Inorganic–organic hybrid materials with zirconium oxoclusters as protective coatings on aluminium alloys

Inorganic–organic hybrid materials are attracting a strong scientific interest mainly for their outstanding inherent mechanical and thermal properties, which can be traced back to the intimate coupling of both inorganic and organic components. By carefully choosing the experimental parameters used for their synthesis, chemically and thermally stable acrylate-based hybrid material embedding the zirconium oxocluster Zr₄O₄(OMc)₁₂, where OMcCH₂C(CH₃)C(O)O, can be deposited as UV-cured films on aluminium alloys.

In particular, the molar ratios between the oxocluster and the monomer, the polymerisation time, the amount of photo-initiator and the deposition conditions, by using an home-made spray-coating equipment, were optimised in order to obtain the best performing layers in terms of transparency and hardness to coat aluminium alloy (AA1050, AA6060 and AA2024) sheets. Furthermore, it was also evaluated whether the hybrid coatings behave as barrier to corrosion.

Several coated samples were prepared and characterised. Environmental scanning electronic microscopy (ESEM) and scratch test were used to investigate the morphology of the films and to evaluate their scratch resistance, respectively. Electrochemical impedance spectroscopy (EIS) was performed in order to evaluate if the coatings actually protect the metallic substrate from corrosion.

In order to measure shear storage modulus (G′) and loss modulus (G″) of the materials used for coatings, bulk samples were also obtained by UV-curing of the precursors solution. Dynamical mechanical thermal analysis (DMTA) was performed in shear mode on cured disks of both the hybrid materials and pristine polymer for comparison. The values of T_g were read off as the temperatures of peak of loss modulus. The length and mass of all the samples were measured before and after the DMTA analysis, so that the shrinkage of the materials in that temperature range was exactly evaluated.     

IRIS/AP型电感耦合等离子体光谱仪激发光源常见故障分析

本文介绍IRIS/AP型ICP的激发光源(炬管),并较为全面地阐述和分析其不能正常激发点燃的常见故障及其原因。     

用土壤含水层处理系统去除水库微污染有机物的试验研究

本文针对当前中国饮用水源污染以微污染为主的特点，以北京三家店水库原水和永定河河道砂为研究对象，设计了用于表征土壤含水层处理系统的一维土柱，进行污水净化效果的试验研究。结果表明，土壤含水层处理系统对三家店水库微污染水中的有机物有一定的去除效果，在0．12m／d的水力负荷条件下，对CODMo去除率虽然仅为15％，但是出水达到了地表水Ⅱ类水质标准；对BOD5的去除率达到了55％，可以被有效地去除。渗透速率相同时，水力负荷周期对去除效果的影响不明显，但在保证一定水力负荷的情况下，可适当延长落干期，恢复土壤的渗透能力，达到较好的处理效果。同时，土壤含水层处理系统的净化能力主要发生在土层50cm以内。     

有机羧酸钠盐对PET结晶和熔融行为的影响

采用差示扫描量热仪研究了5种具有不同取代基的苯甲酸钠盐作为结晶成核剂对聚对苯二甲酸乙二醇酯（HET）结晶和熔融行为的影响，并同滑石粉进行了对比。结果表明，成核剂的加入能明显改变PET的结晶和熔融行为。苯甲酸钠、对苯二甲酸甲酯单羧酸钠和对羟基苯甲酸钠提高既汀的熔融结晶温度（Tc）分别达22．93、21．7和19．37℃，但使PET降解严重；对苯酚钠甲酸钠能够提高Tc达17．75℃且对PET相对分子质量影响很小；对苯二甲酸二钠成核作用最差。低于滑石粉。此外，成核剂的成核能力越强，PET双熔融峰中的低温峰顶温度就越高。     

地球化学录井技术的发展和应用

简要介绍了国内地化录井技术的发展历程，分析了该技术的特点及在油气勘探开发应用中取得的成效。认为中国地化录井技术在引进、消化、吸收的基础上，扩展了该技术的应用领域和范围，目前该专业的整体技术水平处于国际领先地位。在以统计资料及应用实例报道该技术的应用成果及独特技术优势的同时，也分析了存在的问题，指出了解决问题的主要途径。     

A Nonvolatile Organic Memory Device Using ITO Surfaces Modified by Ag‐Nanodots

We report on a single‐layer organic memory device made of poly(N‐vinylcarbazole) embedded between an Al electrode and ITO modified with Ag nanodots (Ag‐NDs). Devices exhibit high ON/OFF switching ratios of 10⁴. This level of performance could be achieved by modifying the ITO electrodes with some Ag‐NDs that act as trapping sites, reducing the current in the OFF state. Temperature dependence of the electrical characteristics suggest that the current of the low‐resistance state can be attributed to Schottky charge tunnelling through low‐resistance pathways of Al particles in the polymer layer and that the high‐resistance state can be controlled by charge trapping by the Al particles and Ag‐NDs.     

Performance evaluation of a water/silicone oil two‐phase partitioning bioreactor using Rhodococcus erythropolis T902.1 to remove volatile organic compounds from gaseous effluents

BACKGROUND: In the framework of biological processes used for waste gas treatment, the impact of the inoculum size on the start‐up performance needs to be better evaluated. Moreover, only a few studies have investigated the behaviour of elimination capacity and biomass viability in a two‐phase partitioning bioreactor (TPPB) used for waste gas treatment. Lastly, the impact of ethanol as a co‐substrate remains misunderstood. RESULTS: Firstly, no benefit of inoculation with a high cellular density (>1.5 g L^?1) was observed in terms of start‐up performance. Secondly, the TPPB was monitored for 38 days to characterise its behaviour under several operational conditions. The removal efficiency remained above 63% for an inlet concentration of 7 g isopropylbenzene (IPB) m^?3 and at some time points reached 92% during an intermittent loading phase (10 h day^?1), corresponding to a mean elimination capacity of 4 × 10^?3 g L^?1 min^?1 (240 g m^?3 h^?1) for a mean IPB inlet load of 6.19 × 10^?3 g L^?1 min^?1 (390 g m^?3 h^?1). Under continuous IPB loading, the performance of the TPPB declined, but the period of biomass acclimatisation to this operational condition was shorter than 5 days. The biomass grew to approximately 10 g L^?1 but the cellular viability changed greatly during the experiment, suggesting an endorespiration phenomenon in the bioreactor. It was also shown that simultaneous degradation of IPB and ethanol occurred, suggesting that ethanol improves the biodegradation process without causing oxygen depletion. CONCLUSION: A water/silicone oil TPPB with ethanol as co‐substrate allowed the removal of a high inlet load of IPB during an experiment lasting 38 days. Copyright © 2008 Society of Chemical Industry     

A flexible architecture for distributed knowledge based systems with nomadic access through handheld devices

Nowadays any Knowledge Based System (KBS) realization needs of intercommunication among distributed components and to use non-connected and distributed data sources, which poses several challenges to the classical Artificial Intelligence field of KBS.

The multiagent paradigm and the use of ontologies are considered to be suitable tools to face the problems of designing and developing today KBS. On the other hand, using such networked KBS through handheld devices makes more efficient exploitation and interaction with the system.

This paper presents an open and flexible architecture for a distributed KBS and an application of it to construct a system for Psychological Disorders consulting, the so called PDA² (Psychological Disorder Assistant through PDA). We analyze the main features of the architecture as well as the agent tools we may use to construct it. Additionally, we present a support ontology for Psychological Disorders.