基于颜色和边缘特征的均值迁移目标跟踪算法

综合颜色特征对旋转、变形不敏感和边缘特征对光照、颜色不敏感的优点,提出了一种基于颜色和边缘特征的均值迁移目标跟踪算法,提高了跟踪算法的鲁棒性。利用加权求和的方法获得联合特征的Bhattacharyya系数,以此作为衡量目标模型与候选目标相似程度的依据。实验结果表明,在光照变化时,本文算法的跟踪误差大约是基于颜色特征的均...     

最小均方误差检测器对扩频系统中窄带干扰的抑制性能分析

本文首先说明当码元间隔内的码片数目与扩频序列周期相等时,直接序列扩频(DSSS)系统中最小均方误差(MMSE)意义下的最优滤波器也是最小误码率意义下的最优滤波器,因而能很好地抑制大多数干扰样式。本文具体分析了最小均方误差检测器对音频干扰以及自回归干扰的抑制性能,给出了详细的推导过程以及结论。     

UML技术在医院检验信息管理系统设计中的应用

目的:针对医院对检验信息管理系统的开发质量要求,研制解决方案,避免后期投入成本巨大浪费问题,实现因地制宜地保证系统上线。方法:采用标准的UML方法,编制了适合医院的检验管理信息系统,并完成了详细描述了其具体用例图(Use Case)、顺序图(Sequence Diagram)、类图(Class Diagram)。结果:设备的开机率提高了20%,标本控制时间明显缩短,故障响应时间为1分钟,在系统中及时报警提示。结论:完成了基于UML的LIS系统的设计,提高了设备的工作效能,收到了良好的效果。     

MIMO iterative receiver SNR estimation strategies for link to system interfacing

This paper presents link to system (L2S) interfacing technique for multiple input and multiple output (MIMO) iterative receivers. In L2S interfacing, usually the post detection signal to noise ratio (SNR)‐based frame error rate lookup tables (LUT) are used to predict the link level performance of receivers. While L2S interfacing for linear MIMO receivers can be conveniently implemented, it is more challenging for MIMO iterative receivers due to unavailability of the closed form SNR expressions. In this paper, we propose three methods for post detection SNR estimation for MIMO iterative receivers. The first is based on the QR decomposition of the channel matrix, the second relies on the residual noise calculation based on the soft symbols, and the third exploits the closed form SNR expressions for linear receivers. A link to system interface model for iterative receivers is developed for evaluating the reference curves for different modulation and coding schemes, and results are validated by comparing the simulated and predicted frame error rates. It is shown that linear and residual noise‐based SNR approximations result in a very good prediction performance whereas the performance of QR decomposition‐based method degrades for higher order modulations and coding schemes. This paper presents link to system interfacing technique for MIMO iterative receivers. A link to system interface model for iterative receivers is developed for evaluating the reference curves for different modulation and coding schemes, and results are validated by comparing the simulated and predicted frame error rates. Three post detection SNR evaluation schemes have been proposed for link to system interfacing all of which give good prediction performance especially at lower order modulation.     

Multiuser Frequency Synchronization for Interleaved-OFDMA Uplink Systems

This paper investigates the frequency synchronization in the uplink of the Orthogonal frequency- division multiple access （OFDMA） system with interleaved subcarrier assignment. In such a system, one of the key problems is the multiuser frequency synchronization, which focuses on the multiple-parameter estimation of the Carrier frequency offsets （CFOs）. In this paper, we propose a two-stage frequency offset estimation algorithm. The main advantage of the proposed method is that it can obtain the CFOs of all users simultaneously using only one OFDMA block. In addition, a novel CFO-compensation method is presented. Based on the inner signal structure of interleaved-OFDMA uplink, the new scheme uses adaptive beamformer to compensate the CFO of each user and isolate the signals of all users at the same time. Compared to the previously known methods, the proposed algorithm can provide accurate frequency synchronization and data detection without feeding CFO estimates back to active users for frequency adjustment.     

Adaptive notch filter design under multiple identical bandwidths

Digital notch filters are applied to remove or suppress the narrow-band interferences in digital signals, while preserving other components unchanged. Under the condition of the identical notch bandwidths, a novel design method is put forward in this paper to realize the adaptive notch filter with infinite-impulse response (IIR). Firstly, a specially simplified all-pass filter is introduced to construct an IIR non-adaptive notch filter, which serves as the core part in the adaptive one. Secondly, the criterion of least-mean-square (LMS) is applied to design the desired adaptive notch filter (ANF). The designed ANF can track and suppress multiple non-harmonic interference components simultaneously. Finally, the effectiveness and practicability of the proposed design method are verified by a set of experimental results.     

小波变换在火箭遥测数据误码剔除中的应用

利用MATLAB 仿真,对两段具有代表性的火箭飞行遥测数据进行了小波变换.通过分析不同小波基、分解层数和阈值规则下的处理效果,研究利用小波变换剔除火箭遥测数据误码的可行性.结果表明:对于同一表现形式的遥测数据,只要选择合适的小波基和分解层数,利用小波交换可有效剔除数据中所含误码.     

一种低频外露机载天线隐身设计

针对低成本准隐身飞机,探讨了一种低频外露机载天线的隐身设计,提出了一系列的隐身设计措施(例如优化天线外形、改变安装方式、在天线罩表面涂敷吸波材料等);经过隐身仿真、隐身测试等手段,获取了天线在不同频点、不同极化下的RCS均值,并通过仿真、测试数据对比,验证了隐身改进设计的有效性,并为其他外露物隐身设计提供了设计依据和手段.     

Image Restoration Using Hybrid Features Improvement on Morphological Component Analysis

Images are generally corrupted by impulse noise during acquisition and transmission. Noise deteriorates the quality of images. To remove corruption noise, we propose a hybrid approach to restoring a random noise-corrupted image, including a block matching 3D (BM3D) method, an adaptive non-local mean (ANLM) scheme, and the K-singular value decomposition (K-SVD) algorithm. In the proposed method, we employ the morphological component analysis (MCA) to decompose an image into the texture, structure, and edge parts. Then, the BM3D method, ANLM scheme, and K-SVD algorithm are utilized to eliminate noise in the texture, structure, and edge parts of the image, respectively. Experimental results show that the proposed approach can effectively remove interference random noise in different parts; meanwhile, the deteriorated image is able to be reconstructed well.     

机载可见光摄像机调光方法研究

针对机载光电平台可见光摄像机在执行任务时所面临的场景多样性的特点,对现有调光方法进行了研究,提出一种灰度平均值与区域信息熵相结合的调光方法.方法分为3个步骤,首先是灰度平均值法初调,获得大致清晰的图像;其次是地面人员提取感兴趣目标区域;最后是目标区域内利用信息熵法进行调光.实验结果表明,利用此方法可以获得亮度合适、目标...