Electrochemical behaviour of heat-treated AlZnMg alloys in chloride solutions containing sulphate

The electrochemical corrosion and passivation of Al5Zn1.7Mg0.23Cu0.053Nb alloys, submitted to different heat treatments (cold-rolled, annealed, quenched and aged, and quenched in two steps and aged), in sulphate-containing chloride solutions, has been studied by means of cyclic polarization, electrochemical impedance spectroscopy (EIS), scanning electron microscopy (SEM), energy-dispersive X-ray (EDX), and X-ray photoelectron spectroscopy (XPS). The cyclic polarization curves showed that sulphate addition to the chloride solution produced a poor reproducible shift of the breakdown potential to more positive potentials. The repassivation potentials, much more reproducible, and practically separating the passive from the pitting potential region, were slightly displaced in the negative direction with that addition. When the alloys were potentiodynamically polarized in the passive potential region, sulphate was incorporated in the oxide film, thus precluding chloride ingress. In addition, Zn depletion was favoured, whereas Mg losses were avoided. Different equivalent circuits corresponding to different alloys and potentials in the passive and pitting regions were employed to account for the electrochemical processes taking place in each condition. This work shows that sulphate makes these alloys more sensitive to corrosion, increasing the fracture properties of the surface layer and favouring the pitting attack over greater areas than chloride alone.     

Solubility of Si3N4 in Liquid SiO2

The nitrogen solubility in the SiO₂-rich liquid in the metastable binary SiO₂-Si₃N₄ system has been determined by analytical TEM to be 1%–4% of N/(O + N) at 1973–2223 K. Analysis of the near edge structure of the electron energy loss peak indicates that nitrogen is incorporated into the silicate network rather than being present as molecular N₂. A regular solution model with a positive enthalpy of mixing for the liquid was used to match the data for the metastable solubility of N in the presence of crystalline Si₃N₄ and to adjust the computed phase diagram. The solubility of Si₃N₄ in fused SiO₂ is far less than reported in liquid silicates also containing Al, Mg, and/or Y. Apparently, these cations act as modifiers that break anion bridges in the silicate network and, thereby, allow further incorporation of Si₃N₄ without prohibitive amounts of network cross-linking. Finally, indications emerged regarding the diffuse nature of the Si₃N₄-SiO₂ interface that leads to amorphous regions of higher N content.     

Low-Temperature Synthesis of Calcium Hexa-Aluminate

Calcium hexa-aluminate (CaO·6Al₂O₃) has been prepared from calcium nitrate and aluminum sulfate solutions in the temperature range of 1000°–1400°C. A 0.3 mol/L solution of aluminum sulfate was prepared, and calcium nitrate was dissolved in it in a ratio that produced 6 mol of Al₂(SO₄)₃·16H₂O for each mole of Ca(NO₃)₂·4H₂O. It was dried over a hot magnetic stirrer at ∼70°C and fired at 1000°–1400°C for 30–360 min. The phases formed were determined by XRD. It was observed that CaO·Al₂O₃ and CaO·2Al₂O₃ were also formed as reaction intermediates in the reaction mix of CaO·6Al₂O₃. The kinetics of the formation of CaO·6Al₂O₃ have been studied using the phase-boundary-controlled equation 1 − (1 − x )^1/3= K log t and the Arrhenius plot. The activation energy for the low-temperature synthesis of CaO·6Al₂O₃ was 40 kJ/mol.     

Synthesis of Compositionally Homogeneous Sr(CuxZn1−x)1/2W1/2O3

A complex perovskite of Sr(Cu _x Zn_{1- x} )_1/2 W_1/2O₃ (SCZW) is synthesized by a new combination of wet and dry processess. Mixed oxides containing Cu²⁺ and Zn²⁺ (CZ) are prepared by the wet process (coprecipitate method). SCZW is obtained by the dry process (mixed-oxide method) from a mixture of CZ, SrCO₃, and WO₃. SCZW has practically no compositional, unlike solid solutions prepared by the conventional dry method. The wet–dry process method is useful because the wet process is applied to only B-site cations having the same valence.     

Microstructure and Mechanical Properties of Hot-Pressed Silicon Carbide-Aluminum Nitride Compositions

A flexural strength of up to 1 GPa was achieved in SiC-AIN materials and is attributed to a dense, equiaxial grain structure of the 2H(δ) SiC-AIN solid solution, with a relatively uniform grain size of ∼ 1 μm. The strength was found to decrease with increasing grain size. While the β→α phase transformation and the formation of various metastable polytypes make microstructural control difficult in SiC materials, excellent control is facilitated in SiC-AIN materials as a result of the stable 2H solid solution. Several mechanisms of grain refinement during the β→ 2H transition were observed, most notably the direct formation of several 2H grains from a single β grain. In addition, grain growth is limited by the diffusion-controlled nature of the transition. These mechanisms could be utilized to achieve even higher strength values, with potentially higher reliability of the materials in structural applications.     

