从稳态到动态的空气调节

分析传统空调所提供的稳态参数微气候环境不一定能达到人的舒适和健康的要求,提出符合人本身生理习惯的空调送风方式应该是动态空气调节.认为个人可调节和适宜的环境渐变能同时保证舒适和健康两方面需要.     

一种新的基于快速功控的多普勒估计

针对采用快速功控的移动通信系统提出了一种简便的多普勒估计方法。该方法利用功控后的接收信号电平的平稳性与最大多普勒频移有密切关系这一特点，通过测量接收信号电平的平稳性估计多普勒频移。文中在单径瑞利衰落信道条件下对这一方法进行了仿真验证，并同文献中提出的COV方法进行了比较，仿真结果表明在信道变化不是太快时本方案有较好的估计精度。     

Quality Control for Scalable Media Processing Applications

Many media processing applications create a load that varies significantly over time. Hence, if such an application is assigned a lower processing-time budget than needed in its worst-case load situation, deadline misses are likely to occur. This problem can be dealt with by designing media processing applications in a scalable fashion. A scalable media processing application can run in multiple qualities, leading to correspondingly different resource demands. The problem we consider is to find an accompanying quality control strategy, which minimizes both the number of deadline misses and the number of quality changes, while maximizing the quality of processing. We present an initial approach to the above problem by modeling it as a Markov decision process (MDP). Our model is based on measuring relative progress at milestones. Solving the MDP results in a quality control strategy that can be applied during runtime with only little overhead. We evaluate our approach by means of a practical example, which concerns a scalable MPEG-2 decoder.     

Reconfigurable hardware implementation of a phase-correlation stereoalgorithm

This paper describes the implementation of a stereo-vision system using Field Programmable Gate Arrays (FPGAs). Reconfigurable hardware, including FPGAs, is an attractive platform for implementing vision algorithms due to its ability to exploit parallelism often found in these algorithms, and due to the speed with which applications can be developed as compared to hardware. The system outputs 8-bit, subpixel disparity estimates for 256× 360 pixel images at 30,fps. A local-weighted phase correlation algorithm for stereo disparity [Fleet, D. J.: {Int. Conf. Syst. Man Cybernetics 1:48–54 (1994)] is implemented. Despite the complexity of performing correlations on multiscale, multiorientation phase data, the system runs as much as 300 times faster in hardware than its software implementation. This paper describes the hardware platform used, the algorithm, and the issues encountered during its hardware implementation. Of particular interest is the implementation of multiscale, steerable filters, which are widely used in computer vision algorithms. Several trade-offs (reducing the number of filter orientations from three to two, using fixed-point computation, changing the location of one localized low-pass filter, and using L1 instead of L2 norms) were required to both fit the design into the available hardware and to achieve video-rate processing. Finally, results from the system are given both for synthetic data sets as well as several standard stereo-pair test images.     

基于支持向量机的缓存预估模型的设计与实现

采用支持向量机(SVM)对网络业务流数据进行预测估计，通过训练样本，从而获得样本以外数据的分布规律。在此基础上，设计了一种网络排队队列缓存的预估模型。实验表明，该模型具有较高的训练效率和很高的估计精确度。     

异步DS-CDMA系统中基于矩阵点除算法的DOA估计

针对异步DS-CDMA系统中的多用户环境,本文提出了一种低复杂度的DOA估计算法——矩阵点除算法。该算法通过对感兴趣信息的逐次分离,实现了DOA的逐路径估计。算法具有两方面显著优势:(1)克服了传统的DOA估计算法在路径总数大于天线阵元数时不能工作这一缺陷:(2)避免了计算复杂的特征值分解运算,大大降低了算法复杂度。仿真实验验证了算法的有效性。     

火工品压药机装配误差的研究

针对军用雷管生产线中压药机结构,分别用极值法和概率法对压药机冲子和雷管的配合精度,进行了装配尺寸链的描述和计算,并对所得的结果进行了比较。     

基于EDGE系统信道估计实现方案的研究

研究了基于ＥＤＧＥ系统接收机中信道估计的实现方案，并对算法的各项性能做出评估。首先论述了算法的采用及其理论依据。接着，说明了信道预估计的原理及方法。最后，针对ＭＡＴ－ＬＡＢ及 ＤＳＰ上的仿真结果，比较了各项系数对于系统性能改善所具有的影响和作用，对系统特性作了较为详细的分析总结。     

Outlier-resistant methods for estimation and model fitting

Least squares is perhaps the most widely used technique for model fitting. In this article, we illustrate the poor performance of least squares when there are spurious values, or outliers, in a sequence of measurements. A brief overview of three well-known classes of robust alternatives to the least-squares mean is presented. For robust regression, a recent proposal called least median squares (LMS) is decribed. LMS regression is compared to least-squares regression in an example involving the estimation of optical fiber geometry. References are provided for software that is available for robust estimation techniques surveyed in this article.     

泡沫夹克管的防水与保温

针对辽河油田应用泡沫夹克管道的情况，从泡沫夹克管的制作和敷设施工直到设计等环节，结合泡沫夹克管防腐保温的机理，并从理论与实践相结合角度出发，提出导致泡沫夹克管腐蚀损坏的最主要原因是管道保温层漏水，进而提出了在设计和施工过程中提高泡沫夹克管质量的措施。