多站远程无线控制信号系统通信软件的开发

多站远程无线控制系统是以计算机为中心控制 ,用多个信号源作为下位机通过无线模块进行通信 ,文中介绍了通过无线数传模块实现无线通讯以及ActiveX控件的使用方法 ,提出了使系统应用程序更安全可靠 ,效率更高 ,维护更加方便的几种措施。     

Delay‐dependent stability for Markovian genetic regulatory networks with time‐varying delays

This paper is concerned with the problem of stochastic stability analysis for a class of genetic regulatory networks with Markovian jump parameters and time‐varying delays. A delay‐dependent stability criterion is derived by using a novel mode‐dependent Lyapunov functional. The derived stability criterion is expressed in terms of linear matrix inequalities and is less conservative than the existing ones in the literature. A numerical example is provided to demonstrate the effectiveness of the proposed stability criterion. Copyright © 2011 John Wiley and Sons Asia Pte Ltd and Chinese Automatic Control Society     

网络控制系统优化设计研究

研究网络控制系统的优化问题,提高系统的实时性。针对传统的网络控制系统是闭环系统,网络带宽有限,网络传输中的时间延迟、数据包丢失等问题不可避免。当发生以上情况时,反馈信号不能及时传回,造成控制信号发出延迟,影响了系统的实时性。为了解决上述问题,提出了一种非规律时滞补偿算法,把时滞信号引入自由权矩阵,能够得到延迟信号相关稳定性条件,并充分运用线性信号特征矩阵保证网络控制系统的性能,保证系统在线控制的实时性。证明改进方法能够避免控制信号延迟造成的滞后问题,提高了网络控制系统的实时性。     

基于流媒体技术的网络视频监控研究

使用流媒体技术构建网络视频监控系统具有成本低廉,稳定可靠,不受防火墙限制等诸多优点,全面地介绍了基于流媒体的监控系统构成和开发方法,并重点分析了系统的延迟问题。     

NiTi形状记忆合金的相变温度滞后

用透射电镜、正电子湮没和电阻测量,研究了NiTi形状记忆合金的组织结构与相变滞后的关系结果表明,经不同制度时效处理的组织,其相变温度滞后大小的顺序是:片状马氏体>R相>束状马氏体。Ti_(11)Ni_(14)相质点周围的共格应力场对这些相的可逆转变起障碍作用。正电子湮没Doppler展宽能谱S参数值与试样的温度滞后值之间存在线性关系,从而确认Ti_(11)Ni_(14)相析出的错配位错密度及由此而建立的晶体中弹性应力场分布是决定NiTi合金相变温度滞后的主要因素。     

Creep-induced local lattice parameter changes in a monocrystalline nickel-base superalloy

The γ-γ lattice mismatch of specimens of the monocrystalline nickel-base superalloy SRR 99 has been measured by a high-resolution X-ray diffraction technique for the undeformed state and after high-tem-perature creep deformation. During creep deformation beyond the minimum creep rate (total strain =0.5%), the lattice mismatches, measured in and perpendicular to the [001] stress axis, respectively, un-dergo changes in opposite directions. This reflects the buildup of a complex deformation-induced triaxial state of internal stress in the phases y and γ. The overall resolved shear stresses that act in γ and y due to the combined action of the external and internal stresses are estimated, and the conditions under which cutting of the γ phase by dislocations should occur are discussed.     

Observability of linear systems with commensurate delays and unknown inputs

This paper investigates the observability analysis for linear time systems whose outputs are affected by unknown inputs. Three different definitions of observability are proposed. By introducing the Smith form and comparing the invariant factors, a sufficient condition is deduced for each proposed observability definition. Three examples are given for the purpose of highlighting the effectiveness of the proposed approach.     

Effect of MgO Addition on the Bondability and Interfacial Reaction between Dielectric and Glass-Ceramics for the Fabrication of Multi-Component Ceramic Substrates

Bondability and interfacial reaction between dielectric and insulator layers have been examined to obtain a basic understanding of bonding mechanisms. Lead-containing complex perovskite was used as a dielectric material. Two kinds of glass-ceramics were used as insulator material; lead borosilicate glass containing Al_2O3 (insulator A) and the same containing Al₂O₃ and M_gO (insulator B). Dielectric and insulator layers did not bond when insulator A was used. When insulator B was used, however, strong bonding was achieved between the two layers by firing the powder compacts at temperatures between 800° and 1000°C. Addition of M_gO to lead borosilicate glass increased the thermal expansion coefficient to that of the dielectric and enhanced the formation of reaction layers, resulting in good bonding. Two reaction layers were identified. The main reaction products were enstatite and bredigite for one layer contacting the dielectric, and enstatite and a compound with the same diffraction pattern as that of faujasite for the other layers contacting insulator B.     

CMOS图像传感器中分段电容DAC非理想因素研究

CMOS图像传感器信号处理中通常采用分段电容DAC产生斜坡参考电压。研究了分段电容DAC精确的电容失配及寄生与其转换精度的关系式。基于对分段电容DAC工作原理的研究,导出了电容失配及寄生模型;针对其分数桥接电容失配、各二进制电容间的失配及寄生电容问题进行了理论分析;对分段电容DAC进行非理想因素仿真,设计了一个采用分段电容DAC的10位单斜ADC并对其进行测试,仿真和测试结果均验证了理论分析的正确性。上述理论分析结果可作为分段电容DAC的设计指导。