Pt/C活性催化剂催化氢化合成6-氯-2-羟基喹喔啉

以对氯邻硝基乙酰乙酰苯胺为原料，在碱性条件下经环合及催化氢化合成6-氯-2-羟基喹喔啉。采用自制的Pt／C催化剂，考察了反应条件对产品收率的影响，在85℃，1．0～1．3MPa氢气压力下进行加氢还原反应，总收率89．6％(以对氯邻硝基乙酰乙酰苯胺转化为6-氯-2-羟基喹喔啉)。     

碳铵化肥发青问题解决小结

探讨了该厂化肥生产中碳铵发青的原因,通过硫化氢含量的测定,分析了系统内外影响因素,提出了解决措施,达到了不停车稳定产品质量的目的。     

Kinetics of the methanation of carbon dioxide over a supported Ni-La2O3 catalyst

The kinetics of the methanation of carbon dioxide was investigated using an alumina supported Ni-La₂O₂ catalyst in a differential and integral reactor. In the differential reactor the molar ratio of H₂ to CO₂ was varied from 0.6 to 30. In the integral reactor the rates were measured with up to 90% conversion. Both reactor tests were carried out at temperatures between 513 and 593 K. The experimental results were described by a Langmuir-Hinshelwood type equation. The kinetics can be explained by assuming equilibrium of dissociative carbon dioxide and hydrogen adsorption, and assuming hydrogenation of surface carbon as the rate determining step.     

2,6-二乙酰基吡啶合成方法的改进

优化了2，6—二乙酰基吡啶的合成工艺。以2，6—吡啶二羧酸为原料，经过醇化及克莱森酯缩合反应，合成了2，6—二乙酰基吡啶，2，6—吡啶二羧酸二乙醇和2，6—二乙酰基吡啶的分离收率分别为94．1％和88．9％，2，6—二乙酰基毗啶的质量分数大于99％。     

甲基葡萄糖甙（MeG）水溶液工艺改进试验

介绍了用５次以上的母液生产ＭｅＧ水溶液工艺的改进试验。     

熔块釉中三氧化二硼的测定

用NaOH熔融样品，向标准溶液中加入同样量的KOH基体，建立工作曲线，试样酸化后，直接用ICP－AES法测定。     

Nucleation of isolated PO4 units on CeO2 driven by high temperatures and the effect on its oxygen storage and release properties

The chemical nature of P-containing species of varying concentration present in CeO₂ after impregnation with (NH₄)₂HPO₄ and calcination at 1273 K, and their effects on the oxygen storage and release (OSR) properties of ceria are reported for the first time. The samples were characterized by different techniques and the results were compared with those recently reported on the same samples but calcined at 873 K. When P-containing ceria solids were calcined at 1273 K, CePO₄ (monazite) was the predominant P-containing species on the surface of ceria, confirming previous studies that showed that monazite exists for those samples in which the surface P loading (P atoms per nm⁻²) is larger than 5.5. For lower surface P concentrations, isolated orthophosphate units are present at the surface and within the subsurface region of the solid. Severe sintering of CeO₂ after calcination at 1273 K resulted in P concentrations >5.5 P atoms·nm⁻² in all samples. Isolated PO₄ units that could initially be present in the samples calcined at 873 K nucleated and CePO₄ was formed when samples were calcined at 1273 K. OSR properties of CeO₂ deteriorated progressively when P loading increased due to the presence of larger crystals of the very stable Ce(III) phase of CePO₄ at the surface of the P-containing ceria solids.     

Effect of Pt Incorporation into Ni/ZrO2–SO 4 = /Al2O3 Catalyst for n-Butane Isomerization

Three Ni/ZrO₂–SO₄⁼/Al₂O₃ catalysts with different concentrations of platinum (0.2, 0.3 and 0.4 wt%) were prepare and tested for n-butane isomerization reaction at 338 K, in absence and in presence of hydrogen. The results shown that, at low temperature, platinum contributes to the olefin or butyl ion formation and the reaction follows a bimolecular pathway. However, when the reaction occurs in the presence of hydrogen, the formation of butyl ions is inhibited. The main feature of platinum addition is the stabilization of the catalytic activity, which is indicated by the slow deactivation constants compared to that of the unpromoted catalyst.     

聚己二酸1,2-环己二醇酯的合成

采用正交实验方法,分别以钛酸四丁酯和对甲苯磺酸为催化剂,合成了聚己二酸1,2 环己二醇酯,对其合成工艺条件进行了研究,得出了最佳工艺条件。并以所得聚酯合成了具有透明度高、硬度大、耐磨、玻璃化温度高等优异性能的聚氨酯材料。     

添加物对ZrO2系快离子导体烧结性能的影响

本文介绍了１３２０℃下，ＣａＯ，Ｙ２Ｏ３等稳定剂，低融物组成及１－６价阳离子化合物对ＺｒＯ２烧结性能的影响并列举出材料的晶型及某些主要性能。