Computation of Bearing Capacity Factor Nγ?Terzaghi’s Mechanism

A procedure based on K?tter’s equation is developed for the evaluation of bearing capacity factor Nγ with Terzaghi’s mechanism. Application of K?tter’s equation makes the analysis statically determinate, in which the unique failure surface is identified using force equilibrium conditions. The computed Nγ values are found to be higher than Terzaghi’s value in the range 0.25–20%, with a diverging trend for higher values of angle of soil internal friction. A fairly good agreement is observed with other solutions which are based on finite difference coupled with associated flow rule, limit analysis, and limit equilibrium. Finally, the comparison with available experimental results vis-à-vis other solutions shows that, computed Nγ values are capable of making a reasonably good prediction.     

钻井井架力学性能分析

钻井井架作为钻机系统设备中的关键部分,其力学性能直接关系到整套钻机系统的安全生产。文章推导了常用于分析钻井井架力学性能的理论,即线性屈曲、几何非线性和双重非线性理论。提出同时用这三种理论对钻井井架进行综合比较分析,从而合理地预见井架力学性能的方法。以A形钻井井架为例,进行了详细的分析,得到了井架的失稳形式、极限承载、破坏特征及薄弱部位,为钻井井架的设计、优化与评定提供了参考。     

文东油田连续气举优化配气数学模型建立及应用

针对连续气举在开发过程中出现的注入气利用效率低、综合效益差的问题，建立了供气能力有限时的优化配气数学模型，给出了解析法求解过程。文东油田现场试验表明，应用该技术可以实现连续气举井的合理配气，并提高油井产量，适合在油田推广应用。     

Functional and sensory properties of chicken meat from spent-hen carcasses deboned manually or mechanically in Jordan

Samples of chicken meat from spent laying hens were obtained by four different methods: (1) manual deboning of whole carcasses; (2) manual deboning of skinned carcasses; (3) mechanical deboning of whole carcasses; and (4) mechanical deboning of skinned carcasses. The meat was packaged, frozen and stored at ?18 °C for up to 3 months. Functional properties studied were pH, emulsifying capacity (EC) and water‐holding capacity (WHC) and, in addition, pigment concentration was investigated. Sensory properties included aroma, colour, texture and overall acceptability, as judged by a trained panel using a nine‐point hedonic scale. Removal of the skin prior to deboning by either method gave significantly higher values (P < 0.05) for EC, while WHC values were not significantly different among the experimental treatments, despite higher pH values for mechanically‐deboned meat, with and without skin. Pigment concentrations were highest in meat from Treatment 4 and lowest for Treatment 1, but values for both methods of deboning were affected by the presence of skin. There were no significant differences between treatments for any of the sensory properties studied. Changes occurring in the meat during frozen storage are described.     

Design and Characterization of the CLIMPAQ,Chamber for Laboratory Investigations of Materials,Pollution and Air Quality*

A test chamber has been developed in order to provide a small and simple emission testing facility capable of testing construction products in a climate where the important climatic parameters such as temperature, ventilation rate and air velocity can be varied independently around typical indoor values. The test chamber CLIMPAQ is made of panes of window glass. Other main surface materials are stainless steel and eloxated aluminium. The chamber has a volume of 50.9 litres and is designed to meet the requirements for quantifying air pollution. In this investigation human subjects acted as air pollution judges, and chemical characterization of the air pollution was carried out. Carpet, linoleum, wall paint and seal- ant were tested simultaneously in the CLIMPAQ and in four other chambers ranging from a full-scale chamber of 28 m³ to a field and laboratory emission cell of 3.5· 10^?5m³. Product ranking is the same in all chambers for the sensory measurements. Emission rates based on sensory measurements differ for all products less than 100 % except for tests in a 3-litre chamber where emission rates were higher. Chemical measurements differ up to approximately 10 times for the same product in different chambers. Deviations appear to be the result of different environmental parameters in the various chambers. Low air concentrations or high specific ventilation rates seem to increase emissions, while differences in air velocities and sink properties may also be the cause of differences in emission rates.     

丙烯酸接枝聚丙烯纤维的结构与性能

本文研究了用化学引发剂引发丙烯酸接枝聚丙烯纤维的某些影响因素。红外光谱分析表明，丙烯酸接枝在聚丙烯大分子链的叔碳原子上。Ｘ－射线衍射和ＤＳＣ分析指出，纤维接枝后结晶度有所增加，接枝前纤维存在的β－变体转化成了α－变体，接枝纤维的吸湿性、离子交换容量和染色性随接枝率增加而增大。接枝纤维的力学性能有所下降。     

Decisive arrival law parameters and a general finite capacity queueing problem

This paper addresses the problem of finding the parameters of the arrival law which most significantly influence expected occupation and loss of a finite capacity queue. The input process is supposed to be ergodic and wide sense stationary. We show that it is mostly possible to fit an MMPP(2) to the decisive parameters of observational data. Numerical examples illustrate the importance of the decisive parameters, called key parameters, and also show the accuracy of the proposed fitting procedure. Finally, in the appendix we present the solution of the finite capacity queueing problem with Special Semi Markov Process (SSMP) arrivals and a general service strategy.     

基于电压陡降的VRLA容量预测新思路

重点介绍了蓄电池电压陡降与容量之间的关系及各操作因素对电压陡降的影响。由此引出一种新的蓄电池容量预测思路,并就如何实现它进行了初步探讨,最后对该思路进行了简要的展望。     

PTN网络的二次断纤链路规划算法

在PTN（PacketTransportNetwork）网络规划建设中,需要对光纤链路留出备份带宽,以保证部分光纤断开时,受影响业务有足够的容量进行路由重组。这也是提高网络生存性的有效方法之一。文中首先遍历网络双链路的失效状态,然后断开网络中任意两条链路,通过逐次增加链路容量来保证失效业务能够重组路由;最后提出二次断纤链路容量规划算法并进行试验仿真。结果表明,该算法在节约网络带宽、降低建造成本以及故障容错方面有着良好性能,能够很好应用于传送网络的链路规划中。     

Aluminum. II. Derivation of C v0from C p and comparison to C v0 calculated from anharmonic models

The specific heat at constant pressure, C _p, of aluminum measured by Ditmars, Plint, and Shukla has been reduced to the volume V ₀ appropriate for 0 K employing the Murnaghan equation. The C _v0 thus obtained is compared with the theoretical C _v0 calculated in the harmonic and the lowest-order anharmonic approximation from three different pseudopotentials (Harrison, Ashcroft, and Dagens-Rasolt-Taylor) as well as a phenomenological Morse potential. The higher-order ( ⁴) anharmonic contributions are calculated from the same nearest-neighbor Morse potential as in the lowest-order anharmonic theory. The role of the vacancy and the higher-order anharmonic contributions to C _v0 has been examined and we conclude that the ⁴ contributions to C _v0 are much smaller than the vacancy contribution. After removal of the vacancy contribution, the reduced C _v0 is found to be in excellent agreement with the Ashcroft and Harrison pseudopotentials as well as the Morse potential including the ² and ⁴ contributions to C _v0.