破片式战斗部优化设计技术研究

侧重研究了破片式战斗部装药外形的优化设计技术。提出了装药外形与破片飞散特性（如破片飞散角，分布带宽等）之间的数学描述；建立了圆弧和对数螺线装药外形母线与战斗部其他设计参数间的数学模型。在假定约束条件下，优化设计了破片了聚焦式战斗部的结构参数；静爆试验结果表明，破片分布与理论计算吻合较好。     

A Study of AlN Films Prepared by Arc Ion Plating

Hexagonal AlN films have been obtained by arc ion plating at different negative biases ,X-ray diffraction and scanning electron microscopy results show that AlN films with smooth surfaces and (002) preferred orientation are obtained at low biases ,whereas those with coarse surfaces and (100) preferred orientation are obtained at high biases,The formation mechanism of AlN is analyzed and the experiment results are discussed,The effect of bias on adhesion strength has also been examined.     

Zeolite synthesis from paper sludge ash with addition of diatomite

BACKGROUND: This study aimed to investigate the synthesis of zeolites from paper sludge ash (PSA) with added diatomite to remove both NH₄⁺ and PO₄^3? for water purification. The PSA had low Si and significant Ca contents. Four types of diatomite: white (T‐W) and brown (T‐B) from deposits of marine origin in Takanosu, and white (S‐W) and gray (S‐G) from lacustrine deposits in Shonai, were added to NaOH solution to increase the Si content and thereby synthesize zeolites with high cation exchange capacity (CEC). RESULTS: The order of the amounts of Si extracted from the diatomite to the alkali solution was S‐W > T‐W = T‐B > S‐G, which correlates with the amorphous SiO₂ content of diatomite. The original ash without addition of diatomite yielded hydroxysodalite with CEC of about 1.0 mmol g^?1. For all samples, the addition of diatomite to the solution yielded zeolite‐P with a higher CEC, but the addition of excess Si inhibited the synthesis of zeolite‐P, and the CEC of the product was low. A product with high CEC including zeolite‐P was obtained in a solution with around 500 mmol L^?1 of Si concentration, and had the ability to remove both NH₄⁺ and PO₄^3?. CONCLUSION: Diatomite has the potential for used as an additive for the synthesis of high CEC zeolite from PSA. The product with zeolite‐P exhibited relatively high CEC, capacity for NH₄⁺ uptake, and the ability to remove PO₄^3? by precipitation, which is preferable for water purification applications. Copyright © 2008 Society of Chemical Industry     

One‐step production of 2,3‐butanediol from starch by secretory over‐expression of amylase in Klebsiella pneumoniae

BACKGROUND: 2,3‐Butanediol (2,3‐BD) is a valuable chemical that can be biosynthesized from many kinds of substrates. For commercial biological production of 2,3‐BD, it is desirable to use cheap substrate without pretreatment, such as starch. However, there have been few reports on the production of 2,3‐BD directly from starch. RESULTS: In this work, gene malS coding for α‐amylase (EC 3.2.1.1) precursor was inserted into plasmid pUC18K, and secretory over‐expression of α‐amylase was achieved by engineered Klebsiella pneumoniae. The extracellular recombinant amylase accelerated the hydrolyzation of starch, and one‐step production of 2,3‐BD from starch was carried out by engineered K. pneumoniae. A 2,3‐BD concentration of 3.8 g L^?1 and yield of 0.19 g 2,3‐BD g^?1 starch were obtained after 24 h fermentation. CONCLUSION: The one‐step production of 2,3‐BD from starch was achieved by secretory over‐expression of amylase in K. pneumoniae. This would simplify the process and reduce the production cost considerably by enabling use of starch with minimal pretreatment. Copyright © 2008 Society of Chemical Industry     

人类HLA-DRB1基因型与民族和人群的神经网络无监督模式分类

HLA-DRB1等位基因主要参与人类的抗原免疫功能,对其进行比较研究,有助于追溯人类的进化迁移史,开发类群特异性药物.本研究以Matlab为平台,用自组织竞争网络(Self-Organizing Competitive Neural Network),对世界54个民族和人群、14个HLA-DRB1等位基因,进行了无监督模式分类.结果表明,各民族之间存在差异性,同民族的各人群之间有相似性.西伯利亚各人群,澳洲各土著人群,黑人各人群,南美印第安各人群,犹太族各人群,日本各人群,及欧美白人各人群有相对独立性:南美印第安人与西伯利亚人有高度相似性;中国民族在南方人群和北方人群间存在较大差异;中国汉族中,广东汉族地位特殊,与少数民族如拉祜族、瑶族关系密切.     

