除氧化物剂的除氧机理浅析

对无缝钢管生产所用的内壁除鳞材料———除氧化物剂中各个组分的性质和作用进行了阐述,提出了除氧化物剂的除氧机理。     

Casein Hydrolysate Fractions Act as Emulsifiers in Process Cheese

ABSTRACT: Degrees of hydrolysis and emulsifying activity of casein hydrolysates were the highest at 4 h hydrolysis. The oil-off values of the mixture of hydrolysate (H) or supernatant (S) and traditional emulsifier (T) were not significantly different from the control made with traditional emulsifier, except for S + T = 3:1. Two other samples made with hydrolysate or supernatant only (H or S) showed higher oil-off value than the others (p < 0.05). In flavor property, no difference was found between samples made with traditional emulsifier and those made with the mixture of hydrolysate or supernatant at the ratio of 3 to 1. Therefore, these results indicated that a mixture of the hydrolysate or supernatant and traditional emulsifier might replace a traditional emulsifier in process cheese manufacturing.     

Ionoluminescence decay measured with single ions

A new ion beam analysis-based, single ion technique called the time to first photon has been developed to measure the decay of the luminescence signal of phosphors. Such measurements are currently needed to study luminescence decay mechanisms following high-density excitations and to identify strongly luminescent phosphor coatings with short lifetimes for ion photon emission microscopy (IPEM). The samples for this technique consist of thin phosphor layers placed or coated on the surface of PIN diodes. Single ions from an accelerator strike this sample and simultaneously create ion beam induced luminescence (IBIL) from the phosphor that is measured by a single-photon-detector, and an ion beam induced charge collection (IBICC) signal in the PIN diode. In this case, the IBICC signal provides the start pulse and the IBIL signal the stop pulse to a time to amplitude converter. It is straightforward to show that this approach also measures a signal proportional to activity versus time with an accuracy of 5% as long as the number of detected photons per ion is less than 0.1, which usually requires the use of absorbers for the IBIL detector or electronic discrimination for the IBIL signals. Details of the new analysis are given together with examples of luminescence decay measurements of several ceramic phosphors being considered to coat IPEM samples. IPEM is currently being developed at Sandia National Laboratory (SNL), the University of North Texas in Denton, and the Universities and INFN of Padova and Torino.     

工程监理取费偏低,阻碍监理行业发展

工程监理制在我国建筑市场中，对提高工程质量、控制投资效益起着极其重要的作用，目前我国工程监理行业在低取费的条件下，困难重重，只能维持低水平运行。我们应找出存在的差距，采取相应的措施，适当提高监理取费，使监理行业迅速发展壮大。     

偶联剂处理硅灰石填充不饱和聚酯树脂的研究

对针状硅灰石 (L∶D≥ 10∶32 5目 )提纯后 ,采用偶联剂进行表面处理 ,将硅灰石按不同比例填充于不饱和聚酯树脂体系中 ,研究了材料的性能。结果表明 ,改性后的硅灰石可显著改善不饱和聚酯的性能。     

Theoretical Discussion of Couple-Mode Using Chirped Fiber Grating for Dispersion Compensation

１ＩｎｔｒｏｄｕｃｔｉｏｎＡｔｐｒｅｓｅｎｔ，ａｓｔｈｅｅｒｂｉｕｍｄｏｐｅｄａｍｐｌｉｆｉｅｒｓｈａｖｅｓｕｃｅｓｆｕｌｙｂｅｅｎａｐｐｌｉｅｄｔｏｏｐｔｉｃａｌｆｉｂｅｒｌｉｎｋｓ，ｔｈｅｌｏｎｇｈａｕｌｈｉｇｈｂｉｔｒａｔｅｏｆｏｐｔｉｃ...     

基于移动Agent技术的QoS保障机制

介绍了移动Agent的基本特性。移动Agent可在异构的网络各个节点间自由地移动,它能感知网络的状态,监控系统并与其他Agent进行交互。IETF的IS模型采用了RSVP(ResourcereSerVationProtocol)协议对系统资源进行预留,从而达到一定程度上保障所需QoS的目的。QoS保障机制将移动agent技术与RSVP协议结合起来,通过资源预留和agent动态移动的实现可以达到更好地改善QoS的目的。     

热释电系数的测量方法

描述热释电系数的两种测量方法。其一为电荷积分法，测试系统简单，测量数据准确，且能满足零电场条件下的测量。其二为动态电流法，采用调制热源技术，研究在特定温度条件下热释电材料的动态热释电响应。     

黑钨矿细泥浮选时有机螯合剂的活化作用

黑钨矿细泥的有效浮选仍是有待解决的选矿难题。本文试图采用有机螯合剂作活化剂，以实现黑钨细泥浮选药剂低耗高效的目的。     

叠后高分辨率资料处理方法及应用效果

高分辨率勘探是一项系统工程，它由多个环节组成。甚至叠后高发辨率资料处理也是由多个环节组成。本文介绍的叠后高分辨率资料处理流程主要包括Ｌｐ模自适应预测统计反褶积，高频成分补偿，振幅补偿及有色成分校正。文中还就处理流程中各种方法的合理组合，各种方法自身参数的合理选取作了试验和探讨，最后给出了处理实例。