添加微量铝对TS-2合成及苯酚羟基化的影响

以硅溶胶为硅源合成分子筛TS 2时 ,在溶胶制备过程中添加微量的铝 ,可以降低模板剂氢氧化四丁基铵 (TBAOH)的用量 ,当TBAOH/SiO2 降低到 0 .1以下时 ,仍然合成了性能优良的TS 2 ,而且用于苯酚过氧化氢羟基化反应过程中催化活性也大大提高。所得催化剂用XRD ,IR ,ICP进行了表征     

浅谈工程项目的预算(成本)管理

从施工单位管理的角度出发,在工程投标、施工前、施工中及完工等不同阶段对项目的预算管理重要性进行描述,充分表明了只有加强各个阶段的预算(成本)管理,才能真正提高经济效益。     

A new amperometric biosensor for fructose determination based on epoxy-graphite-TTF-TCNQ-FDH-biocomposite

In this work a novel amperometric biosensor for fructose determination in solutions was developed. The device was constructed by the incorporation of a tetrathiofulvalene-tetracyanoquinodimethane organic conducting salt and fructose dehydrogenase enzyme, include in a polymeric matrix of epoxy resin and graphite powder. Because of the electrocatalytic function of the salt, the direct transfer of the electron between the reduced prosthetic group (PQQH₂) of the enzyme and the transducing material, was verified at a low working potential (150 mV vs. Ag/AgCl), where the interfering reactions were minimized. The response time at 90% of the steady state value was less than 20 s. The current response was directly proportional to the D-fructose concentration from 0.01 to 0.3 mmol/l with a detection limit of 0.005 mmol/l (signal/noise of 3) and a sensitivity of 1.9985 μA/mmol. The biosensor sensitivity diminishes when its surface is not polished between successive determinations, and remains constant (rsd=1.85, n=10) when the surface is polished between determinations. The effects of temperature and pH on the biosensor response were studied and analyzed; also the properties of the enzyme (Km _ap, I _max, Q₁₀) were determinate in this work. The biosensor was used to determine fructose in high fructose syrups and there were not significant differences between these results and those obtained by HPLC (p≤0.05). During 4 months, in intermittent determinations the biosensor kept 100% of its original sensitivity and after 18 months stored at 4°C, it only lost 32% of its sensitivity. The simplicity, low working potential, high stability and good performance of this biosensor shows a great potential for its use in the fructose determination.     

Syntheses and Structural Characterization of Triorganotin Derivatives of Bis(carboxymethyl)trithiocarbonate: X-ray Crystal Structures of 2D Network Polymers

Six triorganotin(IV) complexes of the type {(R₃Sn)₂[C₃S₃(COO)₂]}_n (R = C₆H₅ 1; n-Bu 2; PhCH₂ 4; p-F-PhCH₂ 5; o-F-PhCH₂ 6) and {(R₃Sn)₂[C₃S₃(COO)₂]}_n·[EtOH] (R = Me 3) have been synthesized by the reaction of bis(carboxymethyl)trithiocarbonate with triorganotin(IV) chloride in the presence of sodium ethoxide. All complexes were characterized by elemental analysis IR, ¹H, ¹³C and ¹¹⁹Sn NMR spectroscopy. Except for 4–6, all complexes were also characterized by X-ray crystallography. The X-ray date revealed that complexes 1–3 show two-dimensional network polymeric structure in which the geometries of tin atoms are trigonal bipyramid with the axial positions occupied by carboxylic oxygen atoms.     

Multiresolution Representation of 2D CSG Models

Multiresolution is currently one of the main schemes used in CAD modeling for representing objects, particularly when large-scale geometric data must be transferred interactively over a network, as in the case of collaborative design. Increasingly complex products and growing competition have turned design into a collaborative team effort. Furthermore, the widespread development of Internet viewers has also necessitated the transfer and display of large-scale CAD models over networks. In order to reduce the volume of transferred data, efforts have been made to transfer CSG (Constructive Solid Geometry) models rather than those based on B_rep (Boundary Representation). This paper presents an original new method for speeding up data transfer by using multiresolution CSG models at different levels of details (LOD). The multiresolution CSG algorithm generates a hierarchy of multiresolution CSG trees; at each level, the shape is further approximated and represented by a smaller number of CSG primitives. The paper analyzes the proposed algorithm, and demonstrates its feasibility.     

