Phosphorus Inputs to Lake Simcoe from 1990 to 2003: Declines in Tributary Loads and Observations on Lake Water Quality

Total phosphorus (TP) inputs to Lake Simcoe have led to hypolimnetic dissolved oxygen (DO) depletion and loss of cold water fish habitat. Since 1990, efforts have been made to reduce the total TP input to the lake below a defined target of 75 t/year, which was predicted to lead to reductions in spring TP concentration and improvements in end-of-summer hypolimnetic DO concentrations. The total TP load to the lake during the most recent period of record (1998/99-2003/04) ranged from 53 to 76 t/yr and averaged 67 t/yr, compared to an average of 114 t/yr estimated between 1990/91 and 1997/98 (range 85-157 t/yr). Reductions in TP loads from the catchment via tributary discharge (∼26 t) accounted for the majority of the decrease in total load between the two time periods. Total P concentrations decreased significantly in four out of six long-term monitored tributaries; however, concentrations in all six tributaries remain above the level recommended to avoid nuisance plant growth (30 μg/L). Although TP loads to the lake are currently below the target 75 t/yr, excessive growths of filamentous algae and macrophytes continue to be a problem in the nearshore zone. End-of-summer minimum hypolimnetic DO concentrations (average 4.3 mg/L, 1998/99-2003/04) remain substantially below the level (7 mg/L) that is considered protective of lake trout. Efforts to reduce TP loads to the lake therefore need to continue.     

Diel Vertical Migration of Round Goby Larvae in the Great Lakes

One hypothesis for the transcontinental and intra-Great Lakes basin transfer of round gobies (Neogobius melanostomus) has been that round gobies were pumped into the ballast water of ships. During June 2005 in Lake Erie, we obtained evidence of a vertical migration of round goby larvae, when we collected 167 round goby larvae in surface ichthyoplankton net tows at night and zero during day. These results complemented similar findings from the Muskegon River estuary of Lake Michigan during 2003 and 2004, documenting diel vertical migration for the first time in larval round gobies. We suggest vertical migration behavior may have allowed larval round gobies to be transported to and within the Great Lakes via ballast water and dispersed in the Great Lakes via advection of 6.5–8.5-mm long larvae at the surface. Based on our results, if ballast water was only taken on near the surface during daylight hours from May through September when larval round gobies were present, it would have mitigated the spread of round gobies throughout the Great Lakes.     

Photoelectrocatalytic humic acid degradation kinetics and effect of pH,applied potential and inorganic ions

This study addresses the removal of humic acid (HA) dissolved in an aqueous medium by a photoelectrocatalytic process. UV₂₅₄ removal and the degradation of color (Vis₄₀₀) followed pseudo‐first order kinetics. Rate constants were 1.1 × 10^?1 min^?1, 8.3 × 10^?2 min^?1 and 2.49 × 10^?2 min^?1 (R² > 0.97) for UV₂₅₄ degradation and 1.7 × 10^?1 min^?1, 6.5 × 10^?2 min^?1 and 2.0 × 10^?2 min^?1 for color removal from 5 mg dm^?3, 10 mg dm^?3 and 25 mg dm^?3 HA respectively. Following a 2 h irradiation time, 96% of the color, 98% of the humic acid and 85% of the total organic carbon (TOC) was removed from an initial 25 mg dm^?3 HA solution in the photoanode cell. Photocatalytic removal on the same photoanode was also studied in order to compare the two methods of degradation. Results showed that the photoelectrocatalytic method was much more effective than the photocatalytic method especially at high pH values and with respect to UV₂₅₄ removal. The effect of other important reaction variables, eg pH, external potential and electrolyte concentration, on the photoelectrocatalytic HA degradation was also studied. Copyright © 2003 Society of Chemical Industry     

煤矿矿井水检测质量控制措施探讨

探讨了影响煤矿矿井水检测质量的主要因素,按照全过程、全要素控制的理念提出了检测前、检测中和检测后的控制措施。     

Application of a Three-dimensional Wind Driven Circulation Model to Assess the Locations of New Drinking Water Intakes in Lake Ontario

A 3D transport model is used to perform a comparative analysis of several potential drinking water intakes located along the northwest shore of Lake Ontario between Toronto and Oshawa. The model is specifically used to assess each intake under both long- and short-term transport of a potential pollutant release from the Pickering Nuclear Generating Station and potential and actual pollutant releases from local land sources respectively. A model based on a 500 m grid resolution is calibrated using data collected in the aftermath of the 1992 tritium spill at the Pickering Nuclear Generation Station and subsequently used to simulate long-term transport. A model based on a 100 m grid resolution is verified using drogue studies and used to simulate short-term transport events. Both models are used to assess pollutant levels at each of nine potential intake locations under different wind scenarios and pollutant releases. Field data for the study included water quality and flow measurements from local sewers and rivers, and estimates of pollutant levels from the local waste water treatment plants. This paper describes the model setup for both the long-term and short-term transport models, calibration using field data, long-term transport modeling, short-term transport modeling, and the comprehensive analysis approach used to evaluate the nine potential intake locations proposed. Results indicated that four intakes in particular outperformed other intake locations by maintaining bottom pollutant levels within governmental standards and warning times that exceeded 20 hours.     

