多粒度全光网中的多层联合路由

多粒度交换技术利用波带级路由以及光纤级路由,可有效降低光交叉连接器的复杂度.但多粒度交换增加了光网络的逻辑层次结构,使得网络中的路由与资源分配问题更为复杂,因此,在多粒度全光网中实现多层联合路由是提高网络性能的关键.本文对多粒度交叉连接结构进行了分析,并对多粒度全光网中的多层联合路由问题进行了研究.     

光突发交换中的冲突解决协议

文章介绍了适合于在当前技术条件下的新交换技术-光突发交换，并对光突发交换中的各种冲突解决协议进行了阐述和对比．     

未来航空润滑油基础油

介绍了未来航空涡轮发动机对润滑油性能的要求:在260,-54℃时,试样运动黏度分别大于1.0 mm2/s和小于15 000 mm2/s,热氧化安定性温度为260~427℃。该要求已超出了目前使用的酯类润滑油所能承受的最大极限。为了满足要求,需开发全氟聚醚、改性硅油、聚苯醚、C-型醚、氟醚三嗪及环三磷偶氮润滑油基础油,它们的使用温度依次为:-34~316,-60~260,5~288,-29~260,-30~343,-15~343℃。     

辽河催化裂化澄清油中间馏分热反应研究

采用先加入絮凝剂脱灰，再经减压蒸馏切割420～500℃馏分的方法，将辽河催化裂化澄清油预处理，考察了澄清油、加入絮凝剂脱灰后的澄清油以及脱灰后再减压蒸馏所得的中间馏分这3种原料在热转化过程中中间相的转化历程，并采用偏光显微镜观察热转化产物。结果表明，澄清油预处理效果明显，所得中间馏分具有较低的H／C原子比（nH／nC）和适宜的组成分布，是生产针状焦的理想原料。热转化产物的光学组织结构属于各向异性发达的广域-流线型结构。     

乙烯装置失效模式分析及基于风险的检验

简述了乙烯装置的工艺流程,分析了装置中常见的几种失效模式及其分布;以乙烯裂解装置为例,简述了RBI的执行过程和结果,从基于风险的检验理念,对制订设备检验策略提出了几点建议。     

A Novel Segmentation and Feedback Model for Resolving Contention in Optical Burst Switching

A novel segmentation and feedback model (SFM) applied to resolve contention is proposed. Simulation and performance analyses show that the SFM effectively avoids contentions in optical burst switching (OBS). The long delay time of deflection routing and the immature technology of wavelength converters and optical buffers are not deployed in the SFM. The SFM does not only realize fast switching but also allows preemption by higher priority bursts.     

A novel optical burst switching scheme—logical cascaded private subnet with start wavelength assignment policy

Many recent studies have convincingly demonstrated that network traffic exhibits a noticeable self-similar nature, which has a considerable impact on network performance, and most studies of optical burst switching (OBS) networks are under a fundamental assumption that full wavelength conversion is available throughout the network. In practice, however, economic and technical considerations are likely to dictate a more limited and sparse deployment of wavelength converters in the optical network. Therefore, we present a novel scheme for OBS networks, called logical cascaded private subnet (LCPN) with start wavelength assignment policy. We define the concept of canoe relative to cluster in self-similar traffic, and introduce a new device named payload segregator at the edge node as a gateway to the core node in OBS Networks. According to the changes in the edge node framework, we put forward the concept of cluster private subnet and canoe private subnet in the core node correspondingly. A new start wavelength assignment policy is proposed for the absence of (full) wavelength conversion capabilities in the core node of OBS Networks. The performance study indicates that, our new scheme is robust under self-similar traffic and wavelength continuity constraint.     

质子交换铌酸锂波导MMI光功分器

利用三维非旁轴近似光束传输法对退火质子交换铌酸锂渐变折射率分布波导中的自镜像效应进行分析与模拟 .在此基础上 ,利用退火质子交换技术在 X切 Y传铌酸锂衬底上进一步制作了 1× 8MMI光功分器 .测试表明器件实现了 1路分成 8路的光功分功能 .     

PVR机顶盒文件存储系统的设计与实现

简要介绍了具有PVR功能的机顶盒，具体描述了PVR存储系统硬件与软件的设计与实现，重点讨论了PVR的关键部分——文件存储系统的设计和实现。     

First Harmonic (2f) Characterisation of Resonant Frequency and Q-Factor of Micromechanical Transducers

In this paper, the response to the first harmonic component (2f) of the electrostatic force in single terminal driven electrostatic comb-drive and parallel-plate drive was used as a signal to extract device parameters, namely, the Q-factor and resonant frequency instead of the fundamental (1f) resonance response. It is shown that the difficulty in motional measurement due to electrical cross-talk (parasitics) using 1f measurement can be overcome with a higher signal-to-noise ratio of the 2f signal. Both atmospheric (low-Q) and reduced pressure environment were investigated using off-chip electronics and lock-in amplifier. The measurements were done on the electrostatic comb-drive and capacitive parallel plate sensing plates that form the two core modules of a yaw rate sensor (dual-axis resonator). The effects of AC and DC bias voltages on the measured response have been investigated. Experimental amplitude and phase response data have been analysed using the Lorentzian curve-fit, Resonance Curve Area (RCA) method, the half-power bandwidth method (3 dB) and the Nyquist plot for data fitting and determination of the Q-factor and resonance frequency.