Thaumasite––direct, woodfordite and other possible formation routes

Two main formation routes for thaumasite exist below 15 °C. One is the direct route from C–S–H reacting with appropriate carbonate, sulfate, Ca²⁺ ions and excess water. The other route is the woodfordite route from ettringite reacting with C–S–H, carbonate, Ca²⁺ ions and excess water, in which thaumasite arises through the intermediate formation of the solid solution woodfordite. The woodfordite route for thaumasite formation appears to be relatively quicker (although still slow) than the direct route, presumably because with the former the ettringite already has the octahedral [M(OH)₆] units that can facilitate the critical change from [Al(OH)₆]³⁻ to [Si(OH)₆]²⁻ groupings. Both routes are mutually dependent on each other. The presence of magnesium salts can modify the path to thaumasite formation. High pressure might be able to stabilise [Si(OH)₆]²⁻ groupings and allow thaumasite to become formed above 15 °C. This possibility is discussed.     

丙烯酸/α-甲基丙烯酸/丙烯酰胺共聚物智能水凝胶的合成及评价

由丙烯酸（AA）、α-甲基丙烯酸（MAA）和丙烯酰胺（AM）合成了具有很好DH敏感性和一定温度敏感性的智能水凝胶，考察了合成温度、丙烯酰胺、交联剂和引发剂用量对制备的水凝胶溶胀性能的影响。结果表明，在60℃下，单体从和MAA用量分别为100mmol和75mmol时，单体AM、交联剂和引发剂用量分别为反应物总质量的32．8％、0．2％和0．4％时，制备的水凝胶溶胀性能最好。考察了介质的离子浓度、pH值和温度对水凝胶溶胀比的影响，结果表明，离子浓度越大，水凝胶的溶胀比越小；水凝胶具有一定的DH可逆性。     

3G网络中的IPv6 DNS服务器配置

说明了3G网络中IPv6递归DNS服务器地址配置的三种方法：路由器通告（RA）方案，DHCPv6方案，递归域名系统（DNS）服务器的公认任播地址方案，详细地说明了三种解决方案的操作特点。本文为3G中选择合适的方法进行主机DNS配置提供了指导。     

从RC5到RC6

论文详细描述并分析了从RC5到RC6的演化设计过程,在详细研究了RC6性能的同时,指出了应该如何从一个旧的密码设计出好的新密码。最后对RC6和Rijndael作了一些比较,指出各自在性能上的优缺点。     

Biotransformation of l‐menthol by twelve isolates of soil‐borne plant pathogenic fungi (Rhizoctonia solani) and classification of fungi

The microbial transformation of l‐menthol ( 1 ) was investigated by using 12 isolates of soil‐borne plant pathogenic fungi, Rhizoctonia solani (AG‐1‐IA Rs24, Joichi‐2, RRG97‐1; AG‐1‐IB TR22, R147, 110.4; AG‐1‐IC F‐1, F‐4, P‐1; AG‐1‐ID RCP‐1, RCP‐3, and RCP‐7) as a biocatalyst. Rhizoctonia solani F‐1, F‐4 and P‐1 showed 89.7–99.9% yields of converted product from 1 , RCP‐1, RCP‐3, and RCP‐7 26.0–26.9% and the other isolates 0.1–12.0%. In the cases of F‐1, F‐4 and P‐1, substrate 1 was converted to (?)‐(1S,3R,4S,6S)‐6‐hydroxymenthol ( 2 ), (?)‐(1S,3R,4S)‐1‐hydroxymenthol ( 3 ) and (+)‐(1S,3R,4R,6S)‐6,8‐dihydroxymenthol ( 4 ), which was a new compound. Substrate 1 was converted to 2 and/or 3 by RRG97‐1, 110.4, RCP‐1, RCP‐3 and RCP‐7. The structures of the metabolic products were elucidated on the basis of their spectral data. In addition, metabolic pathways of the biotransformation of 1 by Rhizoctonia solani are discussed. Finally, from the main component analysis and the differences in the yields of converted product from 1 , the 12 isolates of Rhizoctonia solani were divided into three groups based on an analysis of the metabolites. Copyright © 2003 Society of Chemical Industry     

癸二酸二甲酯与1,2,2,6,6-五甲基哌啶醇的酯交换反应

对癸二酸二甲酯与1,2,2,6,6-五甲基哌啶醇的酯交换反应进行了研究;分别考察了四异丙基钛酸酯、氨基锂、氧化二辛基锡3种催化剂的性能;采用氢核磁共振确定了产物的结构;考察了以四异丙基钛酸酯为催化剂时反应温度、反应时间、原料配比和催化剂用量对反应的影响。实验结果表明,四异丙基钛酸酯催化剂的催化效果最好;在癸二酸二甲酯与1,2,2,6,6-五甲基哌啶醇摩尔比1∶1.79、四异丙基钛酸酯催化剂的用量为反应物总质量的0.31%、反应温度180℃、反应时间6h的条件下,所得产物中单(1,2,2,6,6-五甲基-4-哌啶基)癸二酸甲酯(简称单酯)质量分数为23%和双(1,2,2,6,6-五甲基-4-哌啶基)癸二酸酯(简称双酯)质量分数为73%,单双酯质量比为1∶3.17,产物收率为93.3%。该方法可得到理想的单双酯比例及产物收率,具有很好的工业应用前景。     

Taxometrics in Psychopathology Research: An Introduction to Some of the Procedures and Related Methodological Issues.

This article introduces a special section on the use of taxometrics to examine the categorical versus the dimensional structure of various forms of psychopathology. Paving the way into the special section, this introduction briefly describes 3 taxometric methods--mean above minus below a sliding cut (MAMBAC), maximum covariation (MAXCOV), and maximum eigenvalue (MAXEIG)--and discusses possible threats to statistical conclusion validity that often emerge when such techniques are applied in psychopathology research. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

火炮身管内表面激光硬化处理的实验研究

提高身管寿命是火炮行业亟待解决的关键技术问题，激光表面改性技术是解决这一问题的有效方法之一。本文在分析激光表面相变硬化性能的基础上，对身管内表面进行了激光硬化处理实验研究，检测了其内表面阳线和阴线的硬化层硬度和深度，对比分析了离焦量和焦深对其内表面硬化层硬度的影响，并对激光相变硬化层金相组织进行了分析。经激光硬化处理后，身管的内表面硬度有明显提高，硬化层较深，且为很细的条状马氏体组织。     

IEEE 802.11g性能分析及应用

全面介绍IEEE802.11g标准的无线局域网,详细讲述IEEE802.11g草案标准的概念、产生背景、特点、构件及其体系结构和发展前景,探讨实现IEEE802.11gWLAN所需的关键技术及其双频多模应用方式,同时分析IEEE802.11g标准的网络性能。     

聚甲亚胺改性尼龙6复合材料的等温结晶动力学

采用差示扫描量热法（DSC）对聚甲亚胺（PAM）/尼龙6复合材料等温结晶过程进行了研究。结果表明，PAM的加入使得基体的结晶速率增大，尤其是当含量为5%时，半结晶期明显减少。研究还发现，该体系的等温结晶过程完全可以用Avrami方程来描述，各试样的Avrami指数均在2-3之间，表明Avrami指数，球晶生长方式基本不受聚甲亚胺加入的影响。基体中原位形成的聚甲胺微纤起到了诱导结晶的作用，使得基体的结晶速率加快，但随着微纤含量的增加，由于分散性能变差而使得诱导结晶的能力减弱，表现为结晶速率又有所降低。