具有初曲率板弯曲的边界元分析

由于具有初曲率板弯曲问题的控制微分方程较复杂，直接求解原问题基本解推导边界积分方程较为困难。本文通过引入等效荷载，将此问题的控制微分方程化成与普通板弯曲基本方程形式相同的微分方程，利用一般求解板弯曲问题的边界元法迭代求解，建立了分析具有初曲率板弯曲问题的边界元法。算例表明本方法理论准确、精度良好。     

Prediction of axial velocity profiles and solids hold-up in a rotary kiln

Axial bed depth profiles were experimentally measured in a rotary kiln containing ilmenite particles under steady state and transient conditions. The variables include feed rate of solids, inclination and rotational speed of the kiln. and dam height. The variation of the axial velocity with kiln axis was estimated. The semi-experimental model proposed by Perron and Bui (1990) was modified to include the effect of the variables of the present study. The mean residence time of solids was estimated from the fractional hold-up and expressed in terms of the process variables. The transients induced by a step change in any of the operating conditions were measured as variation of discharge rate of solids with time.     

低速爆轰管对黑火药的点传火性能研究

文章采用中心点火管结构的实验装置研究了黑火药的点传火性能。用低速爆轰 (L VD)中心点火管来点燃黑火药时 ,1# ～ 3# 大粒黑药的传火速度为 70 0 m· s-1～ 80 0 m· s-1数量级 ,燃烧波宽度在 3.1ms～ 3.5 ms,最大压力峰值 :1# 为 36 .4 MPa,2 # 为 2 4 .0 MPa,3# 为 38.0 MPa。用普通中心点火管点燃黑火药时 ,2 # 、3# 和钝化 2 # 大粒黑的传火速度分别为 6 1.2 m· s-1、6 8.2 m·s-1和 4 0 .1m· s-1,最大燃烧波宽度分别为 9.2 ms、6 .3ms和 9.5 ms。燃烧波表明 ,L VD中心传火管与普通中心传火管相比较 ,在传火管的不同位置处 ,前者的 P- t曲线一致性远高于后者。     

利用短周期地脉动推断深层地基S波速度

从二维随机波场的相关理论出发，提出了如何从短周期地脉动（频率＞０．５Ｈｚ）时域信号中计算Ｒａｙｌｅｉｇｈ波弥散曲线，进而反演深层地基剪切波（Ｓ波）速度的理论方法和分析技术，并结合实测信号的分析结果，探讨了该方法的可行性和实用性。     

2006年SEG年会反映的各向异性研究新进展

介绍了2006年SEG年会上所反映的各向异性研究的新进展，主要包括：提高速度分析精度的各向异性速度分析参数正交化方法；影响裂隙储层预测的地震波动力学与运动学特征差异分析；验证现行裂隙硬币理论模型可靠性的不规则裂隙有效弹性参数计算分析；提高计算效率的波场延拓各向异性参数参考值优选Lloyd算法；常见TTI介质不同成像方法试验效果的比较。     

Paste Residence Time in a Spouted Bed Dryer. II: Effect of Spout Operational Conditions

Residence time distributions for an aqueous solution of 10% sodium chloride in a spouted bed dryer of inert particles were determined using the stimulus-response technique. Glass and polyethylene beads with diameters 2.6 and 3.4 mm were used as inert bodies in a cylindrical column of 14.0 cm diameter and 60° conical base. The effects of inert bodies load, air, and paste flow rates on the mean residence times and RTD were determined following 2³ factorial designs. The RTD could be correlated to the perfect mixing cell model with R² varying from 0.8684 to 0.9815. The mean residence times in CSBD varied from 10.8 to 13.9 and 10.7 to 13.3 min for glass and polyethylene beads, respectively. For both inert particles, mean residence times increased with bed height and decreased with paste feed rates. Also, terms of interaction among the factors were significant in some cases, showing a complex behavior of paste residence times. Equations obtained by response surface regression could predict mean residence times on glass and polyethylene beads with deviations lower than ±10%.     

爆炸箔起爆系统初始电阻对爆发电流和飞片速度影响的数值模拟

研究了电爆炸箔起爆系统起爆回路初始电阻对爆发电流和冲击片雷管飞片速度的影响规律，分析了影响电爆炸箔起爆系统体系的因素，为在可靠发火条件下降低起爆系统体积提供设计参考。     

Non-Steady Equilibrium during Pro-Eutectoid Ferrite Formation in Fe-0.2C Alloy

Ｔｈｅｐｒｅｃｉｐｉｔａｔｉｏｎｏｆｐｒｏ ｅｕｔｅｃｔｏｉｄｆｅｒｒｉｔｅｆｒｏｍａｕｓｔｅｎｉｔｅｉｓｃｏｎｔｒｏｌｌｅｄｂｙｄｉｆｆｕｓｉｏｎｉｎＦｅ Ｃａｌｌｏｙｓ .Ｗｉｔｈｔｈｅａｓｓｕｍｐｔｉｏｎｔｈａｔｔｈｅｍｉｇｒａｔｉｎｇｉｎｔｅｒｆａｃｅｉｓａｌｗａｙｓｉｎｌｏｃａｌｅｑｕｉｌｉｂｒｉｕｍ ,ｅａｒｌｙｉｎ 194 9,ＺｅｎｅｒＣ[1] ｅｘｐｌａｉｎｅｄｔｈｅｄｉｆｆｕｓｉｏｎａｌｇｒｏｗｔｈｏｆｐｒｏ ｅｕｔｅｃ ｔｏｉｄｆｅｒｒｉｔｅｂｙｕｓｉｎｇｔｈｅＦｉｃｋ’ｓｌａｗ .Ｓｉｎｃｅ…     

固液相变蓄能的数学模型和自然对流换热系数的实验研究

引入自然对流换热系数 ,将固液蓄能数学模型简化为仅用能量方程加以描述。并通过实验测得相变过程的实际温度场 ,证明了自然对流固液相变换热的影响不可忽略 ,验证了固液相变界面移动速率随自然对流换热系数的增大而增大的定性关系