天津独流减河工程监控系统现地通信单元设计

提出一种配电网电容电流测量的新方法，在零序电压互感器的开口三角侧串联一个可调电感，通过注入一个变频恒流信号寻找配电网的谐振频率，改变可调电感的数值后寻找另一谐振频率，联立2个谐振方程求解电容电流，该方法消除了电压互感器漏抗对测量的影响。开发了配电网电容电流测量仪，经模拟试验和现场测试表明，该方法具有安全、快捷、准确等特点，适用于中性点不接地或经随调式消弧线圈接地配电网。     

Electrochemical mass transfer between an impinging jet and a rotating disk in a confined system

This paper presents the mass transfer results from an impinging liquid jet to a rotating disk. The mass transfer coefficients were measured using the electrochemical limiting diffusion current technique (ELDCT). Rotational Reynolds number (Re_r) in the range of 3.4 × 10⁴–1.2 × 10⁵, jet Reynolds number (Re_j) 1.7 × 10⁴–5.3 × 10⁴ and non-dimensional jet-to-disk spacing (H/d) 2–8 were taken into consideration as parameters. It was found that the jet impingement resulted in a substantial enhancement in the mass transfer compared to the case of the rotating disk without jet.     

光纤复合架空地线雷击断股的分析及试验

介绍了光纤复合架空地线(0PGW)雷击断股的特征，讨论了其原因和机理，并进行了0PGW的雷电冲击电波试验，分析了造成断股的影响因素，提出了防止雷击造成0PGW断股的措施。     

Power sector development in India with CO2 emission targets: Effects of regional grid integration and the role of clean technologies

The power sector in India at present comprises of five separate regional electricity grids having practically no integrated operation in between them. This study analyses the utility planning, environmental and economical effects of integrated power sector development at the national level in which the regional electric grids are developed and operated as one integrated system. It also examines the effects of selected CO₂ emission reduction targets in the power sector and the role of renewable power generation technologies in India. The study shows that the integrated development and operation of the power system at the national level would reduce the total cost including fuel cost by 4912 million $, total capacity addition by 2784 MW, while the emission of CO₂, SO₂ and NO_x would be reduced by 231.6 (1.9%), 0.8 (0.9%), 0.4 (1.2%) million tons, respectively, during the planning horizon. Furthermore, the study shows that the expected unserved energy, one of the indices of generation system reliability, would decrease to 26 GWh under integrated national power system from 5158 GWh. As different levels of CO₂ emission reduction targets were imposed, there is a switching of generation from conventional coal plants to gas fired plants, clean coal technologies and nuclear based plants. As a result the capacity expansion cost has increased. It was found that wind power plant is most attractive and economical in the Indian perspective among the renewable options considered (Solar, wind and biomass). Copyright © 2003 John Wiley & Sons, Ltd.     

Development of catalysts for hydrogen generation from hydride compounds

Catalytic hydrolysis of NaBH₄ and NH₃BH₃ has been studied. It was shown that the nature of the support and the active component of the catalyst affect the H₂ generation rate. Despite similar sizes of rhodium particles formed on the surface of different supports (γ-Al₂O₃, TiO₂, carbon), their reactivity is different. Rh/TiO₂ with low rhodium concentration (1 wt.%) is the most active catalyst both in the hydrolysis of NaBH₄ and NH₃BH₃. The obtained results show that the rhodium chloride interaction with titania determines the reactivity of rhodium particles formed under action of NaBH₄ medium. TEM, DRS UV–vis and XPS were used to characterize the catalysts.     

From Long Infrared to Very Long Infrared Wavelength Focal Plane Arrays Made with HgCdTe n + n ?/ p Ion Implantation Technology

This paper aims at studying the feasibility of very long infrared wavelength (VLWIR) (12–18 μm) focal plane arrays using n-on-p planar ion-implanted technology. To explore and analyze the feasibility of such VLWIR detectors, a set of four Cd _x Hg_1−x Te LPE layers with an 18 μ cutoff at 50 K has been processed at Defir (LETI/LIR–Sofradir joint laboratory), using both our “standard” n-on-p process and our improved low dark current process. Several 320 × 256 arrays, 30-μm pitch, have been hybridized on standard Sofradir readout circuits and tested. Small dimension test arrays characterization is also presented. Measured photonic currents with a 20°C black body suggest an internal quantum efficiency above 50%. Typical I(V) curves and thermal evolution of the saturation current are discussed, showing that standard photodiodes remain diffusion limited at low biases for temperatures down to 30 K. Moreover, the dark current gain brought by the improved process is clearly visible for temperatures higher than 40 K. Noise measurements are also discussed showing that a very large majority of detectors appeared background limited under usual illumination and biases. In our opinion, such results demonstrate the feasibility of high-performance complex focal plane arrays in the VLWIR range at medium term.     

3G系统的安全策略分析

介绍了当前3G系统面临的各种威胁和针对3G的攻击方法,如对非授权数据的非法获取、对数据完整性的攻击和对业务的非法访问攻击等.分析了3G系统的安全体系结构和安全特性的优缺点.     

Effects of low radiation on the power quality of a distributed PV-grid connected system

We have previously investigated effects of radiation levels on power quality of a number PV-grid interactive systems in Thailand, in terms of harmonics and voltage variation at the point of common coupling (PCC). In this paper, we focus on the nature of components of complex power (actual, reactive and apparent power) of inverter output of a PV-grid interactive system due to low radiation, below 400 W/m². The system being investigated has an array of 4.2 kWp and representative of roof top units. It is observed that a PV array supplies increasing real power, in magnitude and as percentage of complex power, at high values of radiation. At low radiation level when the array does not provide enough output power, reactive power is drawn from distribution transformer and fed into an inverter and loads. Based on results from the test site and long term radiation data of Bangkok, we then estimate energy available from low radiation from a hypothetical PV-grid interactive unit in Bangkok of a similar size. It can be seen that for a tropical climate like Thailand a significant amount of energy, 20–30% of radiation energy, is in the form of reactive power. Methods must be devised to capture this low radiation energy and converted into real power form.     

Automating application software generation

Many approaches have been proposed to enhance software productivity and reliability. These approaches typically fall into three categories: the engineering approach, the formal approach and the knowledge-based approach. But the optimal gain in software productivity cannot be obtained if one relies on only one of these approaches. This paper describes the work in knowledge-based software engineering conducted by the authors for the past 10 years. The final goal of the research is to develop a paradigm for software engineering which integrates the three approaches mentioned above. A knowledge-based tool which can support the whole process of software development is provided in this paper.     

Triple tangent flank milling of ruled surfaces

This paper presents a positioning strategy for flank milling ruled surfaces. It is a modification of a positioning method developed by Bedi et al. [Comput Aided Des 35 (2003) 293]. A cylindrical cutting tool is initially positioned tangential to the two boundary curves on a ruled surface. Optimization is used to move these tangential points to different curves on the ruled surface to reduce the error. A second optimization step is used to additionally make the tool tangent to a rule line, further reducing the error and resulting in a tool position, where the tool is positioned tangential to two guiding rails and one rule line. The resulting surface has 88% less under cutting than the method of Bedi et al.