软弱破碎围岩隧道二衬施作的合理时机判别研究

为了合理判别软弱破碎围岩隧道的二衬施作时机,结合工程实践,通过洞室拱顶沉降和边墙变形收敛的现场监控量测,提出了利用围岩-初支系统变形实测数据判别软弱破碎围岩隧道二衬施作合理时机的考虑支护是否保守的五级速率比值法并研发了相应的软件,并通过工程实例进行了成功验证。研究表明：1研制的软件操作具有界面简洁、友好,以及操作简单易用的特点,具有测点围岩-初支系统位移和收敛的现场监测数据的录入、储存、修改和管理等功能,能方便地进行软弱破碎围岩隧道的二衬合理时机判别;2通过工程实例验证分析表明,提出的方法是可行的,与现行的二衬时机选择的方法本质上是相同的,但更加具有可操作性,研究成果可以为同类型隧道的二衬时机选择提供可资借鉴的方法。     

Small-angle neutron scattering from branched epoxide resins

Small-angle neutron scattering experiments in the range of q² from 0.01 to 25 nm⁻² have been carried out on branched epoxide resins based on bisphenol-A at the Institute Laue—Langevin (I.L.L) in Grenoble (q=(4π/λ) sin(θ/2)). Measurements were made with six samples in the range of M_W from 1500 to 19 000 and four concentrations between 1.3 and 10% (w/w) in deuterated diglyme. The results are as follows: (i) The mean square radius of gyration follows a relationship S²_z=4.69×10⁻⁴M^1.20_W (nm²). (ii) In all cases fairly large second virial coefficients A₂ are obtained which, however, decrease strongly with molecular weight. Above M_W=2500, the virial coefficient follows the relationship A₂=1.6M^−0.85_W (mol cm³g⁻²). (ii) The reciprocal particle scattering factor as a function of q² exhibits only a slight upturn and otherwise shows the behaviour of a randomly branched polycondensate. The slight upturn is discussed as being caused by the finite volume of the monomeric unit. Possible reasons for the high exponent in the S²_z versus M_W dependence are briefly discussed.     

Solvent extraction of oil from soybean flour II— pilot plant and two-solvent extractions

The process of grinding soybeans to a fine flour and extracting the flour with hexane was studied on a pilot plant scale. The crude oil from the pilot plant study had 15 ppm phosphorus and was suitable for physical refining after a light acid pretreatment and bleaching. The refined oil showed a Lovibond color of 1.4 yellow and 0.3 red. The pilot plant study also showed that grinding of the soybeans and the separation of solid from miscella were the most difficult steps in solvent extraction with fine flour. A laboratory study on separation of miscella from meal by aqueous ethanol reduced the hold-up volume, but it did not remove all the miscella. A test with betacarotene showed that only the miscella outside the flour particles was displaced. Aqueous ethanol solutions used as a second solvent extracted additional nontriglyceride materials (primarily phospholipids) from the meal. Also, the free fatty acid content of the oil was increased with aqueous ethanol solution wash. The quality of the extracted crude oil was lowered by using a second solvent, but it had the advantage of needing only one centrifugation to separate miscella from meal.     

壳聚糖/羧甲基壳聚糖止血膜的制备与表征

针对壳聚糖止血膜柔韧性差的问题,以丙三醇和酚磺乙胺作为改性剂,采用溶液浇膜的方法制备了不同组成配比的壳聚糖(CS)/羧甲基壳聚糖(CMCS)止血膜,并评价了CS/CMCS止血膜拉伸性能和止血效果.丙三醇的引入可使CS/CMCS止血膜的断裂伸长率提高4~7倍,尽管其拉伸强度也降低了70%.丙三醇改性的CS/CMCS=8/2载药止血膜具有较好的拉伸强度(10.4±0.9 MPa)和断裂伸长率(50.4±4.5%);与未加入酚磺乙胺的CS/CMCS止血膜相比,酚磺乙胺的离子交联作用使CS/CMCS载药止血膜的拉伸强度提高55%,而断裂伸长率仅降低24%.止血评价结果表明经丙三醇改性的CS/CMCS=8/2止血膜均能使血液发生分离的时间明显缩短,并具有促使血液凝结形成黑色血块的能力.     