Oxidation of oleuropein studied by EPR and spectrophotometry

The autoxidation at alkaline pH and enzymatic oxidation by mushroom tyrosinase of oleuropein, the dominant biophenol present in the fruits and leaves of Olea europea, was followed by both electron paramagnetic resonance (EPR) and absorption spectroscopy. For comparison, the same oxidation processes were applied to 4‐methylcatechol, a simple polyphenol present in olive mill wastewaters. EPR spectra of stable o‐semiquinone radicals produced during autoxidation at pH 12 and short‐lived o‐semiquinone free radicals produced during autoxidation at pH 9.0 or tyrosinase action and stabilized by chelation with a diamagnetic metal ion (Mg²⁺) were recorded for both polyphenols, and the corresponding hyperfine splitting constants were determined. The UV‐Vis spectral characteristics of the oxidation of polyphenols were highly dependent on the type of polyphenol, oxidant type and the pH of the reaction. The kinetic behavior of tyrosinase in the presence of oleuropein and 4‐methylcatechol was followed by recording spectral changes at 400 nm (absorption maximum) over time. The tysosinase activity with oleuropein showed a pronounced pH optimum at pH 6.5 and a minor one around pH 8. From the data analysis of the initial rate at pH 6.5, the kinetic parameters K_m = 0.34 ± 0.03 mM and V_max = 0.029 ± 0.002 ΔA₄₀₀ min^–1 were determined for oleuropein.     

Concomitant Crystallization of Copper(II) Sachharinato Complexes with 2-methylpyrazine as a Monomer and an One-dimensional Polymer: Syntheses,Crystal Structures,Spectroscopic and Thermal Properties

The reaction of [Cu(sac)₂(H₂O)₄] · 2H₂O with 2-methylpyrazine (mpyz) leads two complexes, concomitant crystallization of a mononuclear complex [Cu(sac)₂(mpyz)(H₂O)₂] (1) and a polymeric complex [Cu(sac)₂(μ-mpyz)]_n (2). Both complexes have been characterized by elemental analyses, magnetic measurements, FT-IR and ESR, TG-DTA and single-crystal X-ray diffraction analyses. Single-crystal X-ray analyses show that complex 1 consists of discrete molecules in which the copper(II) ions exhibits a square-pyramidal coordination geometry. The individual molecules of 1 are connected into a hydrogen-bonded chain structure, which is further assembled to form a three-dimensional network by π–π stacking interactions. Complex 2 is an 1D coordination polymer in which copper(II) centers are bridged by the mpyz ligand. The chains are further assembled to form two-dimensional frameworks by π–π and C–H···π stacking interactions.     

ROI-based Watermarking Scheme for JPEG 2000

A new region of interest (ROI)-based watermarking method for JPEG 2000 is presented. The watermark is embedded into the host image based on the characteristics of the ROI to protect rights to the images. This scheme integrates the watermarking process with JPEG 2000 compression procedures. Experimental results have demonstrated that the proposed watermark technique successfully survives JPEG 2000 compression, progressive transmission, and principal attacks.     

Numerical characterization of a microscale solid-oxide fuel cell

In this study, a single unit of planar micro-solid-oxide fuel cell (μSOFC) is investigated numerically to evaluate the influences of flow channel design, oxygen composition, and thermal operating conditions on cell performance. Four flow channel designs are examined under the co-flow configuration: serpentine, double serpentine, rod bundle, and oblique rib. For all designs, the contacts areas of interconnect to electrodes are kept consistent to maintain the ohmic losses at the same level. To characterize the mass transport effects, there are three different compositions, 100% O₂, 50% O₂/50% N₂ and air, fed to the cathode inlet. Different thermal conditions, adiabatic and isothermal, are applied to the outer boundary of the μSOFC and the results are compared. The outcomes suggest that both thermal conditions and oxidant composition show remarkable influences on μSOFC performance. Under adiabatic conditions, the rise of cell temperature causes a decrease in reversible voltage, deteriorating the overall cell competence. When oxygen is diluted with nitrogen, local gas diffusion becomes dominant to the cathode reaction. Bulk flow, on the other hand, plays a minor role in cell performance since there is little deviation in the polarization curves for all flow channel designs, even at high current densities. For comparison, the flow visualization technique is employed to observe the transport phenomena in various flow channel designs. The flow patterns are found to resemble the concentration distribution, providing a useful tool to design μSOFCs.     

An efficient parallel strategy for the perfect domination problem on distance-hereditary graphs

A graph is distance-hereditary if the distance stays the same between any of two vertices in every connected induced subgraph containing both. Two well-known classes of graphs, trees and cographs, both belong to distance-hereditary graphs. In this paper, we first show that the perfect domination problem can be solved in sequential linear-time on distance-hereditary graphs. By sketching some regular property of the problem, we also show that it can be easily parallelized on distance-hereditary graphs.