有源电光调制式高功率瞬态电场传感器的研制

瞬态电场防护及应用技术的研究离不开瞬态电场测试系统;文中基于有源电光调制法,研制了一种高功率瞬态电场传感器;通过建立该传感器的等效电路模型,并借助CST仿真建模,分别从频域和时域角度分析了传感器的接收特性,并得到了一致的结果;最后利用脉冲噪声模拟器和吉赫兹横电磁波小室对研制的传感器性能进行了测试;结果表明:接收天线为单极子天线,天线负载采用高阻时响应电压与被测电场场强成正比;研制的传感器带宽为10kHz～314MHz,可用于纳秒级高功率瞬态电场的时域测试。     

单参数控制的数字DC-DC变换器设计及其FPGA实现

传统的数字DC-DC变换器采用多参数控制方法,因而增加了控制器设计的复杂度和硬件开销;一种单参数控制的数字变换器控制方法被提出,其数字补偿器由一个乘法查找表和一个加法器构成,使得执行数字控制律的逻辑电路得到显著简化;在分析了控制参数对变换器性能的影响后,提出了获得系统最佳瞬态性能的设计条件;基于所提的单参数控制方法,完成了数字Buck变换器的FPGA实现,测试结果表明:在1MHz的开关频率下,对于1.8V的输出电压,电压纹波律小于1%,电压调整率为6mV/V,负载调节律为8mV/A;负载电流为0.3A时,转换效率高达91.9%。     

视觉测量中多光学靶点亮度自适应控制

提出了一种面向大视场高精度视觉测量的多红外目标靶点（红外LED）亮度自适应控制方法。以微控制器PIC16F873A和LED驱动芯片MAX6964作为核心器件,设计了可满足大空间范围内靶点亮度控制需求的多目标靶点控制驱动器。为了使LED在近距测量时的调节精度和远近距离测量时的发光亮度都能满足要求,根据MAX6964输出特点设计了PWM信号输出电路,并采用推挽电路驱动LED。实验证明,目标靶点在CCD相机上成像光斑稳定一致。     

A preliminary study of a diagonal channel-routing model

The layout of two-terminal nets in a VLSI channel is realized in a new diagonal channel-routing model (DCRM), where the tracks are segments respectively displayed at +45 ° and –45 ° on the two layers of the channel. A new definition of channel density is introduced, and a lower bound to the channel width is derived by the application of an algorithm, whose complexity is evaluated as a function of the channel density, and other parameters of the problem.A simple linear-time algorithm is proposed, which produces an optimal layout (i.e., it requires a channel of minimum width) if the length of the longest net equals the lower bound for the channel width. In any case, the number of vias is at most one for each net. Some particular solutions are proposed for problems with long nets.Specific problems are much easier in DCRM than in the classical Manhattan model. For example, any shift-by-i can be realized in DCRM in a channel of widthi.This work has been supported by Consiglio Nazionale delle Ricerche of Italy under a research grant.     

《自动控制原理》课程中闭环脉冲传递函数算法研究

针对一般方法推导离散系统闭环脉冲传递函数过程繁琐费时的问题,给出一种先连续化求出闭环传递函数再离散化求解的简便方法,并给出使用本方法的单一化条件。对于满足该条件的系统,可直接求用简便方法求取系统的闭环脉冲传递函数,不满足该使用条件的系统,对其中间变量的求取可使用本方法,因而大大简化求解闭环脉冲传递函数的过程,为采样控制系统的分析和设计提供了很大的方便。     

一种基于小波变换的非均匀量化索引调制水印算法

为了提高数字水印的稳健性与不可见性,将图像小波变换与量化索引调制算法相结合,提出了一种基于小波变换的非均匀量化索引调制数字水印算法。该算法对原始图像进行离散小波变换,将中频小波系数分成3×3的系数子块作为水印载体,对子块的系数均值采用非均匀量化索引调制,实现二值水印的嵌入。根据人类视觉特性,不同的系数子块采用不同的量化间隔并自适应于子块内相邻系数的差值。实验结果表明,该算法透明性好,安全性高,对高斯白噪声、剪切、滤波以及JPEG压缩等常见攻击具有较强的稳健性。     

参激随机共振及纠错码技术的应用

为了有效地降低数字信号传输过程中的比特误码率,提出了纠错编码与参数调节随机共振技术的结合.在经过噪声污染后,依据参数调节随机共振技术的性质,给出通过系统参数调节的二进制脉冲幅值调制（PAM）输入信号的渐近误码率公式,应用纠错码技术采用中间值估计的方法得到修正的比特误码率.数字仿真试验证实,理论计算结果与试验结果相吻合,纠错码技术与参激随机共振技术的结合应用于二进制基带信号传输,可以降低误码率,从而可以得到更好的效果,提高通信的可靠性和有效性.     

