Ozonation of CI Reactive Black 5 using rotating packed bed and stirred tank reactor

This study investigates the ozonation of CI Reactive Black 5 (RB5) by using the rotating packed bed (RPB) and completely stirred tank reactor (CSTR) as ozone contactors. The RPB, which provides high gravitational force by adjusting the rotational speed, was employed as a novel ozone contactor. The same ozone dosage was separately introduced into either the RPB or the CSTR for the investigation, while the experimental solution was continuously circulated within the apparatus consisting of the RPB and CSTR. The decolorization and mineralization efficiencies of RB5 in the course of ozonation are compared for these two methods. Moreover, the dissolved and off‐gas ozone concentrations were simultaneously monitored for the further analysis. As a result, the ozone mass transfer rate per unit volume of the RPB was significantly higher because of its higher mass transfer coefficient and gas–liquid concentration driving force. Furthermore, ozonation kinetics was found to be independent of the gravitational magnitude of an ozone gas–liquid contactor. Therefore, the results suggest employing RPBs as ozone‐contacting devices with the advantage of volume reduction. The experimental results, which can be used for further modeling of the ozonation process in the RPB, also show the requirement of correct design for the RPB. Consequently, the present study is useful for the understanding of practical application of RPBs. Copyright © 2004 Society of Chemical Industry     

使用混合杆柱时抽油泵柱塞的超冲程

任何抽油杆柱在理论上都可能产生超冲程，只是大小不同而已。超冲程的存在，使泵柱塞的有效冲程增大，甚至会大于光杆冲程。首次提出了抽油泵柱塞相对超冲程和绝对超冲程的概念，这将有助于正确认识玻璃钢抽油杆的作用和玻璃钢抽油杆的推广使用。将抽油杆柱简化成上端受光杆的激振位移、下端带有集中质量的弹簧－质量力学模型，建立了抽油杆柱纵向振动的偏微分方程和边界条件，然后用固有函数法求解方程，得出了抽油泵柱塞超冲程的无穷级数解析计算式。     

抓紧有利时机 搞好更新换代

本文简要回顾了１５０发动机发展历史，阐述了世界坦克动力发展现状，列举了几种对１５０ 继续发展的看法，认为从综合约束条件和高紧凑性考虑，仍以保持或适当减少缸径较优．指出当 前是追赶世界先进水平的极好时机，要牢牢把握住这个稍纵即逝的机遇．     

可编程控制器在包装机上的应用

本文介绍了可编程控制器（PLC）在包装机上的应用．介绍了系统的硬件设计与软件开发．     

套管固井质量问题及对策分析

从油田现场反应的情况出发，对调整井固井，尾管固井，大位移井套管固井和其他固井的质量问题进行了分析，针对各种问题产生的原因，提出了相应换解决办法。     

地震数据采集系统中频谱均衡滤波器的理论设计

地层的高频吸收衰减效应是导致地震勘探分辨率不高的主要原因，在高分辨率野外地震数据系统中，频谱均衡滤波器所设置的重要部件。文章以频谱均衡滤波器的原理和地层吸收衰减特性为基础，用计算机模拟的方法研究地层吸收衰减使分辨率降低的程度和频谱均衡滤波器对分辨率的补偿效果，给出了较好的频谱均衡滤波器的设计方案。     

高镁瓷工艺特性研究和应用

本文总结了ＭｇＯ－ＳｉＯ２－Ａｌ２Ｏ３系的高镁瓷配方、增塑及烧成工艺特性的研究过程与应用结果；介绍了适应大生产的高镁瓷制作工艺。     

Nb,Ti微合金钢热变形的动态模拟变形抗力模型

本文报道 Nb,Ti 微合金钢的热变形动态模拟变形抗力模型。在试验中用热加工模拟试验机进行高温压缩试验,其变形温度为1123—1423K,变形速率为0.1—60s~(-1)。结果表明,在峰值以前该钢种的流变应力数学模型为:σ=5.99.ε~(0.167)·(?)~(6.47×10~(-5)·T)·exp(4064/T)。形变激活能(Q)为444 kJ/mol,β系数为0.080。峰值应力(σ_p),临界应变(ε_c)和温度补偿应变速率参数(Z)之间的关系分别为:σ_p=12.56·lnZ-391.8;lnε_c=0.157·lnZ-7.39。     

Electrical characterization of very-narrow-gap bulk HgCdTe single crystals by variable magnetic field hall measurements

Variable-magnetic-field Hall measurements (0 to 1.5 T) are performed on very-narrow-gap bulk-grown Hg_1−xCd_xTe single crystals (0.165 ≤ x ≤ 0.2) at various temperatures (10 to 300K). The electron densities and mobilities are obtained within the one-carrier (electrons) approximation of the reduced-con-ductivity-tensor scheme. The present data together with the selected data set reported by other workers exhibit a pronounced peak when the electron mobility is plotted against the alloy composition x-value which has been predicted to be due to the effective-mass minimum at the bandgap-crossing (E_g ≈ 0). The observed position (x ≈ 0.165), height (≈4 x 10² m²Vs), and width (≈0.01 in x) of the mobility-peak can be explained by a simple simulation involving only ionized-impurity scattering. A lower bound of the effective mass is introduced as a fitting parameter to be consistent with the finiteness of the observed electron mobility and is found to be of the order of 10⁻⁴ of the mass of a free electron.     

Volumetric properties of mixtures of 1,4-dioxane and water at high pressures

Densities of aqueous of 1,4-dioxane have been measured at temperatures from 298 to 348 K and at pressures up to 40 MPa by a vibrating-tube method. Molar volumes obtained with an estimated uncertainty of ±0.2°,% are correlated with pressure by the Tait equation within the experimental uncertainty. Pressure and composition dependences of the excess molar volume, partial molar volume, and isothermal compressibility are determined and they are compared with those of other aqueous solutions.