金属包覆平板波导模式特性的有限元法分析

采用有限元法（FEM）分析了具有复数折射率的金属包覆介质波导的模折射率与模场分布情况。计算了具有损耗层的6层介质平板波导模折射率，并与解析解比较，二者有较好的一致性；分析了金属包覆3层平板波导中TM模折射率与波导芯厚度的变化关系，计算了金属包覆5层平板波导中TM模折秧经与金属层厚度的变化关系，并结合对模场分布的分析对模式进行了定性判断，给出了其模式演变过程。     

蜂窝移动通信系统核心网络的演进与全IP核心网络

分析了现有移动通信网络存在的问题，阐述了第2代移动通信核心网向第3代移动通信核心网演进的必然性：讨论了第2代移动通信核心网向第3代移动通信核心网演进所采用的演进策略，介绍了两种可供选择的全IP核心网络的参考结构。     

油田采出水的高温水解-好氧处理工艺研究

根据油田采出水的水质特征，采用厌氧(水解)-好氧(接触氧化)处理工艺。实验表明，虽然油田采出水的BOD5／CODCr，较低，属于难生物降解废水，但是当温度为50～60℃时，选择厌氧停留时间为6h，好氧停留时间为3．5h，气水比为10～20，可使其出水的CODCr稳定在120mg／L左右。如果排除Cl^-产生的影响，CODCr，约为60～70mg／L，达到GB8978-1996一级排放标准。     

支持向量机在交通量预测中的应用

交通量预测对于区域交通规划有重要意义。提出一种基于支持向量机理论的交通量预测方法。该方法以统计学习理论为基础，通过和BP神经网络进行比较的实验，证明其在交通量预测中的有效性。     

Associative properties of perfluorooctyl end‐functionalized polystyrene–poly(ethylene oxide) diblock copolymers

The synthesis of 2,2,3,3‐tetrahydro‐perfluoroundecanoyl end‐functionalized polystyrene–poly(ethylene oxide) block (PS‐block‐PEO‐R_F) copolymers and their matching PS‐block‐PEO diblock copolymers was carried out by sequential anionic polymerization. Viscometry and ¹⁹F NMR studies show that the PS‐block‐PEO copolymers, in contrast to their matching PS‐block‐PEO‐R_F copolymers, exhibit a micellar rather than the associative behavior seen for the latter. However, the presence of an excess of fluorinated acid, used for end‐functionalization, produces a reduction of the associative behavior above the overlap concentration, with the fluorinated acid acting like a surfactant. A competition may also occur between PS—and R_F—mediated micellization. Copyright © 2004 Society of Chemical Industry     

Prediction of spectral reflectance factor distribution of automotive paint finishes

It is necessary to determine the accurate reflectance of painted surfaces for the review of paint finishes by computer graphics (CG) before actual painting of the exterior color of automobiles, and for quality control during production and inspection processes. We have optimized a method for measuring reflectance by using a statistical technique. We have found that the reflectance of a painted surface is best measured at an incident angle of 60° and at five aspecular angles of 10°, 18°, 28°, 40°, and 90°. Our method makes it possible to accurately reproduce reflection characteristics of paint finishes containing special flake pigments, such as pearl mica. Also it was proved that our method can apply not only to solid and metallic coatings but to all painted surfaces. © 2005 Wiley Periodicals, Inc. Col Res Appl, 30, 275–282, 2005; Published online in Wiley InterScience (www.interscience.wiley.com). DOI 10.1002/col.20125     

Copper(II) removal from aqueous solutions by fly ash

The removal of Cu(II) by adsorption on fly ash has been found to be concentration, pH and temperature dependent. The kinetics of adsorption indicates the process to be diffusion controlled. The Langmuir constants have been calculated at different temperatures, and the adsorption has been found to be endothermic (ΔH = 15.652 kcal mol^?1). The maximum removal is observed at pH 8.0, and variation in adsorption with pH has been explained on the basis of surface ionisation and complexation.     

量子阱红外探测器能带结构的计算

利用电子波在阱与垒的界面上的反射及干涉效应，计算了量子阱红外探测器(QWIP)的能带结构，并对其适用性进行了分析和讨论。通过与K-P模型比较发现，本方法对计算较宽势阱(阱宽大于4nm)的量子阱结构的电子态适合。在垒宽和阱宽不变条件下，用两种方法计算得到的AlGaAs／GaAs量子阱材料中Al组分x与吸收峰值波长λp的关系曲线基本相同。结果说明，在较宽的范围内，本方法对QWIP能带结构的计算是适用且简便的。     

星间激光通信技术进展与趋势

较详细地评述了目前国外卫星间光通信技术研究的现状．根据关键单元技术的进展情况，总结了未来星间光通信系统的发展趋势。     

一种新的HEMT小信号模型参数提取方法

介绍了一种高电子迁移率晶体管(HEMT)的小信号参数提取方法——综合多偏置点优化参数提取法。该文首先推导并提出了器件的模型、确定外部参数和内部参数，其次介绍了多偏置点优化算法。最后，以PHEMT器件为例进行鲁棒性和精确性测试，实验采用一系列随机起始值，结果表明，提取的参数值与经验值相差小于1％。