掺锰BaTiO3 PTCR陶瓷的电子顺磁共振研究

利用电子顺磁共振（EPR）方法对Mn掺杂的BaTiO3 PTCR陶瓷在120－450K的温度范围内进行了研究，研究结果表明：高自旋Mn^2 离子的6重谱线非常明显，表征谱线位置的g因子为2．009 9,Mn^2 离子信号弱弱与BaTiO3晶体结构密切相关，Mn^2 离子信号的温度分布呈U型，即在三方相和立方相时，信号强度较强，而在四方相和斜方相时信号很弱，这是因为在四方相和斜方相中，由于BaTiO3晶体结构的扭曲和畸变，导致Mn^2 和Vo空位缔合生成Mn^2 -Vo复合缺陷，未成对电子的消失以及复合缺陷n^2 -Vo的生成最Mn^2 在四方相和斜方相（200－380K）消失的主因，实验中没有发现Mn^3 和Mn^4 的信号，而与实验的环境条件一致，掺Mn后样品Curie点的漂移可能是Mn进入晶格的一个判据，此外，由于试样的n(Ba)/n(Ti)=1，因而没有发现钡空位VBa及其它的复合缺陷（如：VBa-Mn^2 ,Mn^3 -Vo,La^3 -Mn^3 等），Mn^2 离子等电子陷阱的生长是Curie温度处电阻骤然增加的主要原因。     

Cement-based materials for stress sensing by dielectric measurement

The self-sensing of stress by measurement of the relative dielectric constant (κ) has been shown in cement pastes containing steel fibers of 8 μm diameter and carbon filaments of 0.1 μm diameter. The κ value increases nonlinearly and quite reversibly with compressive stress up to 6.4 MPa, although the reversibility is not complete. Inferior sensing performance was observed in cement paste with carbon fibers of 15 μm diameter, although the performance was still better than cement paste without admixture.     

Ohmic contacts to semiconducting diamond using a Ti/Pt/Au trilayer metallization scheme

Ohmic contacts have been fabricated on a naturally occurring type IIb diamond crystal using an annealed Ti/Pt/Au trilayer metallization where the Pt served successfully as a barrier to Ti diffusion into the Au capping layer. However, a specific contact resistance could not be reliably determined using transmission line model measurements. Auger microanalysis revealed the presence of Ti on the diamond surface near the ohmic contact pads. The most likely origin of the Ti on the diamond surface was determined to be lateral diffusion from beneath the contact pads. This would have produced a nonuniform concentration of Ti across the diamond surface which, in turn, would have affected the diamond sheet resistance in a complicated way.     

Experimental Evaluation of the Acceptor-States Compensation in Positive-Temperature-Coefficient-Type Barium Titanate

Experimental evidence shows that the acceptor-state levels in Sb-doped positive-temperature-coefficient-type BaTiO₃ are compensated up to a critical acceptor-state density. Using the slope of the natural logarithm of the resistivity with respect to 1/ T , instead of maximum resistivity as a measure for the acceptor-state density, it is possible to estimate this critical value. The value obtained (4.2 × 10¹⁷ m⁻²) is believed to be the first reported estimate based on experimental data. It is in good agreement with the estimate of 6 × 10¹⁷ m⁻² (first reported by Jonker) obtained from the spontaneous polarization of BaTiO₃. This shows that the ferroelectric behavior of BaTiO₃ is indeed a feasible explanation for the low resistivity below the Curie point, as proposed by Jonker.     

利用神木不粘性块煤炼制炭质还原剂

本文介绍利用神木不粘结性块煤炼制优质铁合金专用焦，通过对块焦的筛分组成分析、工业分析和灰分分析，焦炭的反应性能、比电阻、强度、石墨化程度研究，证明该煤炼制的块焦具有比电阻高，灰分、硫、磷、铝和高温下石墨化程度低的优点。该焦可代替冶金焦冶炼铁合金。     

Rheological and electrical properties of polycarbonate/multi-walled carbon nanotube composites

Rheological and electrical properties of the polycarbonate (PC)/multi-walled carbon nanotube (MWNT) were studied. The MWNT was funtoinalized by treating with the hydrogen peroxide (H₂O₂). The H₂O₂ treated MWNT was dried by thermal and freeze drying methods. From the morphological studies, the degree of entanglement of the MWNT was decreased after treating with the H₂O₂. For the H₂O₂ treated MWNT (thermal drying), the length of the MWNT was shortened compared that of the H₂O₂ treated MWNT (freeze drying). The rheological and electrical properties of the PC/MWNT (H₂O₂ treated) composites increased compared that of the PC/MWNT (untreated) composites. Also, the electrical conductivity showed higher value for the PC/MWNT (H₂O₂ treated, freeze drying) composites compared that of the PC/MWNT (H₂O₂ treated, thermal drying) composites. From the results of the morphological, rheological, and electrical properties of the PC/MWNT composites, it is suggested that the electrical and rheological properties of the PC/MWNT composites are affected by the MWNT-MWNT network structure, which is related with the MWNT morphologies such as the degree of aggregation and aspect ratio of the MWNT.     

