单片机的显示接口电路设计

介绍了利用单片机的串、并行接口和专用显示接口 IC 设计显示接口电路的方法,并提供了4种动态和静态显示的硬件接口电路。     

Degradation of polyethylene terephthalate films in the presence of lubricants for HFC 134a: a critical issue for hermetic motor insulation systems

Earlier studies conducted in the use of sealed tubes with polyalkylene glycol lubricants and polyethylene terephthalete (PET) films revealed that the PET films exhibited embrittlement and (visual) degradation. This led to an investigation of PET embrittlement mechanisms with the new lubricants used with HFC 134a. The lubricants studied were three polypropylene glycols (the monol, the diol and the completely end-capped glycols), pentaerythritol ester and a blend of monol and ester. The effects of moisture content, temperature and lubricant structure were studied. All lubricants in this study were of viscosity grade ISO-32 (150 SUS). The results were compared to PET film embrittlement in the presence of CFC 12 and mineral oil. This study reconfirmed the earlier findings that the PET films must be dried to lower than 0.1 wt.% moisture content for use in hermetic systems. This paper discusses the effect of the moisture content of the lubricant and the effect of the lubricant structure on PET films. The dependence of the various mechanisms on temperature is shown. Esters and end-capped polyalkylene glycols are recommended for use with HFC 134a.     

阻尼式限流器参数的设计选择

本文阐述阻尼式限流器参数设计选择和产品系列规划的依据原则，并结合实例说明实施步骤与方法，以有助于限流器的正确设计与选用。     

An experimental and numerical study of hunting in thermostatic-expansion-valve-controlled evaporators

The dynamic behaviour of a thermostatic-expansion–valve (TEV)-controlled dry-evaporator is studied experimentally and numerically. Although the linear model of the TEV together with the distributed model of the evaporator is able to predict the stable dynamic response of the system adequately, it fails to reproduce the hunting behaviour that is observed under certain operating conditions. A scrutiny of the experimental data reveals the possible existence of hysteresis in the system. The distributed model including the experimentally determined input-output characteristics of the TEV is able to reproduce the main features of the hunting oscillations well. The amplitude and frequency of these oscillations depend on the static superheat setting, the heat load of the evaporator and the time constant of the TEV bulb.     

Continuous formation of slurry ice by cooling water–oil emulsion in a tube

Water-silicone oil emulsion with an additive, (C₂H₅O)₃SiC₃H₆NH₂, was examined as a heat storage material. A spiral tube used as a heat exchanger was immersed in a low temperature bath and the emulsion was circulated in the tube to make ice continuously. Ice was separated from the ice–liquid suspension in an outlet tank. The amount of formed ice, the temperatures of the inlet and the outlet of the heat exchanger, and the temperatures in the tube wall were measured and the overall heat transfer coefficient and the heat flux through the tube were calculated. Experiments were carried out, varying the flow rate, the temperature of cooling brine, and the thickness of tube wall. The condition under which slurry ice was formed continuously without adhesion of ice to the cooling wall was clarified. Though decrease in the thermal resistance of the tube increased the rate of ice formation or raised the brine temperature, it narrowed the range of the flow rate and of the brine temperature in which slurry ice was formed continuously.     

Performance of compression/absorption hybrid refrigeration cycle with propane/mineral oil combination

This paper discusses the feasibility of a vapor compression/absorption hybrid refrigeration cycle for energy saving and utilization of waste heat. The cycle employs propane as a natural refrigerant and a refrigeration oil as an absorbent. A prototype of the cycle is constructed, in which a compressor and an absorption unit are combined in series. The performance of the cycle is examined both theoretically and experimentally. Although the solubility of the propane with the oil is not enough as a working pair in the absorption unit, the theoretical calculation shows that the hybrid cycle has a potential to achieve a higher performance in comparison with a simple vapor compression cycle by using the waste heat. In the experiment, the prototype cycle is operated successfully and it is found that an improvement of an absorber is necessary to achieve the good performance close to the theoretical one. The application of an AHE (absorber heat exchanger) can reduce the heat input to a generator. Further examinations on some other combinations of refrigerant/refrigeration oil and additives are desirable.     

8-R-9苄基-9H-嘌呤衍生物的合成研究

采用 (Ph3 P) 2 PdCl2 为催化剂 ,DMF为溶剂 ,对 8 碘 9 苄基 9H 嘌呤与有机锡试剂RSnBu3 (R=乙烯基、2 噻吩基、2 呋喃基、苯乙炔基和苯基等 )之间的Stille偶合反应进行了研究 ,合成出了5种 8位取代的嘌呤衍生物。在反应温度为 80℃ ,n(8 碘 9 苄基 9H 嘌呤 )∶n (RSnBu3 )∶n〔(Ph3 P) 2 PdCl2 〕 =1 0∶1 2∶0 0 5的较佳工艺条件下 ,产品收率 4 1%～ 91%。用1H NMR、13 C NMR和MS对产物进行了表征     

A novel method of suppressing the inrush current of transformers by using a series‐connected voltage‐source PWM converter

This paper proposes a novel method of suppressing the inrush current of transformers. A small‐rated voltage‐source PWM converter is connected in series to the transformers through a matching transformer. As the connected PWM converter serves as a resistor for the source current, no inrush phenomena occurs. The required rating of the PWM converter, which serves as the damping resistor for the inrush phenomena, is 1/400 that of the main transformers in single‐phase circuits. In three‐phase circuits, it is 1/900. The basic principle of the proposed method is discussed. Digital computer simulation is implemented to confirm the validity and excellent practicability of the proposed method using the PSCAD/EMTDC. A prototype experimental model is constructed and tested. The experimental results demonstrate that the proposed method can perfectly suppress the inrush phenomena. © 2006 Wiley Periodicals, Inc. Electr Eng Jpn, 157(4): 56–65, 2006; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/eej.20174     

毫米波谐波振荡器的Volterra级数分析法

本文基于Ｖｏｌｔｅｒｒａ级数法和非线性转移函数理论，提出了一种分析毫米波谐波振荡器的新方法，给出了描述其非线性特性的决定方程，通过求解一组非线性代数方程，便可计算出谐波振荡器的振荡频率和幅度。文中给出了具体分析实例，并与谐波平衡法等进行了比较，结果表明：这种方法具有理论严密、准确性高、适用范围广等特点，特别是利用一次决定方程的结果作为其它非线性数值分析方法的初始估值，则可大大地节约计算时间，并容易     

随钻气侵检测仪在胜利油田的应用

简要介绍了随钻气侵检测仪的结构特点、工作原理、现场模拟试验及应用情况。中原油田全尺寸实验井和胜利油田６口井的现场试验及应用结果表明，该仪器能实现早期气侵检测，比常规方法检测到气侵的时间明显提前，对高压气井和复杂地层井控具有重要的现实意义。