to whole-body vertical vibration: discomfort caused by sinusoidal vibration

Frequency weightings for predicting vibration discomfort assume the same frequency-dependence at all magnitudes of vibration, whereas biodynamic studies show that the frequency-dependence of the human body depends on the magnitude of vibration. This study investigated how the frequency-dependence of vibration discomfort depends on the acceleration and the force at the subject–seat interface. Using magnitude estimation, 20 males and 20 females judged their discomfort caused by sinusoidal vertical acceleration at 13 frequencies (1–16 Hz) at magnitudes from 0.1 to 4.0 ms^? 2 r.m.s. The frequency-dependence of their equivalent comfort contours depended on the magnitude of vibration, but was less dependent on the magnitude of dynamic force than the magnitude of acceleration, consistent with the biodynamic non-linearity of the body causing some of the magnitude-dependence of equivalent comfort contours. There were significant associations between the biodynamic responses and subjective responses at all frequencies in the range 1–16 Hz.

Practitioner Summary: Vertical seat vibration causes discomfort in many forms of transport. This study provides the frequency-dependence of vibration discomfort over a range of vibration magnitudes and shows how the frequency weightings in the current standards can be improved.     

A 5 GHz LC-VCO frequency synthesizer for unlicensed band of WiMAX

This paper presents a low power and low phase noise CMOS integer-N frequency synthesizer based on the charge-pump Phase Locked Loop (PLL) topology. The frequency synthesizer can be used for IEEE 802.16 unlicensed band of WiMAX (World Interoperability for Microwave Access). The operation frequency of the proposed design is ranged from 5.13 to 5.22 GHz. The proposed Voltage-Controlled Oscillator (VCO) achieves low power consumption and low phase noise. The high speed divider is implemented by an optimal extended true single phase clock (E-TSPC) prescaler. It can achieve higher operating frequency and lower power consumption. A new frequency divider is also proposed to eliminate the hardware overhead of the S counter in the conventional programmable divider. The proposed frequency synthesizer consists of a phase-frequency detector (PFD), a charge pump, a low-pass loop filter, a VCO, and a frequency divider. The simulated phase noise of the proposed VCO is −121.6 dBc/Hz at 1 MHz offset from the carrier frequency. The proposed frequency synthesizer consumes 13.1 mW. The chip with an area of 1.048 × 1.076 mm² is fabricated in a TSMC 0.18 μm CMOS 1P6M technology process.     

Effect of test frequency and water content on localized crack-tip heating in nylon-6,6

Fatigue crack propagation (FCP) tests were conducted at various frequencies on nylon-6,6 specimens equilibrated over a range of moisture levels to determine the crack growth rates and the crack-tip temperatures as a function of water content. Frequency-sensitivity was correlated with the amount of crack-tip heating taking place, with crack-tip temperature being found to depend strongly on the estimated loss compliance, D″, of the material. The frequency-sensitivity of FCP in nylon was seen also to be affected by mean stress, suggesting that creep processes are often significant in FCP of nylon.     

一种检测单晶炉热场温度的新方法

为去除单晶炉热场温度测量信号中的低频干扰、提高温度信号的估计精度,本文提出了一种基于跨维模拟退火(trans dimensional simulated annealing,TDSA)的单晶炉热场温度检测方法.该方法首先将AIC(Akaike information criterion)信号个数判断准则纳入采样机制中以便对干扰个数采样估计,进而利用所设计的基于信号频谱和轮盘赌思想的Metropolis Hastings机制对相应个数的干扰频率进行采样,最后设计了混合均匀和高斯采样机制对单晶炉热场温度进行采样估计.仿真和单晶炉工程实验结果表明,该方法在干扰个数未知的情况下,能够有效地抑制低频干扰、准确检测单晶炉热场的温度.