一种复合制导导弹的导航滤波器设计

研究了一种中制导段采用雷达修正的遥控制导方式和末制导段采用捷联式自寻的导引头的自导引制导方式的捷联式复合制导的中远程战术导弹的导航滤波问题，考虑到目标的大机动性和模型的非线性，基于最佳估计理论中的广义卡尔曼滤波理论，建立了通用导航滤波方程，仿真计算与仿真结果表明所做设计是合理和有效的。     

声表面波滤波器的匹配电路设计

介绍了通过测试仪器采集的声表面波（SAW）滤波器的Sij(i,j=1,2）参数来优化匹配电路的方法。首先将采集的Sij(i,j=1,2）参数转换为SAW滤波器Yij(i,j=1,2）参数，然后建立新的S12（或S21）参数与匹配电路的依赖关系，通过优化匹配电路元件值，而使滤波器的插入损耗和通带波动满足目标值，该方法的主要优点是考虑整个通带特性，而不是考虑通带内的某一点（如中心频率）。     

合成孔径雷达干扰技术的研究

合成孔径雷达（Synthetic Aperture Radar）是一种新型高辨力成像雷达。其在距离上利用发射的线性调频（LFM）的脉冲压缩信号来获取距离上的高分辨力，在方位上利用接收脉冲之间的多普勒信息获得方位上的高分辨力。本文在简单分析合成孔径雷达工作原理基础上，针对合成孔径雷达的特点与弱点，讨论了几种干扰样式。     

一种遗传-梯度混合算法

本文提出一种函数全局优化的遗传-梯度混合算法。该算法由选择、交叉和诱导变异算子组成。通过对自适应滤波和前向神经网络权值训练两个典型问题的数字仿真，表明该算法是一种快速有效的全局优化算法。     

使用光纤放大器的频分复用光纤传输系统

报道了一个使用光纤放大器的两路非相干频分复用光纤传输实验系统。系统采用国产ＤＦＢ激光器作光源，用意大利生产的光纤放大器作在线放大器，用自制的光学谐振腔作光学滤波器和解复用器，采用ＦＳＫ调制制式，将１４０Ｍｂ／ｓ非归零伪随机码传输了５０公里，得到了很好的眼图。在频道间距为１０ＧＨｚ情况下，未观测到邻道干扰和光纤放大器的非线性现象。     

A NEW ALGORITHM FOR ADAPTIVE LATTICE FILTERAND ITS APPLICATION IN THE SPEECH LINEARPREDICTIVE SYNTHESIS

In this paper, an adaptive line spectral pair filter is derived from an adaptive lattice filter. A least-mean-square(LMS) type adaptive algorithm used to calculate directly the line spectral pair(LSP) coefficients on a stage-by-stage basis is presented. Experimental results show that the algorithm has higher convergence rate and lower misadjustment as compared with the other algorithms. The LSP coefficients calculated by the algorithm have been used to carry out speech linear predictive synthesis, resulting in better results than PARCOR coefficients.     

高阻带抑制有源声表面波滤波组件

介绍有源声表面波滤波组件的设计思路。报道最新研制的高性能滤波组件，其中心频率４０ＭＨｚ，３ｄＢ相对带宽０．８％，阻带抑制优于１００ｄＢ，矩形系数（Δｆ１００ｄＢ／Δｆ３ｄＢ）小于３，输入输出端口电压驻波比接近１。组件体积８５ｍｍ×３５ｍｍ×２４ｍｍ，重量小于１１５ｇ     

声表面波传感器电路参数的CAD方法

本文提出了声表面波传感器电路参数的一种ＣＡＤ方法，即有约束内点惩罚函数－鲍威尔－阻尼最小二乘法，并对两个实例进行了计算。     

Direct preparation of particles from liquid suspension for ESEM or SEM analysis

A simplified method for the preparation of particles from liquid suspensions has been developed. Particles are deposited directly on carbon planchets for rapid analysis by environmental scanning electron microscopy or by conventional scanning electron microscopy after an additional drying step. This is accomplished by filtering the liquid through thin carbon planchets. Three different grades of graphite were investigated for their suitability as the source material for these planchets. The high quality isomolded graphite is recommended for the filtration and direct observation of particles by electron microscopy. This technique is demonstrated for particles in hydraulic fluid and aquatic suspended particulate material from a natural water source.     

An attempt to compare the performance of bioscrubbers and biotrickling filters for degradation of ethyl acetate in gas streams

This study presents a comparison of the efficiency of a bioscrubber and a biotrickling filter (BTF) for the removal of ethyl acetate (EA) vapour from a waste gas stream, under the same operating conditions. The maximum EA elimination capacity achieved in the bioscrubber was 550 g m^?3 h^?1 with removal efficiency higher than 96%. For higher EA loadings the bioscrubber was oxygen limited, which caused incomplete EA biodegradation. When pure oxygen was fed to the bioscrubber at a rate of 0.02 L min^?1, the bioscrubber recovered and could treat higher EA loadings without any oxygen limitation. The BTF achieved EA elimination capacity of 600 g m^?3 h^?1 with removal efficiency higher than 97% and the dissolved oxygen concentration remained substantially higher than in the bioscrubber. However, severe channelling and blockage of the spray nozzle occurred due to the excessive biomass growth. Overall, the bioscrubber system was easier to operate and control than the BTF, while an enhancement of the oxygen mass transfer in the bioscrubber could potentially increase its performance by up to three times. Copyright © 2005 Society of Chemical Industry