Open‐cycle OTEC systems with freshwater product: Effects of noncondensable gases on performance of condenser

An open‐cycle ocean thermal energy conversion (OC‐OTEC) system is one of the energy conversion methods used to generate electricity from ocean thermal energy. For the OC‐OTEC system, steam evaporated from the surface seawater due to flash evaporation drives the turbine. At that time, dissolved gas such as air is introduced into the low‐pressure system (OC‐OTEC system) as the noncondensable gas, which degrades the performance of condensation heat transfer. In this paper, a small‐scale OC‐OTEC experimental unit experimentally investigates the effect of noncondensable gas on the heat transfer performance in a condenser. The experimental results are discussed in comparison with theoretical estimation by the Sparrow–in method. It is shown that the condensation is occupied by heat and mass transfer near a condensation surface and that the condensation efficiency is affected by exhaust quantity of noncondensable gas at a relatively high concentration ratio of condensable gas. © 2005 Wiley Periodicals, Inc. Electr Eng Jpn, 154(1): 29–35, 2006; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/eej.20179     

Effect of Channel Changes in the St. Clair River During the Present Century

Periodic man-made changes in the outlet of Lake Huron through the St. Clair River date back to the middle of the last century. These artificial channel changes have been well documented during the present century. They consist of dredging for commercial gravel removal in the upper river during 1908–25 and uncompensated navigation improvements for the 7.6-m (25-ft) and 8.2-m (27-ft) projects completed in 1933 and 1962, respectively. The total effect of these changes on the levels of Lakes Michigan and Huron (hydraulically one lake) and on the upper St. Clair River profile was determined with dynamic flow models. The ultimate effect of the above dredging was a permanent lowering of the Lake Michigan-Huron levels 0.27 m (0.89 ft), which represents a tremendous loss of freshwater resource [32 km³ (7.7 mi³)].     

A load dispatch method using fractional programming and semidefinite programming

This paper describes a load dispatch method which minimizes power cost—[fuel cost]/[electric output]—for a power system with thermal plants and energy storage facilities. The proposed method employs fractional programming to convert a minimization problem with fractional objective function to a series of quadratic minimization problems, and semidefinite programming to solve converted problems. The method provides the optimum time‐dependent power output/input and storage level of energy storage facilities as well as time‐dependent power output of thermal plants. The method has been applied to a power system with five thermal plants, two energy storage facilities of various performances, and five load demands. The optimum load scheme of four time mesh points is obtained for the thermal plants and energy storage facilities. The fractional programming successfully converges the optimal scheme through a few iterations. The semidefinite programming deals with a variable matrix of 164 dimensions, and 185 inequality constraints. © 2001 Scripta Technica, Electr Eng Jpn, 138(2): 49–58, 2002     

Effect of water inlet velocity on thermal stratification in a mantled hot water storage tank

Thermal stratification in a mantled hot water storage tank is analysed numerically for different water inlet velocities. The aim is to obtain higher thermal stratification and supply hot water for usage as long as possible. Twelve different water inlet velocities to the hot water storage tank are considered. The numerical method is validated by comparing its results against experimental and numerical results from the literature. It turned out that the results obtained from the numerical analysis have shown very good agreements with the results from previous works. As a result, the water temperature in the tank increases with the increase of the water inlet velocities to the mantle but this increment is not proportional. After a period of operation of 7.2 h, which corresponds to the average sunshine duration in Turkey, temperature increments of 6.5 and 35 K have been estimated for the hot water inlet velocities of 0.01 and 0.3 m s^?1, respectively, at a radial distance of 0.1 m and a height of 1 m inside the storage tank. Copyright © 2005 John Wiley & Sons, Ltd.     

Effect of pretreatments and freezing rate on the firmness of potato tissue after a freeze–thaw cycle

The texture of potato tissue after a freeze–thaw process using different freezing rates and different pretreatments was analysed, in order to select the best strategy for optimum preservation of the textural characteristics of pre‐frozen potato. Ten blanching conditions were tested and a two‐step blanching process with calcium chloride (0.07 g mL^?1) proved the most effective in protecting the tissue after a freeze–thaw process (maximum load force around 10–55% of the raw tissue, depending on potato batch, for air‐blast freezing and 20–60% for immersion freezing). Vacuum impregnation at 100 and 400 mbar, even when followed by different pre‐drying treatments to remove excess water, was very detrimental to resistance to a freeze–thaw process (maximum load force below 10% of the raw tissue for air‐blast freezing and below 20% for immersion freezing). Microstructure analysis confirmed better tissue integrity retention with ethyleneglycol immersion freezing instead of air‐freezing. Differences were found between batches with a 6‐month difference in storage time, indicating that the fresher batch was more suitable for freezing.