十万立方米储罐用高强钢SPV490Q的冬季焊接施工

通过对高强钢焊接性能的分析 ,提出了高强钢冬季焊接施工带来的问题及处理办法。可靠的焊前预热和焊后保温是确保冬季焊接施工质量的关键措施     

以磷酸为粘结剂的高铝钒土砂的研制与应用

介绍了以磷酸为粘结剂的高铝钒土砂的组成和性能及在离心铸造端盖造型上的使用方法和使用效果。实践证明，它具有很好的经济效益和社会效益。     

一种新颖的跳频振荡器

摘要本文综合考虑到频率合成技术及单端口体波谐振器HBAR的特点提出了一种基于一阶非线性PLL的锁相频率合成方案。文中对这种跳频方案的原理、性能特点作了详细论述、并通过实验、从不同角度对本方案进行了说明、同时对整机的各项指标作了详尽测试:在HBAR无载Q_N值为4000的情况下,该多模跳频振荡源的捷变范围为770MHz—840MHz、捷变时间小于20μS。杂散分量低于—60dB、二次谐波分量低于—34dB。离散捷变频率点为16点,构成闭环跳频系统后,对开环VCO的短稳改善了三个量级:从1.3×10~(-5)/ms到1.6×10~(-8)/ms及9.56×~(-7)/s到1.69×!0~(-9)/s,尤为重要的是该多模跳频振荡源达到此性能所需的硬件量很小,因此在对体积要求苛刻的场合、此种跳频方案具有极强的竞争力。     

S—135钢板热轧工艺研究

S—135钢板是水电站用高强耐磨不锈钢板,既要求强度高、韧性好,又要求耐磨、耐蚀性强,生产难度较大。除我厂外,目前国内尚无其它厂家能够生产这种钢板。该钢板在加热轧制,冷却过程中要解决很多技术难点。我们通过采用特殊的控制轧制和控制冷却工艺,很好地解决了诸多技术难点,使S—135钢板的开发研制取得了成功。为电站用高强度耐磨不锈钢生产提供了宝贵的经验,也为控制轧制及控制冷却技术在中板生产行业的应用起到了积极的推动作用。     

高能超声处理Al-1Si合金凝固组织分析

采用高能超声处理Al-1Si合金熔体,借助金相显微镜和电子探针进行组织分析,并测定合金的熔化潜热,分析了熔体中超声空化效应和声流效应影响凝固过程的机理。结果表明,试样晶粒平均尺寸由超声处理前的94μm减小到超声处理后的34μm;合金试样的熔化吸热量由263.90J/g降低为159.81J/g,在熔体中施加高能超声显著改善了合金成分的均匀性并细化了晶粒。     

A Novel Method Of Transport Barrier Formation

A novel technique is proposed for creating transport barriers by the rf waves. This is that the transport barriers can be created by the rf induced ponderomotive force itself and no rf induced flow shear generation is necessary. It is demonstrated that the ponderomotive force of the rf waves can stabilize the ion temperature gradient (ITG) mode, considered nowadays as the dominant source of anomalous energy losses in the low confinement (L) mode. It is also shown that this stabilization can be achieved for rather modest values of the rf power and hence should be easily obtained in actual experiments.      

Conductor design with high-Tc superconducting Bi(Pb)—2223/Ag multifilamentary tapes

With high upper critical fields, high temperature superconductors (HTSC) have been recognised as candidate materials for coil and magnet applications. High field devices, at one time or another, when operated close to their rated limits are often faced with instability problems which normally are electrical, magnetic or mechanical in nature. The determination of stability parameters, therefore, is of interest to the conductor designer which very much assists in the processing aspect of long length production of wires and tapes. Due to the morphology of the superconductor most HTSC devices made with Bi(Pb)—2223 precursor exist in tape form. Here the determination of stability parameters (for flux-jump and cryogenic stability) for multifilamentary Bi(Pb)—2223/Ag tapes are presented. Processing parameters such as intermediate deformation and filling factors have been found to play a crucial role, not only on the critical current density of the tapes but on the stability aspect in conductor design as well.     

实用型5GHz带宽InGaAs／InP PIN光电探测器

设计并研制成功了实用型５ＧＨｚ带宽ＩｎＧａＡｓ／ＩｎＰ ＰＩＮ光电探测器，介绍了限制探测器响应速度的主要因素，微波封装的理论依据，以及所研制器件频率响应的测试结果。     

电荷灵敏放大器不用反馈高值电阻的新方法

本文提出了一种电荷灵敏放大器不用反馈高值电阻的新方法。对这种方法作了电路分析以及对实际电路的测量结果作了介绍。     

高能粒子辐照对零膨胀微晶玻璃光学性质和面形光学稳定性的影响

研究了高能电子，高能质子对ＶＯ２微晶玻璃辐照前后光性质和面形光学稳定性的影响，研究结果表明，高能电子辐照能引起微晶玻璃面形明显变化，且使ＶＯ２微晶玻璃强烈着色。高能质子辐照没引起面形明显变化，高能质子辐照对反射光谱特性没有影响。