国有公路运输企业改革创效的现实选择

通过对公路运输企业经营实践的考察 ,介绍了国有公路运输企业改革创效的一些现实选择 ,以供运输公司经营借鉴 ,从而摆脱困境 ,取得良好业绩     

Formation and electronic structure of interface

In the present work the formation of the interface between polycrystalline silver and thin films of titanium oxide was studied with photoelectron spectroscopy (XPS, UPS) and time-of-flight secondary ion mass spectrometry (TOF-SIMS). Titanium oxide was deposited stepwise on 100 nm thick silver films by reactive magnetron sputtering allowing to study the evolution of the interface formation process. The process involves two steps: formation of thin layer of silver oxide and subsequent growth of the TiO₂ film. For better understanding of the silver oxidation process, pure silver films were exposed to a low temperature Ar/O plasma for different time intervals providing a possibility to investigate early stages of the oxide film growth.     

Impact of the addition of an enzyme pool on an activated sludge system treating dairy wastewater under fat shock loads

BACKGROUND: The application of lipase‐rich enzyme pools (such as the crude solid enzymatic preparation (SEP) obtained from Penicillium restrictum solid‐state fermentation of agro‐industrial wastes) to activated sludge systems may be an effective strategy for preventing various operational problems. The continuous addition of SEP to the treatment system can become cost‐prohibitive when in situ production and/or storage are factored in. The application of SEP to high‐fat wastewater treatment would only be justified as an emergency measure, such as a sudden increase in the fat content of the bioreactor influent. Therefore, the primary objective of this work was to investigate the efficiency of a crude SEP during fat shock loads, simulated through the periodic addition of dairy industry waste containing high fat concentrations to the feed stock of an activated sludge system, operated in continuous mode. RESULTS: The test bioreactor exhibited a higher average chemical oxygen demand (COD) removal efficiency than the control bioreactor (83% for control and 90% for test) and the fat accumulation in the biological flocs of the test bioreactor was 3.2 times lower than that in the control bioreactor. Turbidity was also lower in the effluent of the test bioreactor (123 and 66 FTU in control and test, respectively) and it had a shorter recovery time between shock loads, especially when the interval between loads was shorter than one month (biweekly and weekly shock loads). CONCLUSION: The addition of SEP during fat overloads in the reactor feed maintained efficient COD removal in the test bioreactor for 270 days without any operational problems. Copyright © 2008 Society of Chemical Industry     

基于复数主成分分析的磁共振波谱信号衰减系数的自动校正

衰减系数的校正是磁共振波谱信号处理和分析过程中的一个关键难题。本文基于复数主成分分析，提出了一种自动的磁共振波谱衰减系数的校正方法，较成功地解决了这个难点问题。文中的模拟数据及其实现结果充分验证了该方法的有效性。     

欠驱动系统Pendubot的模糊控制策略

本文针对欠驱动Pendubot机器人系统，提出一种简单可靠的摇起及平衡控制策略。通过利用模糊控制及全状态反馈控制技术来分别设计摇起控制器及平衡控制器，其中模糊摇起控制器的设计使得系统的摇起可靠性得到大大的加强，并缩短了响应时间，两个控制器的转换通过转换装置实现。最后的仿真结果验证了算法的有效性。     

Connecting the second exhaust-heat boiler to the operating first one under the conditions of flow circuits of combined-cycle plants with two gas-turbine units and one steam turbine

Problems arising with connecting the second exhaust-heat boiler to the first exhaust-heat boiler under load in the case of flow circuits of combined-cycle plants of type PGU-450 are considered. Similar problems exist for two-boiler single-turbine units of type PGU-325 and for two-boiler single-turbine units of traditional steampower plants with an output of 200–300 MW upon connection of the second furnace of a two-furnace boiler to the operating first furnace. Analysis of the temperature-induced stressed state and of the cyclic strength of thick-walled elements of the steam-water conduit of PGU-450 and of two-furnace boilers of two-boiler single-turbine units with an output of 200–300 MW (the check valve, the inlet header of the water economizer) is used for determining the steam temperature differences in the high-pressure conduits to the steam turbine and the order of connection of the second exhaust-heat boiler to the operating fist one. Modes of enabling a two-boiler single-turbine unit of a combined-cycle plant, which are most “rigid” from the standpoint of thermal strength, are determined. __________ Translated from élektricheskie Stantsii, No. 2, February 2006, pp. 11–17.     

铀表面初始氧化行为的电子能量损失谱研究

利用俄歇电子能谱仪获取了表面清洁的铀及其在氧化过程中的电子能量损失谱(EELS)，研究这些电子能量损失谱线显示：清洁表面铀的等离子损失的实验值与理论值较为符合；随着氧化程度的加剧，体等离子体(BP)、表面等离子体(SP)以及价带间跃迁所造成的电子能量损失峰发生了明显的连续偏移和强度的变化，表明室温下清洁表面铀暴露微量纯氧后，在铀表面上发生了U→UO→UO2初始氧化过程。同时，又采用了俄歇电子能谱(AES)和X射线光电子谱(XPS)对照分析了铀的初始氧化过程。     

A novel method for determination of polyester end-groups by NMR spectroscopy

An efficient, convenient and quantitative method for characterising polyester end-groups is described. We have found that trichloroacetyl isocyanate (TAI) reacts rapidly and quantitatively with both carboxyl [C(O)OH] and hydroxyl (OH) chain ends to form derivatives that can be readily determined by ¹H NMR spectroscopy. The TAI capped end-groups give rise to characteristic imidic NH resonances in a normally clear region of the ¹H NMR spectrum [δ∼10-11.5 for C(O)-O-C(O)-NH-C(O)CCl₃ from C(O)OH, δ∼8-9 for O-C(O)-NH-C(O)CCl₃ from OH]. The method has been successfully applied to quantitative determination of the end-groups of a wide variety of oligomeric polyesters. It has also been applied to higher molecular weight polyesters including commercial, bottle grade, poly(ethylene terephthalate) (PET) and PET based copolyesters (e.g. PETG).     

新型超微晶软磁合金FePCCuMoSi微观结构缺陷的正电子湮没研究

用正电子湮没方法研究了新型超微晶软磁合金的微观结构缺陷，样品选用的是在不同温度下退火的Ｆｅ８１Ｐ１２Ｃ３Ｃｕ１Ｍｏ０．５Ｓｉ２．５合金，结果表明，合金的微观结构构陷大小，密度随退火温度有规律地变化，这种现象可能与非晶的晶化过程有关。