Electrical properties of V2O5–WO3/TiO2 EUROCAT catalysts evidence for redox process in selective catalytic reduction (SCR) deNOx reaction

Electrical conductivity measurements on EUROCAT V₂O₅–WO₃/TiO₂ catalyst and on its precursor without vanadia were performed at 300°C under pure oxygen to characterize the samples, under NO and under NH₃ to determine the mode of reactivity of these reactants and under two reaction mixtures ((i) 2000 ppm NO + 2000 ppm NH₃ without O₂, and (ii) 2000 ppm NO + 2000 ppm NH₃ + 500 ppm O₂) to put in evidence redox processes in SCR deNO_x reaction.It was first demonstrated that titania support contains certain amounts of dissolved W⁶⁺ and V⁵⁺ ions, whose dissolution in the lattice of titania creates an n-type doping effect. Electrical conductivity revealed that the so-called reference pure titania monolith was highly doped by heterovalent cations whose valency was higher than +4. Subsequent chemical analyses revealed that so-called pure titania reference catalyst was actually the WO₃/TiO₂ precursor of V₂O₅–WO₃/TiO₂ EUROCAT catalyst. It contained an average amount of 0.37 at.% W⁶⁺dissolved in titania, i.e. 1.07 × 10²⁰ W⁶⁺ cations dissolved/cm³ of titania. For the fresh catalyst, the mean amounts of W⁶⁺ and V⁵⁺ ions dissolved in titania were found to be equal to 1.07 × 10²⁰ and 4.47 × 10²⁰ cm⁻³, respectively. For the used catalyst, the mean amounts of W⁶⁺ and V⁵⁺ ions dissolved were found to be equal to 1.07 × 10²⁰ and 7.42 × 10²⁰ cm⁻³, respectively. Since fresh and used catalysts have similar compositions and similar catalytic behaviours, the only manifestation of ageing was a supplementary progressive dissolution of 2.9 × 10²⁰ additional V⁵⁺ cations in titania.After a prompt removal of oxygen, it appeared that NO alone has an electron acceptor character, linked to its possible ionosorption as NO⁻ and to the filling of anionic vacancies, mostly present on vanadia. Ammonia had a strong reducing behaviour with the formation of singly ionized vacancies. A subsequent introduction of NO indicated a donor character of this molecule, in opposition to its first adsorption. This was ascribed to its reaction with previously adsorbed ammonia strongly bound to acidic sites. Under NO + NH₃ reaction mixture in the absence of oxygen, the increase of electrical conductivity was ascribed to the formation of anionic vacancies, mainly on vanadia, created by dehydroxylation and dehydration of the surface. These anionic vacancies were initially subsequently filled by the oxygen atom of NO. N^o atoms, resulting from the dissociation of NO and from ammonia dehydrogenation, recombined into dinitrogen molecules. The reaction corresponded to

Full-size image

. In the presence of oxygen, NO did not exhibit anymore its electron acceptor character, since the filling of anionic vacancies was performed by oxygen from the gas phase. NO reacted directly with ammonia strongly bound on acidic sites. A tentative redox mechanism was proposed for both cases.     

Degradation of 4-chloro-2-methylphenol in aqueous solution by electro-Fenton and photoelectro-Fenton processes

Degradation of 4-chloro-2-methylphenol (PCOC), a refractory toxic chemical emitted to the environment from the industrial production of phenoxy herbicides was studied in aqueous solution. Electro-Fenton and photoelectro-Fenton processes were used as the degradation methods. H₂O₂, produced by the reduction of oxygen at carbon cathode reacted with dissolved metal ions to form hydroxyl radicals, which in turn reacted with PCOC sequentially to degrade the aromatic ring. The effects of using different [Fe²⁺]/[PCOC]₀ and the effect of replacing Fe²⁺ by Mn²⁺ ion have been examined. It was found that degradation rate was increased with increasing [Fe²⁺]/[PCOC]₀ ratio from 2 to 4. However, the total charge utilized during the treatment was also increased. The efficiency of PCOC degradation was observed to be higher when Mn²⁺ was used as the catalyst. The mineralization of aqueous solutions of PCOC, withdrawn from the reactor at certain time interval, has been followed by total organic carbon (TOC) decay and dechlorination. A fast and complete degradation of the aromatic ring was achieved in photoelectro-Fenton system. 41.7% TOC decay and complete dechlorination were observed by consuming only 141.4 C electrical charge during a 300 min photoelectron-Fenton treatment. In the case of electro-Fenton system, 280.7 C electrical charge was consumed during 450 min of electrolysis to attain a similar degradation of PCOC. 14.9% TOC removal and 89.3% dechlorination have been obtained in this system under the applied conditions.     

四维瞬变电磁法油藏监测正演模拟

本文采用基于张量格林函数的体积分方程法进行四维模型瞬变电磁响应的正演研究,文章中首先说明了四维瞬变电磁法模拟的可行性及程序实现,然后分别设计了两个三维异常体模型(水藏、油藏),采用两种观测方式(激发与接收平行、激发与接收垂直)进行正演模拟计算,并对所得的二次总场的数据进行了分析。