Microstructural and compositional aspects of ZnO-based varistor ceramics prepared by direct mixing of the constituent phases and high-energy milling

ZnO-based varistor samples were prepared by the direct mixing of the constituent phases (DMCP) and sintering at 1100 °C for 2 h. The influence of the starting powder mixture's composition – the amounts of the pre-reacted varistor compounds and their composition – and its preparation, either with or without mechano-chemical activation (MCA), on the microstructure, phase composition and electrical characteristics of the varistor samples was studied. It showed that MCA improved the density and microstructural homogeneity of the varistor samples. MCA strongly affected the grain growth: it enhanced the nucleation of inversion boundaries (IBs) in the ZnO grains and the IBs-induced grain-growth mechanism resulted in uniform grain growth and hence a microstructure with smaller ZnO grains and a narrower grain size distribution. The final phase composition of the samples prepared by the DMCP method mainly depended on the presence of varistor dopants that can prevent the formation of the pyrochlore phase, especially Cr₂O₃, while MCA can affect it mostly by providing a homogeneous distribution of those dopants. The DMCP varistor samples prepared with MCA had much better current–voltage characteristics than the samples of the same composition prepared from unactivated powders.     

Sintering studies of nano-crystalline zinc oxide

Sintering and grain growth of nano-crystalline undoped ZnO has been studied in detail over a wide range of temperature and holding time. Below 800 °C, sintering of over 70% theoretical density is not observed, irrespective of particle size. At 900 °C for 6 h, the nano-crystalline sample sinters to 99% of theoretical density whereas the density for as received sample is 93% of theoretical density. However, at 1300 °C or higher, the densification is found to be much faster and after a few hours becomes independent of holding time. Grain growth studies reveal a similar feature of attaining saturation over holding time. The average saturated grain size is found to be ∼1.5 and ∼2.2 μm at 800 and 900 °C, respectively, while at 1300 °C or higher, it is in between 12 and 13 μm.     

Preparation of multi-compositional gas sensing films by combinatorial solution deposition

Various compositions of gas sensing films were prepared by the combinatorial deposition of SnO₂, ZnO, and WO₃ sol solutions and their gas sensing behaviors were investigated. The film composition could be manipulated conveniently via the alternate dropping of different oxide sol solutions. From the correlation between film compositions and gas sensitivities, the selective detection of C₂H₅OH and CH₃COCH₃ in the presence of CO, C₃H₈, H₂, and NO₂ could be attained. In addition, the discrimination between C₂H₅OH and CH₃COCH₃, which is a challenging issue due to their similar chemical nature, becomes possible. This research demonstrates the precise design of the sensor-material composition for the selective gas detection via the combinatorial approach.     

Micromechanical approach to damage mechanics of composite materials with fabric tensors

The purpose of this study is to apply continuum damage mechanics – introduced through the concept of fabric tensors – to composite materials within the framework of the theory of elasticity. A directional data model of damage mechanics for composite materials will be developed using fabric tensors. The introduction of fabric tensors into the analysis of damage of composite materials will allow for an enhanced and better understood physical meaning of damage. The micromechanical approach will be used here to relate the damage effect through fabric tensors to the behavior of composite materials. In this approach, damage mechanics is introduced separately to the constituents of the composite material through different constituents’ damage effect tensors. The damaged properties of the composite system as a whole can then be obtained by proper homogenization of the damaged properties of the constituents.

The derivation of a generalized formulation of damage evolution will be shown here in a mathematically consistent manner that is based on sound thermodynamic principles. Numerical examples will be presented to show applicability. In addition, damage evolution for the one-dimensional tension case is also illustrated.     

Numerical analysis of two-dimensional steady-state and transient heat transfer in a parallel duct filled with pressurized He II

Analysis on steady-state and transient heat transfer on a flat plate at the middle of a parallel duct immersed in He II was performed for bath temperatures from 1.8 to 2.1 K at 101.3 kPa. Two-dimensional computer code named SUPER-2D developed by the authors based on the two-fluid model and the theory of mutual friction was used. Steady-state critical heat flux (CHF) and the time lag from the application of a step heat input to λ transition, that is called a lifetime, were obtained numerically for various step heat fluxes and for the channel gaps from 2 to 20 mm. Effect of the gap restriction on the CHF and the lifetime were clarified. The solutions were compared with the experimental data for the ducts with the same structures and the corresponding conditions. They agreed well with the experimental data. The heat transport mechanism in the parallel duct was clarified.     

