环己烷液相无催化剂的氧化动力学研究

采用搅拌釜反应器,在确认已排除传质因素对反应速率影响的情况下,研究了环己烷液相无催化剂的氧化反应动力学。应用自由基理论及最优化计算技术,从导出的8个候选动力学模型中,确定了最佳的动力学模型,它能满意地描述环已烷氧化过程。该动力学可为环己烷氧化工业生产操作条件的优化、反应器的选型及工业设计提供依据。     

应用微扰理论（PHCT）诠释MH—55状态方程

用硬链微扰理论分析了ＭＨ－５５型状态方程。首次改进了该方程中的参考项，以ＣＳ硬球方程替代了原来的ｖａｎｄｅｒＷａａｌｓ斥力项，使改进后的ＭＨ－５５方程计算范围扩大到汽液两相。     

Synthesis and thermal properties of block copolyetheresters with poly(pentamethylene p,p′-bibenzoate) segments

The block copolyetheresters with hard segments of poly(pentamethylene p,p-bibenzoate) and soft segments of poly (tetramethylene ether) were prepared by melt polycondensation of dimethyl-p,p-bibenzoate, 1,5-pentanediol and poly (tetramethyene ether) glycol (PTMEG) with molecular weights of 650, 1000 and 2000. The results by NMR indicate that the polymer composition is determined by the charge molar ratio (x) of PTMEG to dimethyl-p,p-bibenzoate. The thermal transitions of the block copolyetheresters were investigated by DSC in combination with X-ray diffraction and polarized microscopy. Some block copolyetheresters exhibit a monotropic smectic phase due to the presence of the poly (pentamethylene p,p-bibenzoate) segments. As the molar content of PTMEG increases, the average sequence length of the polyester segments decreases, the isotropic-smectic transition temperature and the smectic order decrease accordingly. When x is as high as 0.3, the block copolyetheresters exhibit no liquid crystallinity.     

浅谈燃气轮机的清洗方法

由于燃气轮机吸收含有大量灰尘等杂质的空气,会在压气机叶片上形成积垢,从而导致机组出力下降,该文介绍在实际工作中,根据不同的情况使用不同的设备、采取不同的清洗方法来除去压气机叶片上的污垢,以提高整台机组的工作效率.     

The effect of Al content on the wettability between liquid iron and MgOAl2O3 binary substrate

In the present study, the wettability between liquid iron with two different Al contents and MgOAl₂O₃ binary substrates was studied in reducing atmosphere. The contact angles between liquid iron with 18?ppm Al and MgO, MgO·Al₂O₃, Al₂O₃ were 133.5°, 113.7°, 126.9° respectively. With the variation of the substrate composition, the contact angles for the intermediate binary phases of the three components (MgO, MgO·Al₂O₃, Al₂O₃) obeyed the Cassie theory. In the experiment using iron with 370?ppm Al, all the contact angles were higher than that using low Al-containing iron. The surface of the iron drop was covered with an oxide layer, which mainly consisted of many small particles. With the variation of the substrate gradually from MgO to Al₂O₃, the composition of the oxide layer changed from MgO·Al₂O₃ to CaOAl₂O₃. The formation of the oxide layer prevented the spreading of liquid iron, leading to the increase of the contact angle.     

A PRACTICAL METHOD FOR RECTIFYING INTERFACIAL TENSION DATA TO PREDICT THE SHAPE OF INTERFACES IN AN IMMISCIBLE LIQUID/LIQUID/GAS SYSTEM

The shape of interfaces formed by the contact of two liquid phases, immiscible with each other, and a gaseous phase can be predicted on the condition that the tension to work at each interface is known with a sufficient accuracy. In general, interfacial tension data available are not so accurate, however, as to be useful as they are in predicting the shape of interfaces, particularly when the spreading coefficient of either liquid (liquid 1) on the other (liquid 2) has a negative value of a small magnitude. Presented in this note is a simple method to rectify the interfacial tension data, with the aid of a measurement of the radius of a lens of liquid 1 of a known volume placed on the horizontal surface of liquid 2, and thereby make them usable for predicting interfacial geometries. The method is tested by applying it to benzene/water and n-pentane/water systems.     

A rapid test to measure performance,emission and wear of a diesel engine fueled with palm oil diesel

Results of performance, emission and tribological evaluations of palm oil methyl ester and its blends with conventional diesel in an automobile diesel engine test bed are presented. Polymerization and carbon deposits on the fuel injector were monitored. CO, CO₂, O₂, combustion efficiency and temperature of exhaust gases were also measured. Palm oil methyl ester and its blends have great potential as alternative diesel fuel. Performance and exhaust gas emission for palm oil methyl ester and its blends with conventional diesel are comparable with those of conventional diesel fuel. Palm oil methyl ester does not pose a severe environmental problem and will not deteriorate engine and bearing components.     

SEPARATION AND ENRICHMENT OF WEAK ORGANIC ACIDS OR BASES BY IMMOBILIZED LIQUID MEMBRANES

A new and effective liquid membrane process to achieve both separation and enrichment simultaneously of weak organic acids or bases was developed. The process utilizes effectively the difference in the apparent partition coefficient of the constituent species between the aqueous and organic phases, and uses the change of the apparent partition coefficients with the hydrogen ion concentration of the aqueous phase. For such a fundamental model apparatus as a diaphragm diffusion cell being operated batch wise, the effects of pK value of solutes, permeability of solutes through the membrane, volume ratio of liquids in two aqueous phases, and pH value of aqueous phase on enrichment factor and selectivity for the solute to be concentrated were discussed analytically. Separation and enrichment were demonstrated using aqueous mixed solutions of fumaric acid and L-malic acid. The results were in good agreement with the theoretical predictions.     

铬铁矿液相氧化的热力学分析

液相氧化法生产铬酸盐技术是对传统火法焙烧技术的突破．在600～900K温度范围内对液相氧化法处理铬铁矿的熔盐体系各反应趋势及物相组成的热力学进行了分析研究，对液相氧化法处理铬铁矿各体系的反应自由能变化（△G°R）与温度（T）关系的计算结果表明，铬铁矿中的（Mg,Fe）（CrO2）2在较低温度下与NaOH、O2具有较强的反应趋势，比传统的火法焙烧方法反应温度降低了873K，节约大量能源;铬铁矿中的杂质相在反应温度下进行一系列副反应，生成硅酸盐、铝硅酸盐等新相．     

Side-chain functionalized liquid crystalline polymers and blends, 10: phase behavior and structure of side-chain liquid crystalline ionomers containing ions of d-metals

Novel side-chain liquid crystalline (LC) ionomers containing d-metals Co(II) and Ni(II) were synthesized and characterized. Both families of the ionomers are characterized by the same influence of charged group content in polymer on their phase behavior. The incorporation of 2-3 mol% of metal ions in the nematic polymer matrix leads to the induction of SmA phase and rise in the clearing point. The peculiarity of their phase behavior in comparison with the earlier investigated LC ionomers with alkaline or alkali-earth metals is the full destruction of the mesophase at the concentration of d-metal higher than 12 mol%. This phenomenon was associated with the well-known ability of the transition metal ions to form various complexes that, in the case of LC ionomers, can negatively influence the ordering of the side mesogenic groups. The proposed structure of the LC ionomers is discussed in comparison with the metallomesogenic polymer systems.