The Chemistry of Water Treatment Processes Involving Ozone,Hydrogen Peroxide and Ultraviolet Radiation

Advanced oxidation processes are defined as those which involve the generation of hydroxyl radicals in sufficient quantity to affect water purification. The theoretical and (practical yield of OH from O₃ at high pH, 0₃/H₂0₂, O₃/UV and H₂O₂/UV systems is reviewed. New data is presented which illustrates the importance of direct photolysis in the O₃/UV process, the effect of the H₂0₂:0₃ ratio in the O₃/H₂O₂ process, and the impact of the low extinction coefficient of H₂O₂ in the H₂0₂/UV process.     

Photostabilization of cationic UV-cured coatings in the presence of nanoTiO2

The effect of TiO₂ nanoparticles for sun-weathering protection of UV-cured coatings is investigated. TiO₂ is either introduced in the form of nanoparticles in the photocurable formulations or generated in situ via sol–gel process. Cured films containing comparable amounts of TiO₂ were weathered for 800 h under UV irradiation and compared with free-TiO₂ coating. The TiO₂ presence induces a clear lower mass loss decrease during weathering as well as a lower gel content decrease. The TiO₂ screen effect is also confirmed by a lower alkyl-band reduction monitored by FT-IR during weathering. The TiO₂ generated in situ via sol–gel gives rise to transparent coatings without interfering with photopolymerization process and therefore without compromising UV-cured film properties.     

185nmUV降解水中4-CP、4-NP和RhB的研究

本文以对氯苯酚（4-cP）、对硝基苯酚（4-NP）和罗丹明B（RhB）为模型有机物（以4-CP和4-NP为小分子模型有机物，以RhB为大分子模型有机物），分别研究了185nmUV对水中这3种模型有机物的降解规律、性能和效果．研究结果表明，185nmUV直接对水中4-CP、4-NP和RhB有很好的降解效果．研究内容包括：185nmUV降解模型有机物的浓度、TOC（Totalorganic carbon）浓度、185nmUV降解模型有机物过程中溶液pH及电导率变化、以及降解模型有机物过程中产生的无机离子等几个方面．     

紫外/臭氧复合杀灭水中细菌性能研究

为开发一种高效灭菌方法,研究了UV/O3的复合灭菌性能,对紫外辐射、臭氧和羟基自由基等在体系中的各自作用进行探讨,同时考察pH值、温度等对灭菌效果的影响.结果表明,UV/O3较单独紫外或臭氧灭菌时效果有所提高,在初始臭氧质量浓度为5.02mg·L-1,液面紫外辐射强度为6.5mW·cm-2,灭菌时间1.5～9.0s时,UV/O3对细菌总数灭菌率达3.6～6.4,单独紫外时为1.8～4.7,单独臭氧时仅为1.6～3.0.羟基自由基的产生是复合灭菌效果增加的主要原因.随紫外辐射强度和臭氧投加量的增加,复合灭菌作用得到提高.pH值在5.5～8.5变化时,UV/O3灭菌效果随原水pH值的增加略有提高.温度由10℃上升到27℃时,灭菌效果稍有下降.由此可见,UV/O3是一种高效可行的水体灭菌技术。     

日盲区紫外光非视线传输模型

为建立一个更接近实际情况的紫外光非视线传输模型,用来处理复杂的大气条件和边界条件,建立了基于Monte Carlo方法的紫外光非视线传输快速算法模型。分析了发射功率为1 W的单色紫外光信号在不同环境条件下的脉冲响应函数和边界条件对信号强度空间分布的影响,以及系统发射仰角和接收仰角与探测信号强度的关系。与单次散射模型比较,该模型具有更高的精度和边界处理能力。对合理涉及通信系统、提高通信质量都有很大提高。     

Synthesis of nanodispersed oxides of vanadium, titanium, molybdenum, and tungsten on mesoporous silica using atomic layer deposition

The advantages of the atomic layer deposition (ALD) method for preparation of tungsten, vanadium, titanium, and molybdenum oxide catalyst supported on mesoporous silica are discussed, with emphasis on the importance of synthesis conditions on dispersion, structure and activity of the resulting materials. A suite of complementary techniques such as DRS-UV/Vis, BET, ¹H-NMR, XRD, and TEM were used to study the structural properties of the supported metal oxides, and probe reactions such as 2-butanol dehydration and ethanol partial oxidation were used to demonstrate the potential advantages of the ALD-prepared catalysts. Specifically, highly dispersed oxides of titanium, molybdenum, and tungsten oxide on mesoporous silica were synthesized using the ALD method. It is also demonstrated that attainment of high dispersions of vanadium oxide on mesoporous silica requires the presence of at least a single layer of titanium oxide due to the well-known poor interaction between vanadia and silica. The highly dispersed catalysts prepared here by ALD methods exhibited superior catalytic performance relative to those prepared using conventional incipient wetness impregnation.     

