钛合金的银脆,镉脆敏感性及其控制

利用慢应变速率拉伸技术（ＳＳＲＴ），并结合恒载实验，较全面地研究了Ｔｉ－６Ａｌ－４Ｖ合金的银脆行为、固态与液态镉脆行为，确定了应变速率、接触条件、热处理制度、试样取向、温度等因素对Ｔｉ－６Ａｌ－４Ｖ合金银脆与镉脆敏感性的影响，探讨了Ｎｉ阻挡层对控制Ｔｉ－６Ａｌ－４Ｖ合金和ＴＣ１１合金银脆开裂的作用。     

二极管端泵浦连续激光器激活介质长度与透过率的优化

从准三能级系统的速率方程出发,推导出了二极管(LD)端泵浦连续工作端面泵浦固体激光器的速率方程,提出了计算连续LD端面泵浦激光器输出功率的方法,并表示成激活介质长度和透过率的函数,由此得到在泵浦功率一定情况时的优化设计步骤。数值计算结果与我们的实验结果和文献[3],[4]的实验数据符合甚好。     

积极开展泵站技术改造

为探索山丘地区中小型泵站技术改造的经验，选定南康县四个小型泵站作为泵站改造的试点站，进行现场测试，根据测试成果，分析各站存在的问题及效率偏低的原因，并拟定各站技术改造的措施，经实施后取得了较好的效果，本文就南康县泵站改造的实际效果阐明泵站改造的必要性及其改造过程中值得注意的问题。     

Analysis and Optimization Laminar Viscous Flow Through a Channel

Optimizing of laminar viscous flow through a pipe by two dimensionless values is investigated analytically. Dimensionless entropy generation and pumping power to heat transfer rate ratio are used as basis for constant viscous and the temperature dependence on the viscosity. For this matter we calculate entropy generation and pumping power for a fully developed in a pipe subjected to constant wall temperature for either constant viscosity and the variable viscosity. The variation entropy generation increase along the pipe length for viscous fluid is drawn, either the variation summation dimensionless entropy generation and the pumping power to heat transfer rate ratio are varying the fluid inlet temperature for fixed pipe length and are varying pipe length for fixed fluid inlet temperature are drawn. For low heat transfer conditions the entropy generation due to viscosity friction becomes dominant and the dependence of viscosity with the temperature becomes essentially important to be considered.     

辽宁省节水工作存在问题及对策

辽宁省是水资源严重短缺的省份之一，水资源不足已成为制约全省经济社会可持续发展的瓶颈。通过对全省大型取用水户的调查分析，找出了辽宁省节水工作中存在的问题，提出了节约用水工作的对策和建议。     

底水油藏射孔优化设计

为了优化底水油藏的生产参数，研究了不同产量时射孔长度的优化方法。采用球面流和径向流相结合的模型推导了临界产量和无水采油量的计算公式，分别以临界产量和无水采油量为标准，对胜利油田桩西区块底水油藏上6口油井的射孔长度进行了优化设计，优化结果表明，对于底水油藏应首先按照临界产量对射孔长度进行优化设计，如果得到的最大临界产量不符合实际生产的要求，就应按照无水采油量进行射孔优化设计。研究表明，当油井产量超过临界产量后，以临界产量为标准得到的优化射孔长度会减小油井的无水采油量。     

Split and collectorless flotation to medium coking coal fines for multi-product zero waste concept

The medium coking coal fines of − 0.5 mm from Jharia coal field were taken for this investigation. The release analysis of the composite coal reveals that yield is very low at 10.0% ash, about 25% at 14% ash and 50% at 17% ash level. The low yield is caused by the presence of high ash finer fraction. The size-wise ash analysis of − 0.5 mm coal indicated that − 0.5 + 0.15 mm fraction contains less ash than − 0.15 mm fraction. Thus, the composite feed was split into − 0.5 + 0.15 mm and − 0.15 mm fractions and subjected to flotation separately. The low ash bearing fraction (− 0.5 + 0.15 mm) was subjected to two stages collectorless flotation to achieve the concentrate with 10% ash. The cleaner concentrate (18.9%) with 10% ash was recovered which has an application in metallurgical industries. The concentrate of 30.2% yield with 12.5% ash could be achieved in one stage collectorless flotation which is suitable for use in coke making as sweetener. As the − 0.15 mm fraction contains relatively high ash, collector aided flotation using sodium silicate was performed to get a concentrate of 23.6% yield with about 17% ash. The blending of this product with cleaner tail obtained from − 0.5 + 0.15 mm produces about 35.0% yield with 17% ash and that can be utilized for coke making. The reject from the two fractions can be used for conventional thermal power plant or cement industries using a 23.5% ash after one stage collector aided flotation and the final tailings produced content ash of 61.6% can be used for fluidization combustion bed (FBC). This eventually leads to complete utilization of coal.     

运用韦柏函数分析发动机燃烧过程时若干问题的探讨

探讨了韦柏函数的内涵及其在实际应用中的若干问题；应用双韦柏函数对涡流室式柴油机的燃烧过程进行分析，加深了对分隔室式发动机燃烧过程的认识．     

光纤数字环路载波系统的发展

ＯＤＬＣ是当今用户接入网的新型设备，它一方面可取代端局，解决通信线路紧张和远距离大容量放号问题，另一方面也可满足日益增多的增值业务的需求。本文ＯＤＬＣ技术的基本原理，结合目前国内外常见ＯＤＬＣ系统，总结和对比了其基本特点，优势，并指明ＯＤＬＣ的技术发展方向和中国应用的前景。     

采用信息融合技术的IR／MMW复合导引头的目标跟踪

从误差测量环节入手，基于IR／MMW双模结构，采用信息融合处理技术提高其估计跟踪精度，最终达到降低制导误差，提高武器性能的目的，仿真结果验证了该方法的有效性。