真空溅射加工用铁氧体粘接件的制备

主要介绍了高温粘接技术在铁氧体环真空溅射加工中的应用,通过对耐高温胶粘剂的优选及工艺实现途径的探索,较好地将多个铁氧体环粘接为一体。并在其外表面溅射镀铜,粘接强度及粘接精度在高温环境下均达到设计要求。     

硫酸钾尾液冷冻回收高硫钾比矿物工艺研究

以硫酸钾尾液为原料,研究低温冷冻回收高硫钾比矿物合理的工艺技术路线,探寻适宜的贮存条件,为加工车间夏季高温生产硫酸钾提供优质高硫钾比原料.在低温下进行冷冻试验,根据冷冻结晶矿物产率及其干基组分确定适宜的冷冻温度为-15～5℃,冷冻制得的结晶矿物硫钾比均在3.0～5.1,符合夏季生产硫酸钾所需原料硫钾比>2.5的要求.高...     

大功率电机启动方式的比较与选择

通过对电机启动过程的分析和启动方式的比较,说明大功率电机的启动应选用降压启动方式。软启动器作为新型的降压启动装置,以其优良的性能和良好的控制方式,将得到广泛的选用。     

超高层综合楼消防自控设计探析

讨论了超高层综合楼消防自控设计的必要性、可能性和具体的设计方法.     

高瓦斯自燃煤层综放工作面瓦斯综合治理

通过对高瓦斯自燃煤层综采放顶煤回采工作面的瓦斯涌出考察,及对瓦斯涌出与风量、高抽巷布置、推进速度、周期来压的关系分析,提出瓦斯综合治理措施,在实践中取得较好成效。     

Study on high rock slop anchoring technique of large rock engineering

Monitoring data from the Three Gorges Project show that the resulted tensile stresses are mainly distributed within the front section of the internal anchoring section which is often measuring 2.5 m in length. The composition of two early strength cement grout mixes marked as R3350 and R7350 was successfully developed to accelerate anchoring facilities installation and to reduce its intervention with the shiplock construction. It was measured that the ground water pH value in the sidewall slopes of the permanent navigation shiplock during the construction period was close to 8. Based on those characteristics it is concluded that the groundwater is weakly corrosive to steel material and will appear as non-corrosive to the steel wire strands embedded in the cement grout set. The advanced model of 3 MN unbonded anchor cables with double anti-corrosion protection （including the corrugated pipe） is developed to meet the needs of stabilizing the high sidewall rock slopes of the permanent navigation shiplock on the Three Gorges Project.     

蛋类膜-壳结构启发制备兼具高灵敏度和宽检测范围的应变传感

为了解决可拉伸应变传感器的灵敏度与检测范围(最大和最小可拉伸性)之间相互制约的问题.受蛋类膜-壳结构的启发,本文提出了一种构筑具有高灵敏度、宽可拉伸应变传感器的新策略,即基于柔性可拉伸的表面接枝聚吡咯膜(s-PPy)(类似于蛋膜)和脆性金膜(类似于蛋壳)制备器件.Au和s-PPy膜在电学和机械性能上产生相互协同作用.A...     

高硫柴油吸附脱硫剂的研究

研究了不同的Cu2+分子筛在常温常压下吸附高硫柴油中的硫化合物。采用水热合成法和离子交换法制备含Cu2+分子筛(CuMCM41和CuZSM5),用于固定床吸附脱硫。其中每克CuMCM41处理5 mL高硫柴油后达到饱和,并且能把含硫量降到300×10-6(质量分数)。吸附剂对硫化物具有很强的选择性,用CuMCM41来吸附模拟柴油,吸附结果表明它对噻吩和苯并噻吩的吸附性比对萘要强。     

Effect of particle size distribution on green properties during high velocity compaction

Iron powders with two different particle size distributions were compacted by high velocity compaction. The influences of particle size distribution and impact velocity on green properties, including green density, springback, tensile strength and bending strength etc., were studied with scanning electron microscopy (SEM) and a computer controlled universal testing machine. The results show that the particle size distribution and the impact velocity strongly affect its properties. Wider size distribution results in green compact with higher density and better strength. Furthermore, springback of compacts is lower produced by the powder with wider size distribution, especially for radial springback. As impact velocity increases, its green density and green strength gradually increases, but the increasing rate of density decreases gradually. No special relation is found between springback and impact velocity. In addition, the axial springback and the bending strength are higher than the radial springback and the tensile strength, respectively.     

高能球磨制备TiB_2/TiC纳米复合粉体

研究了通过高能球磨制备ＴｉＢ２／ＴｉＣ纳米复合粉体的反应过程和机理,对粉体的显微结构进行了表征．实验结果表明,采用金属 Ｔｉ和 Ｂ４Ｃ为原料,在球磨过程中, ＴｉＣ先于 ＴｉＢ２形成．球磨５ｈ后Ｔｉ与Ｂ４Ｃ反应生成ＴｉＢ２和ＴｉＣ,在随后的长时间高能球磨过程中ＴｉＢ２和ＴｉＣ两相保持稳定．球磨 ３０ｈ后,直径约 ８ｎｍ的 ＴｉＣ纳米粒子分布在 １００～２００ ｎｍ的 ＴｉＢ２粒子中,形成均匀分布的纳米ＴｉＢ２／ＴｉＣ复合粉体．