糖厂现用连续离心机的研究及生产实践

在各糖厂现用连续离心机原有生产实践基础上，对其机械吸震、加温、布温、机索结构、物料密封、机座等部件做了进一步改进，并取得可观的实效。     

Electrical/electronic effects of titanium and iron impurities in EFG and FZ solar cell silicon: SPV/EBIC analysis

In this paper results on surface photovoltage (SPV) and electron beam induced conductivity (EBIC) studies of edge-defined film-fed growth (EFG) and floating zone (FZ) silicon solar cell materials (both p-type) are presented. A systematic comparison based on minority carrier diffusion length and carrier recombination is made between: (i) samples contaminated with Ti and/or Fe, (ii) samples gettered by phosphorous diffusion, and (iii) as-received samples. Deep level transient spectroscopy (DLTS) measurements, together with the iron-boron (FeB) pairing kinetics [1] have successfully been used to detect the presence of Fe in the samples. Even though this process is effective in revealing Fe impurities in p-type FZ silicon it is evidently not suitable for Fe identification in p-type EFG silicon. Ti, like Fe, is found to be a prominent lifetime-limiting metallic impurity in both EFG and FZ silicon. Phosphorous diffusion is proven to be an effective external gettering technique for fast-diffusing impurities such as Fe, but not for Ti.     

掺钛蓝宝石激光晶体中夹杂物的分析

本文用大视场光学显微镜、电子探针观察和分析了掺钛蓝宝石激光晶体中夹杂物的形状、尺寸大小及元素组成，并提出消除和减少这些夹杂物的方法．     

以YAG为添加剂的气压烧结氮化硅

本文以添加ＹＡＧ的反应烧结氮化硅（ＲＢＳＮ）为前驱体，采用气氛加压烧结的工艺，在０．５～９．０ＭＰａ氮气压力范围，研究了不同氮压对烧结体的密度、相组成、强度和显微结构的影响及其相互间的关系。研究表明，通过改变氮气压力能有效地调控材料的显微结构，材料的性能又受控于显微结构的变化。     

氧化铝/锌合金复合材料界面的SEM观察

利用挤压铸造制备氧化铝／锌合金复合材料，在扫描电镜（ＳＥＭ）上观察复合材料的界面。结果表明，在复合材料中纤维与基体间存在致密界面层，合金元素通过适当的化学反应可改善纤维与基体间的结合；在凝固过程中，纤维／基体界面上的硅在共晶体的共生生长过程中起了领先相作用，导致复合材料的共晶转变是由铝硅共晶转变和锌铝共晶转变两者组成。     

开关DC—DC变换器并联运行问题的研究

开关直流电源并联运行在许多场合应用。每一路电源输出阻抗的不一致性使每一路输出电流难以均衡，影响了系统的可靠性。本文提出了一种双回路ＤＣ—ＤＣ变换器的控制方案。由于采用电压环（外环）和电流环（内环）两环结构的双回路控制模式，变换器输出电流得到了有效控制，便于多个ＤＣ—ＤＣ变换器输出直接并联，从而实现了模块化，具有一定的实用性     

Electrochemical Aspects of Electroosmotic Dewatering of Clay Suspensions

An attempt is made to elucidate the electrochemical aspects of the electroosmotic dewatering (EOD) of clays as reported in some recent work, especially that on interrupted DC power electroosmotic dewatering published by Rabie, Mujumdar and Weber (2). These authors showed that the dewatering by EOD stops after the DC power has been on for several minutes or hours; on interruption of their power and on short-circuiting of the electrodes, conditions can be created again for some further dewatering by DC power EOD. This discovery, of Rabie et al. is interpreted as a fuel cell effect and it is shown that it affords clues to several other electrochemical strategies for the possible enhancement of the efficiency of the EOD by DC power.

Further, the open circuit potentials observed by Rabie et al. (2) on the interruption of DC power are given an electrochemical interpretation which leads to quantitative estimates in agreement with the experimental values.     

油砂地层中子-伽玛能谱Monte-Carlo模拟

本工作应用自行研制开发的中子 伽玛能谱测井的中子 伽玛射线随空间、能量、时间分布的蒙特卡罗模拟软件包计算了裸眼井、井眼里无下井仪器、油饱和砂岩地层、井眼注油条件下沿井轴和井壁的中子 伽玛射线随能量、时间分布及沿井轴和沿井壁的中子 伽玛射线能谱 ,研究了源距对中子 伽玛射线随能量、时间分布以及井轴与井壁中子 伽玛射线能谱的影响。     

特征提取在硅内部微/纳米级体缺陷检测中的应用

提出了一种利用特征提取来对硅中微/纳米级体缺陷的激光散射图样进行分析,以获得缺陷大小信息的分析方法.给出了该方法中第一特征值和第二特征值的定义,指出通过所提出的第一特征值及第二特征值即可迅速地判断出缺陷的大小量级所在.这种分析方法具有分析速度快,在体缺陷小于1μm时分辨率高,且可使系统实现自动化等优点.     

汽车用焊接钢管的发展

介绍了汽车用焊接钢和产品品种，国内皮类管的生产现状及市场需求状况；国外汽车用焊管最新发展情况。建议国内汽车用焊管应该是定点供料，定点生产，设备配套，完善工艺，建立从炼钢，轧制到制管的质量管理体制。