液晶光阀光电导层光吸收系数的研究

用化学气相沉积法制备了液晶光阀中光电导层———非晶硅薄膜,从实验中得出最佳制备工艺的参数取值。给出了用包络线法测量非晶硅薄膜光吸收系数的原理,测量了样品的光吸收系数随波长的变化规律。得到样品在最佳工艺条件下的光吸收系数高于1×103cm-1。     

Thin hard coatings fracture propagation during the impact test

One of the most significant applications of the impact test is to investigate thin hard coatings fatigue properties. Herein the test conditions and duration up to the film damage initiation, are considered in order to determine the critical stresses associated with the coating fatigue strength. Moreover, the subsequent film damage propagation is a significant mechanism as well, since it refers to the ability of the coating to withstand loads after its fatigue damage initiation. In order to describe the film fracture propagation the failed area ratio was introduced and an algorithm to determine this magnitude developed, based on the analysis of imprint scanning electron microscopy graphs. The application of the coating failed area ratio will be demonstrated in various impact test film cases, also with superficial thin layers. The top layers do not affect, in general, the failure initiation of the basic coating. However, according to the obtained results, the superficial films influence the basic coating failure propagation rate during the impact test.     

Theory of Seepage into an Auger Hole in a Confined Aquifer Overlying a Gravel Substratum

An analytical solution is presented to the problem of steady groundwater flow seeping into a pumped cylindrical hole partially penetrating a homogeneous and anisotropic confined aquifer overlying a gravel substratum. Solutions are obtained for two general cases of the problem: (1) when the level of the pumped hole is below the confining layer; (2) when it is above it. The validity of the proposed theory is tested by comparing analytical predictions obtained for a few flow situations with corresponding results obtained by numerical means. The theory presented here can be utilized to convert the rate of rise of water in a pumped auger hole into directional conductivities of soil, in areas where water is found to be in a confined state overlying a gravel substratum. The study shows that the conductivity values calculated by neglecting the confining pressure of an artesian aquifer with a gravel base [i.e., by applying the existing (Boast and Kirkham in 1971), auger hole seepage theory for a phreatic aquifer with a gravel base to confined situations] may result in serious error; hence, the artesian head of an aquifer must be accounted for while computing the conductivity values. Further, it is observed that the area contributing flow to a pumped auger hole/well with a gravel base is mostly restricted to a short radial distance from the center of the hole, particularly for situations where the gravel substratum is located close to the bottom of the hole. This is in contrast to auger hole flow situations overlying an impervious substratum, where the domain contributing flow is mostly spread out to a considerable distance from the center of the hole.     

井巷掘进控制斜形炮孔钻孔精度的试验研究

井巷掘进爆破工程中，工作面按设计要求，布置各种斜形炮孔，利用量角器和垂直尺控制钎杆与工作面夹角，使炮孔钻孔精度与设计炮孔角度基本上符合，在生产中取得了良好的爆破效果．     

流动注射分光光度法测定钴

研究了将ＰＡＮ用于流动注射（ＦＩＡ）分光光度法测定微量钴，在５６０ｎｍ处绘制标准曲线，线性范围为０～４５μｇ／ｍｌ，相关系数０．９９６，方法的相对标准偏差（ＲＳＤ）小于３％，加标回收率为９５％～１０５％，进样频率８０次／ｈ。本法简单快速，用于面粉、分子筛，铝合金测定结果令人满意。     

注聚采出水分离用动态水力旋流器特性研究

原有的地面工艺和设备已不能满足聚合物驱采出水分离的要求。采用自行研制的动态水力旋流器，在增压与不增压两种工艺流程下，分别进行了流量和转数对分离效率的影响、转数与压力降的关系，以及入口压力与处理量的关系等项试验研究。试验结果表明，与静态水力旋流器相比，动态水力旋流器的分离效率明显提高，一般可提高10％左右；压力损失显著降低，约可减少0．1MPa，足见可在低压下工作，易于实现无泵运行；无泵运行明显比有泵增压运行的分离效率高，但处理量会有所降低。将动态水力旋流器应用于聚合物驱产出水的油－水分离处理是完全可行的。     

套管固井质量问题及对策分析

从油田现场反应的情况出发，对调整井固井，尾管固井，大位移井套管固井和其他固井的质量问题进行了分析，针对各种问题产生的原因，提出了相应换解决办法。     

Electrochemical Aspects of Electroosmotic Dewatering of Clay Suspensions

An attempt is made to elucidate the electrochemical aspects of the electroosmotic dewatering (EOD) of clays as reported in some recent work, especially that on interrupted DC power electroosmotic dewatering published by Rabie, Mujumdar and Weber (2). These authors showed that the dewatering by EOD stops after the DC power has been on for several minutes or hours; on interruption of their power and on short-circuiting of the electrodes, conditions can be created again for some further dewatering by DC power EOD. This discovery, of Rabie et al. is interpreted as a fuel cell effect and it is shown that it affords clues to several other electrochemical strategies for the possible enhancement of the efficiency of the EOD by DC power.

Further, the open circuit potentials observed by Rabie et al. (2) on the interruption of DC power are given an electrochemical interpretation which leads to quantitative estimates in agreement with the experimental values.     

一种主机与网络相结合的漏洞扫描工具的设计与实现

计算机安全问题是在信息化过程中急需解决的问题 ,而安全漏洞的发现对保护系统安全有着非常重要的意义。网络管理人员由于种种原因 ,很难及时、全面地测试系统的安全性。因此 ,设计一种能代替他们进行测试的工具就显得十分必要。本文首先对漏洞扫描的原理进行了分析 ,主要介绍了一种主机与网络相结合的安全漏洞扫描的设计及实现。     

Theory of a novel voltage-sustaining layer for power devices

The theory of a novel voltage-sustaining layer for power devices, called a Composite Buffer layer (CB-layer for short) is proposed. The CB-layer can be implemented in several ways, one particular implementation is used here, which consists of alternating n- and p-type regions, that are parallel to the direction of the applied electric field. In the off-state, the fields induced by the depletion charges of both region types compensate each other to allowing the doping in both n-regions and p-regions to be very high without causing a reduction of the breakdown voltage. In the onstate the heavy doping ensures the voltage drop is very low and that the saturation current density high. A simple relationship between the specific on-resistance and R_on and the sustaining voltage V_B can be shown to be R_on=2.53 × 10⁻⁷bV_B^1.23 ωcm², where the breadth b (in μm) of each region is much smaller than the thickness W. The design method of the CB-layer is discussed in some detail. The simulation results are shown to be in perfect agreement with the theory. The structure has application to a wide variety of different power devices. An RMOST structure has been used to demonstrate the benefits of the technique in the paper, for which excellent performance is demonstrated.