Performance Comparison of Long-Wave Infrared Imaging Spectrometer Between Dyson Form and Offner Form

In view of the difficulties in traditional long-wave infrared imaging spectrometer which is hard to realize a high signal-to-noise ratio and miniaturization as well under the weak remote sensing signal,Offner convex grating spectrometer and Dyson concave grating spectrometer,both having concentric structure,are designed and analyzed in the band of 8-12 μm. The diffraction angle expressions of the two spectrometers are obtained and the diffraction characteristics are acquired. Both of the spectrometers are designed in Zemax environment under different F-numbers and different grating constants with the same slit,spatial resolution,spectral resolution and detector. The results show that Dyson grating spectrometer possesses the advantages of higher throughput and smaller volume, and Offner grating spectrometer possesses the advantage of more accessible material and the absence of chromatic aberration. The differences between Dyson form and Offner form show that the former is a better choice in the long-wave infrared imaging spectrometer.     

快照成像光谱仪快速光谱重构算法

为实现对光谱数据的快速实时处理,针对快照式傅里叶成像光谱仪,提出一种基于GPU的并行化光谱重构算法.通过分析快照式成像光谱仪的工作原理和数据特性,结合CUDA并行计算架构,对光谱重构算法可并行部分最大程度并行化,并针对并行计算中的内存分配等方面进行优化处理,实现并行化的光谱重构算法.实验结果表明:基于GPU的并行化光谱重构算法,相对CPU串行化算法,精度相同的情况下,计算效率提升了约25倍.利用GPU加速程序的并行部分,可以极大地提高光谱重构的效率,使得快照式成像光谱仪更加适用于实时测量当中.     

CO2探测仪近红外焦平面无效像元检测方法

针对HgGdTe探测器均匀性差、无效像元多,过多无效像元会降低碳卫星CO2探测仪红外焦平面探测器探测精度,提出了一种基于探测器性能测试数据进行无效像元筛选的方法.首先利用CO2探测仪冷光学实验设备采集暗背景数据与响应度数据,然后计算暗背景数据的DN值均值与标准差、各个像元的响应度曲线,利用直方图阈值筛选出暗像元、亮像元、不稳定像元、平均拟合偏差较大等无效像元,最终利用各种无效像元集合交并集确定最终无效像元.结果表明:基于各种无效像元集合交并集确定最终无效像元的无效像元筛选方法准确度更高.通过遍历筛选出无效像元的响应值,从而确认了无效像元筛选的合理性.     

Fabrication of high-efficiency anatase TiO2 photocatalysts using electrospinning with ultra-violet treatment

In metal oxide nanofiber fabrication using the electrospinning method, heat treatment is performed at temperatures of 500°C or higher for crystallization and polymer desorption. Therefore, it is difficult to fabricate low-temperature phase metal oxides that crystallize at low temperatures. TiO₂, a representative metal oxide often used as photocatalysts, is known to have higher photocatalytic activity in the low-temperature phase (anatase structure) than in the high-temperature phase (rutile structure). Studies on the fabrication of TiO₂ anatase nanofibers using conventional electrospinning have reported disadvantages such as the partial expression of rutile structures and low crystallinity. This study developed an anatase TiO₂ nanofiber as a high-efficiency catalyst based on the electrospinning method and a residual organic matter cleaning method that employs ultra-violet (UV) light. We fabricated nanofibers using the electrospinning method and implemented TiO₂ nanofibers with the anatase structure through heat treatment at 260°C. Residual organics remaining after heat treatment of the fabricated crystalized TiO₂ nanofibers were removed by exposing them to UV light, thereby improving photocatalytic efficiency. The photocatalytic efficiency of the fabricated TiO₂ nanofibers was confirmed through a methylene blue (MB) decomposition experiment under visible light irradiation. The photocatalytic efficiency (time taken for the concentration of the MB solution to reach 50%) of the UV-treated TiO₂ nanofibers was approximately six times higher than of P25 and the heat-treated nanofibers.