关于语言输出理论的研究、探讨和启示

Swain的可理解输出假设理论认为输出在二语习得学习中具有重要作用。文章简单地介绍了关于语言输出的基本信息,回顾了我国关于语言输出对听力、口语和写作等方面的作用的研究,并提出了输出假设理论对我国外语教学改革的启示。     

Loss of Curing Agent During Thin Film (Droplet) Curing of Thermoset Material

Recently, it has been reported by our group and others^1.2 that loss of curing agent is encountered during the curing of small droplets or thin films of amine cured epoxies. In our earlier study³ results were reported on loss of curing agent in small droplets used in conducting the rnicrobond, single fiber test for determination of interfacial shear strength (ISS). It was reported that use of a volatile curing agent (meta-phenylene diamine (m-PDA) with DGEBA resin) resulted in increasing amounts of curing agent being lost (as measured by T₈ of the cured droplets) with decreasing droplet size during the processing procedure. Droplets smaller than 150 micrometers were seen to lose up to 40% of the curing agent leading to alteration of the mechanical properties of the droplet and, therefore, causing measured values of ISS to be exceedingly low. Use of a less volatile curing agent (Jeffamine 700, a polyether diamine, Texaco Specialty Chemicals) in combination with DGEBA resin produced results which indicated that loss of curing agent was not occuring. This study was undertaken to show the relationships between film (or droplet) size and the amount of curing agent lost (during the processing) for three different aminecured epoxy systems.     

第二代农民工市民化与中国共产党执政能力建设

第二代农民工市民化利益要求的实现有助于从阶级基础、群众基础、执政理念、执政资源和执政环境等方面加强党的执政能力建设。在第二代农民工市民化背景下,党应该强化执政为民的理念,构建利益相关制度,强化第二代农民工的工人阶级意识和主人翁意识,鼓励他们积极参与政治生活,有组织、有秩序地进行利益表达,使他们充分享受到城市经济社会发展成果,同时提高党自身的执政能力。     

视觉检测系统中亮度不均匀背景的一种去除方法

刀具形状视觉检测系统中，照明不均匀对测量结果影响很大。针对这种情况，提出了基于二维二阶多项式拟合并去除不均匀背景的方法。遵循最小均方程差原理，给出了二维二阶拟合的矩阵表达式。在编制的程序中，拟合点以人机交互形式由鼠标点击选出，程序自动记录所选点的图象人材与亮度值信息，然后拟合出背景曲面，并以二值图象形式给出去除背景后的目标图象。对一幅光照模型未知的网络图象进行了背景去除，实验结果良好。     

基于TMS320C6678的多核程序加载研究与实现

针对多核D SP系统程序加载复杂的问题,基于T MS320C6678对多核程序加载进行了研究与设计。从一级引导程序出发,设计并优化了多核程序内容存储格式。设计了简洁的二级引导程序,以修正一级引导程序只识别主核程序入口地址,而从核入口地址缺失的现象。为了快速生成特定格式的多核程序内容,设计了多个工具用于添加S PI启动参数表、DDR3启动表、从核程序入口地址以及完成程序内容格式的转换。实现了S PI Flash多核程序加载以及基于I2C主模式的Nand Flash多核程序加载。     

1秒采集的三维头像摄影系统

为了实现高精度、快速度、低成本的三维头像建模,提出一个人体头部的三维摄影系统.该系统能够1 s采集用户的三维信息,3 min内建立照片真实感的三维模型.通过配置多目RGB-Depth相机摄影系统,保证1 s内完成对人体头部的全方位数据采集,进而对所得到的点云数据进行数据增强、配准、表面重建和着色,最终生成高逼真的三维头像模型.