云南东川泥石流沟与非泥石流沟~(137)Cs示踪法物源研究

运用1 37Cs示踪法调查云南东川小江流域 6条泥石流沟、6条非泥石流沟和主河的泥沙来源。泥沙主要来源于冲沟侵蚀和滑坡崩塌堆积、坡耕地和草地。坡耕地和草地表层土壤1 37Cs平均含量分别为 0 9Bq m2 和1 98Bq m2 ,冲沟沟壁和滑坡崩塌堆积土体1 37Cs。作者通过 3种源地土体1 37Cs含量的比较 ,分析了细粒泥沙(<0 0 1mm)的来源。 6条泥石流沟冲沟侵蚀和重力侵蚀 (滑坡崩塌 )的相对产沙量变化于 90 2 %～ 1 0 0 % ,平均值为 95 1 % ,6条非泥石流沟的相对产沙量变化于 74 5 %～ 83 3% ,平均值为 78 9%。小江主河为 81 4 %。     

Uncertainty of Predictions of Embankment Dam Breach Parameters

Risk assessment studies considering the failure of embankment dams often require the prediction of basic geometric and temporal parameters of a breach, or the estimation of peak breach outflows. Many of the relations most commonly used to make these predictions were developed from statistical analyses of data collected from historic dam failures. The prediction uncertainties of these methods are widely recognized to be very large, but have never been specifically quantified. This paper presents an analysis of the uncertainty of many of these breach parameter and peak flow prediction methods. Application of the methods and the uncertainty analysis are illustrated through a case study of a risk assessment recently performed by the Bureau of Reclamation for a large embankment dam in North Dakota.     

双层堤基的井涌破坏与无害管涌

双层堤基水文地质结构特殊，堤基承压水常具独特的“渗而不流”特征。在“不流”条件下，堤后盖层薄弱处受超高承压水头顶裂破坏，产生的局部冒水孔实属承压自流井，由此形成的管涌实质为井涌。底部进水的承压井流影响范围不大，井涌的破坏范围更小，据此可区分出有害管涌与无害管涌。前者局限于堤脚附近，小范围压渗为首选方案；对后者，既无需专门防治，更不必追求根治。     

安塞低渗油田孔隙结构对渗流特征曲线的影响

渗流曲线的测定是认识油藏流体渗流规律的基础。实验发现安塞油田储集层岩心渗流曲线在低有效净围压下近似表现为两段直线，通过压汞实验和毛管压力曲线数据分析，认为这种特征与储集层孔隙结构有关。在分析渗流特征时应综合考虑孔隙结核特征、流体与孔隙介质的相互作用等因素。     

青海省桥头电厂河子沟灰场拦洪坝粘滞流模型试验分析

本文采用粘滞流模型试验对青海桥头电厂河子沟灰场拦洪坝设计方案进行了论证，分析了多种防渗条件下的渗流场特点，提出了满足工程运作的既经济又合理的建议。     

FLOW OF NEWTONIAN FLUIDS THROUGH SINUSOID ALLY CONSTRICTED TUBES. NUMERICAL AND EXPERIMENTAL RESULTS

Numerical and experimental predictions of pressure drops in the flow of Newtonian fluids through sinusoidally constricted tubes (SCT) are carried out. The numerical evaluations analyzed in this work are obtained from the following methods: Geometric Iteration (GJM), Geometric Iteration with First and Second Upwinds (GIM1, GIM2), Successive Over Relaxation by Line (SORBLM), Global Galerkin Spectral Method (GGSM), Collocation (CM) and Dufort-Frankel (DFM). The GIM1, GIM2 and SORBLM are applied to SCT and explained in this work. The other methods have been previously reported in the literature with the same purpose. Experiments are accomplished for constrictions of approximately 40,60 and 80% of the average tube diameter and results compare well with numerical predictions of the steady flow. It is concluded that special attention should be given to evaluations of the friction factor ƒ for Reynolds numbers Re between the onsets of flow separation and turbulence due to flow instability. Finally, the SCT as a model for porous media (PM) is discussed.     

含杂质流体的流量测量

结合工程实例.介绍了几种实用的含杂质流体的流量测量方案,供自动化仪表设计及维堆护人员参考。     

考虑弯道环流影响的平面二维水流泥沙数学模型

弯道环流是影响断面流速和含沙量分布的重要因素。本文提出了通过求解立面二维弯道环流运动的方法,在平面二维水流泥沙数学模型中考虑弯道环流的作用。该方法适用范围广,增加计算工作量不太大。     

破碎流程设计与计算应用程序

利用DELPHI 6.0开发应用功能模块 ,形成破碎流程辅助设计系统 ,可以完成破碎流程及设备的选择计算 ,绘出破碎数质量流程图 ,特点是输入原始数据简单 ,计算速度快。