Comparative study of the elimination of toluene vapours in twin biotrickling filters using two microorganisms Bacillus cereus S1 and S2

BACKGROUND: To investigate the microbial degradation performance of organic pollutants in the atmosphere using a biotrickling filter, two microorganism strains, Bacillus cereus S1 and Bacillus cereus S2, were selected, identified and inoculated into a twin biotrickling filter for comparison. RESULTS: Both strains showed good performance towards the degradation of model organic pollutants when gas flow rates ranged from 100 to 600 L h⁻¹. For S1, the total maximum removal efficiency (RE) of toluene was maintained nearly 100% not only at gas flow rates of 100 L h⁻¹ corresponding to empty bed residence time (EBRT) 199.44 s, but also at gas flow rates of 200 L h⁻¹ (EBRT = 99.72 s) and 300 L h⁻¹ (EBRT = 66.48 s). However, S2 had a much lower degradation capability; near 100% removal efficiency was obtained only at the gas flow rate of 100 L h⁻¹ although both bacteria belong to the same Bacillus cereus. With further increase in gas flow rate, the total REs for both S1 and S2 decreased slightly at first and then dropped sharply to 46% and 35%, respectively, at an EBRT of 33.24 s, corresponding to a gas flow rate of 600 L h⁻¹. Starvation for between 2 and 10 days resulted in the re‐acclimation times of both strains ranging between 1.0 and 15.5 h. CONCLUSION: Strain S1 would be a better choice for inoculation into a biotrickling filter than strain S2, because of its much higher toluene removal capacity and rapid recovery to full performance. Copyright © 2008 Society of Chemical Industry     

精对苯二甲酸反应器桨叶断裂分析与修复

为了保证进口精对苯二甲酸装置氧化反应器中钛制搅拌器的正常工作，对钛制搅拌器桨叶在运行中断裂脱落的原因进行了分析，并叙述了桨叶修理的方法和要求。经修理后的桨叶投入生产使用，达到了预期的目标。     

Kinetics study of Ti[O(CH2)4OCHCH2]4 initiated ring‐opening polymerization of ε‐caprolactone by differential scanning calorimetry

Chemical shrinkage was used for the in situ measurement of the progressing chemical stabilization reactions and the influence of ozone during the stabilization of polyacrylonitrile. A method for evaluating the activation energy through the sensitivity temperature is presented. The calculated results show that the activation energies were 161.57 kJ/mol in air and 181.23 kJ/mol in ozone-enriched air. Therefore, the chemical reactions were postponed during stabilization in ozone-enriched air. Ozone seemed to act in three ways: first, ozone promoted the formation of the serious skin–core structure. Second, ozone accelerated the chemical reactions and shortened the stabilization time at lower heating rates. Third, ozone postponed the chemical reactions. © 2008 Wiley Periodicals, Inc. J Appl Polym Sci 2008     

Synthesis and structural characterization of methacrylic acid/octadecyl acrylate‐graft‐poly(methylhydrosiloxane) by hydrosilylation

Methylmethacrylate (MMA) and octadecyl acrylate (OA) were grafted to poly(methylhydrosiloxane) (PMHS) by hydrosilylation, respectively, with hexachloroplatinic acid as catalyst, and the former was further hydrolyzed to prepare methacrylic acid (MAA)‐graft‐PMHS under the alkaline condition. Through orthogonal experiment, main factors affecting the graft reaction between OA and PMHS were discussed and arranged in a decreasing order according to their abilities of the effect on the hydrosilylation of OA with PMHS: catalyst dosage, reaction temperature, reaction time, material ratio, and solvent dosage. It was found that the hydrosilylation of OA with PMHS was easier to that of MMA with PMHS. Under optimal conditions, the grafting ratios of MMA with PMHS and OA with PMHS reached about 90 and 95%, respectively. FTIR and ¹H NMR spectra indicated that the hydrosilylation reactions followed the Markovnikov's rule and played a strong preference toward β‐1,2‐addition. The test of contact angle indicated that surface energy of a system was mainly dependent on the polar groups. The surface energy of OA‐graft‐PMHS (35.07 mN/m) was similar to those of PMHS (35.62 mN/m) and polyoctadecyl acrylate (36.57 mN/m), and lower than that of MAA‐graft‐PMHS (43.50 mN/m). © 2007 Wiley Periodicals, Inc. J Appl Polym Sci 2008     

Maghnite‐H+, a solid catalyst for the cationic polymerization of α‐methylstyrene

The polymerization of α‐methylstyrene (AMS) catalyzed by Maghnite‐H⁺ (Mag‐H) was investigated. Mag‐H is a montmorillonite sheet silicate clay, exchanged with protons. It was found that the cationic polymerization of AMS is initiated by Mag‐H at ambient temperature in bulk and in solution. The effect of the amount of Mag‐H, the temperature, and the solvent was studied. The polymerization rate increased with increase in the temperature and the proportion of catalyst, and it was larger in nonpolar solvents. These results indicated the cationic nature of the polymerization. It may be suggested that the polymerization is initiated by proton addition to monomer from Mag‐H. © 2008 Wiley Periodicals, Inc. J Appl Polym Sci, 2008