电能变换领域中随机脉宽调制技术研究概况及展望

相较于传统的脉宽调制技术,随机脉宽调制具备有效的谐波频谱分散能力,从而实现机电负载噪声的削弱。随机脉宽调制技术包括起步的随机开关调制、后续的随机脉冲位置与随机开关频率等3个基本方法。随着电力电子技术的整体发展,随机脉宽调制已从传统的载波调制逐渐拓展到空间矢量调制之中,应用范围日趋广泛,谐波频谱分散与功率谱峰值抑制的效果不断提升。同时,新的优化方案不断被提出,对谐波频谱及功率谱的分散效果亦在不断提高。梳理了随机脉宽调制的研究历程,总结了数种典型的随机脉宽调制的基本原理,并对未来随机脉宽调制的研究方向作出展望,为随机脉宽调制技术的深入研究提供参考。     

Corrosion inhibition of carbon steel in hydrochloric acid by cationic arylthiophenes as new eco-friendly inhibitors: Experimental and quantum chemical study

This study describes the adsorption behavior of three arylthiophene derivatives namely: 2-(4-amidino-3-fluorophenyl)-5-[4-methoxy phenyl] thiophene dihydrochloride salt (MA-1217), 2-(4-amidinophenyl)-5-[4-chlorophenyl] thiophene dihydrochloride salt (MA-1316) and 2-(4-amidino-3-fluorophenyl)-5-[4-chlorophenyl]thiophene dihydrochloride salt (MA-1312) at C-steel in 1.0 mol·L^-1 HCl interface using experimental and theoretical studies. Electrochemical and mass loss measurements showed that the inhibition efficiency (IE) of the arylthiophene derivatives increases with increasing concentrations and exhibited maximum efficiency 89% at 21×10^-6 mol·L^-1 (MA-1217) by mass loss method. The investigated arylthiophene derivatives obey the Langmuir adsorption isotherm. From polarization studies the arylthiophene derivatives act as mixed-type inhibitors. Surface analysis were carried out and discussed. The mode of orientation and adsorption of inhibitor molecules on C-steel surface was studied using molecular dynamics (MD) simulations. Quantum chemical parameters as well as the radial distribution function indices and binding energies confirm the experimental results.     

Potential of Silver Nanoparticles in Overcoming the Intrinsic Resistance of Pseudomonas aeruginosa to Secondary Metabolites from Carnivorous Plants

Carnivorous plants are exemplary natural sources of secondary metabolites with biological activity. However, the therapeutic antimicrobial potential of these compounds is limited due to intrinsic resistance of selected bacterial pathogens, among which Pseudomonas aeruginosa represents an extreme example. The objective of the study was to overcome the intrinsic resistance of P. aeruginosa by combining silver nanoparticles (AgNPs) with secondary metabolites from selected carnivorous plant species. We employed the broth microdilution method, the checkerboard titration technique and comprehensive phytochemical analyses to define interactions between nanoparticles and active compounds from carnivorous plants. It has been confirmed that P. aeruginosa is resistant to a broad range of secondary metabolites from carnivorous plants, i.e., naphthoquinones, flavonoids, phenolic acids (MBC = 512 µg mL⁻¹) and only weakly sensitive to their mixtures, i.e., extracts and extracts’ fractions. However, it was shown that the antimicrobial activity of extracts and fractions with a significant level of naphthoquinone (plumbagin) was significantly enhanced by AgNPs. Our studies clearly demonstrated a crucial role of naphthoquinones in AgNPs and extract interaction, as well as depicted the potential of AgNPs to restore the bactericidal activity of naphthoquinones towards P. aeruginosa. Our findings indicate the significant potential of nanoparticles to modulate the activity of selected secondary metabolites and revisit their antimicrobial potential towards human pathogenic bacteria.