自旋为j的粒子在旋转磁砀中的几何相位

用相干态的方法得到旋转磁场中自旋为j的粒子的态矢量的严格表达式，由此可计算相干态和叠加相干态的Abaronov－Anandan相位（AA相让）．并具有清楚的物理图象．     

简并量子拍频三能级系统中的光场压缩效应

本文讨论了V-型简并量子拍频三能级原子与单模相干辐射场相互作用时的动力学行为，并研究了光场的压缩效应。     

An equation of state for 1,1-difluroethane (HFC 152a)

An equation of state for 1,1-difluoroethane (HFC 152a, CH₃CHF₂) has been developed on the basis of reliable experimental data including PVT, liquid C_p, and saturated-liquid-density data measured by our group. It is a non-dimensionalized virial equation whose functional form is the same as that originally developed for 1,1,1,2-tetrafluoroethane (HFC 134a) in our group. The effective range is for pressures up to 15 MPa, temperatures from 230 to 450 K, and densities to 1000 kg m⁻³. The equation represents reliable PVT measurements within ± 1% in pressure for the superheated vapour and supercritical fluid, while within ±0.5% in density for the compressed liquid. In addition, it should be noted that the equation represents the other essential thermodynamic properties including vapour pressures, saturated-liquid/ vapour densities, isobaric/isochoric specific heats and sound velocity in both the liquid and gaseous phase of HFC 152a.     

Growth of Fe on Si (100) at room temperature and formation of iron silicide

Low-energy electron diffraction (LEED), Auger electron spectroscopy and X-ray photoelectron spectroscopy (XPS) investigations of both the growth of an iron film on silicon (100) at room temperature and the subsequent formation of iron silicide are the subjects of this paper. An in-situ cleaned silicon (100) wafer without carbon or oxygen contamination exhibiting the known 2 × 1 reconstruction in the LEED pattern served as the substrate. Iron was deposited on this reconstructed surface at 300 K. The comparison of theoretical calculations based on three growth mechanisms with XPS data obtained with take-off angles of 0° and 50° clearly demonstrates a layer-by-layer growth of the iron film on silicon (100). At 300 K no formation of iron silicide was observed, although an interaction between iron and silicon could be detected at the interface. The formation of iron silicide was observed at annealing temperatures of 630–730 K. Quantitative XPS analysis yields the presence of FeSi₂, when the thickness is large enough. Neither the iron film on silicon nor the silicide shows any LEED pattern.     

Reaction steady states and stationary states in modelling semi-batch enzyme hydrolysis

Dimensionless material balance equations describing an uninhibited enzyme hydrolysis process in a semi-batch reactor (i.e. fed-batch reactor) are formulated; numerical solution of these equations provided concentration profiles of the enzyme-substrate complex by using published kinetic parameters. The unrestricted values obtained are compared with estimates based separately on the reaction steady state and stationary state assumptions. Results are discussed in terms of the enzyme/substrate inventory used and it is found that the reaction steady state is a satisfactory approximation only when this ratio is sufficiently small. The stationary state may be a better approximation at other values, particularly when enzyme is added to substrate or when an empty tank is being filled. Reaction yields from semi-batch and batch operations are compared. Processing takes longer in the semi-batch operations and complete conversions are only practical in this mode when enzyme is added to substrate.     

Impact of uncertainties on estimations of heat pump cycle performance

Sensitivity analysis is used to show how uncertainties in basic factors, such as heat transfer, pressure drop, compressor efficiency, and thermophysical properties, influence the result of heat pump cycle performance estimations. By comparing the results of this analysis with uncertainty levels of estimations and experimental determinations, it is established to what extent improvements in accuracy are needed. The investigation was carried out for several different applications and, as working fluids, both pure substances and non-azeotropic mixtures were examined. It was found that evaporation heat transfer and compressor efficiency are two areas where improvements are needed. It is also shown that estimates using very accurate, substance-specific, equations of state differ from those using more general types by up to 1 % for COP and 2% for capacity.     

多级脉冲深穿透射孔技术

目前国内较先进的射孔工艺是增效射孔和三相流射孔,这2种射孔工艺均存在射孔深度和造缝深度浅的问题,尤其是对低渗油藏和纵向渗透率远大于横向渗透率的油藏,此造缝深度并不能满足油田生产的需要.介绍了一种新型的射孔技术,它是一种能进行深度射孔造缝的多级射孔技术,利用三级推进剂燃爆时产生峰值不连续的高温、高压气流,形成多级脉冲,多次冲击射孔孔眼前沿的裂缝,使其有效延伸至地层深处,从而较单独的射孔更能有效地增加油气产量.通过地面水泥靶的试验,证明了该射孔器的延缝功能和安全性;通过塘32等井的现场试验,证明该射孔技术对污染地层解堵有显著效果,可明显地降低地层破裂压力.     

自升式平台深水化改造的新模式及其可行性分析

针对我国现有自升式平台存在的不能满足深水域勘探开发的要求以及造价过高等问题,提出一种自升式平台深水化改造新模式——分体坐底自升式平台,在基本不改变原有平台结构的基础上,通过增加可沉浮平台下体,使作业水深增加50m以上,而造价比同工作水深的常规自升式平台低得多。文章介绍了该分体坐底自升式平台的结构方案、作业工况及操作程序,分析了该平台的技术可行性和经济可行性,并提出了深入研究和具体实施需要解决的问题。     

In-situ ESR spectroelectrochemical studies of overoxidation behaviour of poly(3,4-butylenedioxythiophene)

The behaviour of poly(3,4-butylenedioxythiophene) (PBuDOT), a relative of poly(3,4-ethylenedioxythipohnene) PEDOT within the poly(3,4-alkylenedioxythiophene) family, has been investigated at potentials above its electrochemical stability threshold using in situ ESR spectroelectrochemistry. The aim was to investigate the effect of electrochemical overoxidation on the charge carrying species, namely polarons, normally generated and annihilated during reversible redox doping and dedoping reactions, by determining the potential dependencies of spectroscopic parameters of the ESR spectra of the polymer over a selected potential range. Specific features of the trends of these dependencies allowed also for an evaluation of presence of the second type of charge carrying species—diamagnetic bipolarons and the effects of their interactions with polarons at different potentials. Around 1.5 V, where the boundary of electrochemical stability of the polymer lies, sharp drop of the concentration of paramagnetic centres has been observed together with a transitory narrowing of the ESR line. These changes were found to be irreversible as evidenced by the course of subsequent reduction half-cycle, which differed from the one for a not overoxidised polymer, observed in previous studies. Aided by the results of electrochemical studies it was concluded that the overoxidation process leads to a degradation of the polymer most probably due decrease of the conjugation length of the main chain π-bond through cross-linking or addition reactions. While the electrochemical results pointed to a non-complete degradation of the polymer, the specific parameters of the ESR line in the reduction half-cycle indicate that the remaining spins are confined to isolated segments of a partially degraded polymer where their behaviour resembles oligomer-like radicals.