The enhanced coercivity for the magnetite/silica nanocomposite at room temperature

Magnetite/silica nanocomposite was synthesized by a facile solvothermal processing at 150 °C for about 10 h. X-ray diffraction (XRD) analysis revealed the effect of annealing on the crystallinity of silica. Transmission electron microscopy (TEM) images showed the good dispersion of magnetite in the silica matrix. Magnetic properties of the nanocomposite were characterized by vibration sample magnetometer (VSM), and the enhanced coercivity was explained by the intrinsic anisotropy of the particles enhanced by the interparticle dipolar fields.     

基于B/S模式矿山管理信息系统构建技术研究

在全面分析以往矿山管理信息特点的基础上，提出了基于B／S模式开发矿山信息系统的思路。对基于B／S模式开发矿山信息系统的关键技术及开发步骤进行了详细的介绍。     

On regular drawn symbolic picture languages

Drawn symbolic pictures are an extension of drawn pictures obtained by associating a symbol from an alphabet to each point of the picture. In the paper we will address some new interesting issues derived from the introduction of the symbols and we will identify the conditions, which ensure the preservation of properties holding for drawn pictures in the setting of the proposed extension.     

Microbiological safety of kinema, a fermented soya bean food

Kinema is a fermented soya bean food of Nepal and the hilly regions of North-eastern States of India. Generally, the fermentation is dominated by Bacillus spp. that often cause alkalinity and desirable stickiness in the product. The present study was undertaken in a limited number of commercial (market) kinema samples to test for the presence of foodborne pathogens and their properties. Bacillus cereus was present in numbers exceeding 10⁴ cfu/g product in five of the tested 15 market samples. Enterobacteriaceae and coliform bacteria exceeded 10⁵ cfu/g in 10 of the 15 samples. Escherichia coli exceeding 10⁵ cfu/g was found in two samples. Staphylococcus aureus was not detected in any of the tested samples. Of 31 isolated typical and atypical strains of B. cereus, 18 representative strains were tested qualitatively for the ability to produce diarrhoeal type enterotoxin (BCET) using an Oxoid BCET-RPLA test kit. Overall, BCET was formed by 12 strains in BHIG (brain heart infusion broth +1% glucose), by seven strains on sterilized cooked rice, and by five strains on sterilized cooked soya beans. Semi-quantitative tests on BCET revealed that levels exceeding 256 ng/g soya beans, produced by single pure culture inoculation with the isolated B. cereus strains, were reduced to ≤ 8 ng/g by frying kinema in oil, a common procedure when making kinema curry. It was also shown in a mixed pure culture experiment that a kinema strain B. Subtilis DK-W1, is able to suppress growth and BCET formation by a selected toxin producing strain (BC7-5) of B. cereus. It is concluded that the traditional way of making kinema and its culinary use in curries is safe. However, for novel applications of kinema, safety precautions are advisable.     

27例乙型血友病患者Ⅸ因子基因突变研究

采用ＰＣＲ（聚合酶链反应）及ＧＡＷＴＳ（ＧｅｎｏｍｉｃＡｍｐｌｉｆｉｃａｔｉｏｎｗｉｔｈＴｒａｎｓｃｒｉｐｔｓＳｅｑｕｅｎｃｉｎｇ）技术，研究了江苏、湖北、山东、广东、福建、宁夏六省区２７例乙型血友病患者及其家系成员ＦⅨ（九因子）基因各２．２Ｋｂ　ＤＮＡ序列。在２ｌ例中发现２０种不同类型的突变。其中１２种是未曾报道的新突变。３８％的突变发生在ＣｐＧ二核苷致序列上，进一步证实了ＣｐＧ确系突变热点。同时检出６例女性为致病基因携带者。对开展基因产前诊断及优生优育等，具有重要意义。