Activity–Composition Relations in NiAl2O4─MnAl2O4 Solid Solutions and Stabilities of NiAl2O4 and MnAl2O4 at 1300° and 1400°C

Activities of NiO were measured in the oxide and spinel solutions of the system MnO–NiO–Al₂O₃ at 1300° and 1400° C with the aim of deriving information on the thermodynamic properties of the spinel phases. Synthetic samples in selected phase assemblages of the system were equilibrated with metallic nickel and a gas phase of known oxygen partial pressures at a total pressure of 1 atm. The data on NiO activities and directions of conjugation lines between coexisting oxide and spinel phases were used to establish the activity–composition relations in spinel solid solutions at 1300° and 1400°C. The MnAl₂O₄–NiAl₂O₄ solid solutions exhibit considerable negative deviations from ideality at these temperatures. The free energy of formation of MnAl₂O₄ from its oxide components (MnO + Al₂O₃) at 1300° and 1400°C is calculated to be −24.97 and −26.56 kJ. mol⁻¹, respectively. The activities determined in the stoichiometric spinel solid solutions are more negative as compared with those predicted from cation distribution models.     

Equilibrium Studies of the System'(Fe,Co)O'–(Fe,Co)3O4 by Solid-State emf Measurements in the Temperature Range 970 to 1370 K

The equilibrium reaction 3'(Fe, Co)O'( ss ) +1/2O₂ ( g ) ⇄ (Fe, Co)₃O₄( ss ) was studied in the temperature range 970 to 1370 K for seven different total compositions of molar ratios 0.5 < Fe/(Fe + Co) ≤ 1.0. The equilibrium pressures of oxygen were determined by using galvanic cells incorporating calcia stabilized zirconia as solid electrolyte and the Fe/Co ratios in the solid-solution phases by wavelength dispersive spectrometry microprobe analyses. The activities of 'FeO' in the cobaltowüstite phase were then derived from the experimental results obtained.     

Application of an Ion-Packing Model Based on Defect Clusters to Zirconia Solid Solutions: I, Modeling and Local Structure of Solid Solutions

Oxygen vacancies can be introduced into zirconia solid solution ZrO₂–MO _u ( u = 1 and 1.5) to maintain electroneutrality. Recently, the local structures around Zr⁴⁺ and M^{2 u +} ions in ZrO₂–MO _u solid solutions have been studied through EXAFS spectroscopy, diffuse scattering analysis, and single-crystal structure analysis. The present study constructs an ion-packing model for zirconia solid solutions based on some defect cluster models. The decrease of cell volume with the occurrence of vacancies is assumed to be expressed by decreasing the coordination number (CN) of cations around the vacancy. The distribution of CNs in a solid solution was calculated from a certain defect cluster model. The average interatomic distances, the average CN, and the short-range order parameters were calculated using this distribution of CNs. The local structures calculated from the model were compared with experimental data in the systems ZrO₂–MO_1.5 (M = Y, Gd, Yb, and Ca). In the ZrO₂–YO_1.5 system, the r (s–O) interatomic distance, where s represents Zr⁴⁺ or Y³⁺ and O represents O²⁻, decreased with Y content and therefore vacancy content. The probability of finding Y³⁺ around a vacancy increases with increasing yttria content from a comparison of the calculated results with the ones from recent EXAFS studies. The present model can qualitatively explain compositional and size dependences of the dopant on various local structures.     

第一类Dirichlet积分的公式解

利用三角降次公式及留数解决了第一类Dirichlet积分问题,即给出了第一类Dirichlet积分的公式解。利用所得结果,定义了Dirichlet数Dn,证明了其一般性质。     

Investigation of transport phenomena in a hybrid ion exchange-electrodialysis system for the removal of copper ions

Hybrid ion exchange electrodialysis processes allow the removal of metal ions from dilute waste liquids and the recovery of more concentrated solutions. The work reported here was aimed at investigating the two steps in the treatment process, namely, adsorption of metal ions onto the packed bed of resin and electromigration (i.e., the transport of these ions in the complex system under the applied electrical field). The case of copper sulfate was investigated. Dowex resins with a cross-linking degree of 2 and 8% were used. The flux of copper through the resin bed and the current efficiency for ion transfer to the cathode compartment were determined as a function of potential gradient and copper ionic fraction in the bed. Apparent diffusion coefficients of Cu²⁺ in the overall system were deduced from the experimental data.