Reconfigurable Microstrip Patch Antenna with Switchable Polarization

A novel reconfigurable microstrip patch antenna with frequency and polarization diversities is proposed. A U‐slot is incorporated into a square patch, and a PIN diode is utilized to switch the slot on and off, which realizes the frequency diversity characteristic. The polarization diversities among linear polarization (LP), right‐hand circular polarization (RHCP), and left‐hand circular polarization (LHCP) are also obtained by switching three PIN diodes on the slot and the truncating corners of a square patch on and off. The antenna design and experimental results are presented.     

V型天线的行波加载公式

本文研究了ｖ型天线上电流分布与阻抗加载的关系，导出了支持天线上行波电流的阻抗加载公式。讨论了天线张角、振子半径以及振子长度与加载量的关系和规律，说明了加载Ｖ型天线的宽带特性。文中还计算了在高斯脉冲激励下，不同加载量的天线上瞬态电流的分布，由此可以表明所导加载公式的正确性与重要性。     

A novel frequency-selective metamaterial to improve helix antenna

A novel frequency-selective metamaterial with negative permittivity and permeability for improving directivity and gain of a helix antenna is presented in this paper.The proposed metamaterial is composed of two Z-shape resonators printed on opposite sides of a dielectric substrate.Two forms of multilayered cells are found to be suitable for antennas and waveguides applications.In addition,a new method of designing a metamaterial-based helix antenna is presented with high directivity and gain.A comparison on radiation properties is given between the conventional and the new metamaterial-based helix antennas.Two comparisons on radiation properties are performed:(1) the effect of proposed Z-structure on monopole,dipole,and helix antennas;(2) the effect of OE3,split-ring resonator (SRR),and proposed Z-structure unit cells on the performance of helix antennas.The results show improvement of parameters such as directivity,gain,and radiation power of the new metamaterial-based helix antenna.Therefore,the combination of Z-structure with the helix antenna shows the best performance.     

多用户MIMO系统低复杂度收发联合波束成形方案

基于多用户多输入多输出(MIMO)有限反馈系统提出了一种收发联合波束成形方法。该方法在发送端采用每个用户酉速率控制(PU2RC)波束成形技术,在接收端采用基于信干噪比(SINR)最大化的天线合并算法。天线合并算法利用用户SINR的广义Rayleigh熵特性寻找最佳的天线合并矢量。仿真结果表明,该方法能充分利用信道信息,不仅改善了传统PU2RC系统的和速率性能,相对于已有的迫零(ZF)联合波束成形方法,对信道状态信息的量化误差的敏感性更低,用户选择算法的复杂度更低,且低速率反馈条件下和速率性能更优。     

Design of the broadband microstrip array antenna for blast furnace surface monitoring

Aiming at the requirements of high-resolution imaging and high integration of the blast furnace radar,this paper presents a method for designing a wideband microstrip array antenna,which broadens the antenna bandwidth through the design of parasitic patches and air layers.By combining multi-input multi-output (MIMO) radar and synthetic aperture radar (SAR) imaging principles,a linear MIMO array is designed,and a near-field simulation imaging experiment is performed on the simulated feed line through the wave number domain imaging algorithm.Simulation results show that the gain of the main lobe of the antenna can reach 14.05 dBi,the reflection coefficient is less than -10 dB,the absolute bandwidth is 5.25 GHz,the operating frequency is 20.67~25.92 GHz,and the range resolution is increased to 3 cm compared with the existing blast furnace radar.The average error of the azimuth direction of the simulated material line imaging is 0.008 m,and the range direction is 0.0011 m.Compared with the traditional microstrip array antenna,this antenna effectively widens the bandwidth,and the range resolution is higher than that of the traditional blast furnace radar.It can accurately obtain the shape information on the simulated material line,and has an engineering application value for blast furnace surface monitoring.     

大型非周期相控阵天线协同设计

针对大型非周期相控阵天线的特点,提出一种多学科、多领域协同设计的方法。然后运用该方法指导两个产品天线设计,围绕协同设计的典型流程和几个关键控制点展开论述。在测试阶段实测天线的主要指标,天线1辐射端面平面度≤1.4 mm,栅瓣电平≤-20 dB,天线2辐射端面平面度≤1.1 mm,栅瓣电平≤-18 dB,实测数据与仿真结果吻合,各项指标优于设计输入要求,使用性能良好,验证协同设计方法的有效性。最后指明大型非周期相控阵天线协同设计的进一步研究方向。     

复合材料夹层结构产品固化变形分析

本文讨论产生复合材料产品固化变形的主要原因是树脂收缩引起的各方向上不同的线膨胀系数具体分析了复合材料夹层结构的的固化变形，经技术上的改进解决了固化变形，以满足产品的设计要求。     

自适应天线匹配低频RFID读写器设计

在工业现场、野外甚至水中,RFID读写器天线电特性参数将发生改变,导致阻抗不匹配和发射功率大幅下降,最终降低RFID读写器读写范围和效率。为了解决这个问题,构建了一个自适应天线匹配RFID读写器系统,该系统在基本读写器系统上增加了自适应电容匹配矩阵、正弦波均方根检测和模/数转换器。该系统通过依次配置电容矩阵,扫描天线发射信号幅度,检测出最佳匹配电容,实现天线阻抗的最佳匹配。通过实验表明,在一定范围内该系统能够实现自动的阻抗匹配,获取最大发射功率。     

基于复合左右手传输线结构的新型微带天线

基于复合左右手传输线结构的零阶谐振理论,提出了一种新型双层结构的微带天线,仿真结果表明该天线具有比单层微带天线更小的尺寸。研究了天线各结构参数对天线特性的影响,并对各参数进行了优化仿真。仿真结果表明该天线具有全向辐射特性,与传统微带天线相比,该天线具有体积小的特点。     

一种新变步长LMS算法及在自适应波束形成中的应用

LMS算法是智能天线自适应波束形成算法中的经典算法,由于其步长固定,造成收敛速度和稳态失调之间的矛盾。为了解决这一问题,提出一种新的变步长LMS算法,并在算法中引入误差信号的自相关估计,大大降低了噪声的干扰,对算法进行仿真,得到了最优的参数设置。利用蒙特卡罗方法对算法进行了性能评估,与传统的LMS算法、NLMS算法相比,新的变步长LMS算法具有更快的收敛速度和较小的稳态误差及优良的抗噪性能。