真空碳热还原法制备高密度碳化钒

研究了采用真空碳热还原法由三氧化二钒制备碳化钒，并研究了碳化钒产物密度随实验条件的变化规律。找到了用于强化碳化钒产物密度的添加剂，研究结果表明，反应温度，添加剂是影响碳化钒产物密度的主要因素。反应时间对产物密度也有一定影响。研究结果同时表明，含铁化合物能有效地提高产物密度。     

Density measurements on levitated liquid metal droplets

Electromagnetic levitation is a useful tool for measuring thermophysical properties of high-temperature melts such as liquid metals. Due to its noncontact nature, the undercooled regime is also accessible. Density and thermal expansion of a levitated drop can be derived from volume measurements, if its mass is known. Assuming cylindrical symmetry, the volume of a drop can be determined from its cross section. Using photography, such measurements on liquid metals have been performed in the past. Here we present an improvement of this method, which replaces the photographic camera with a CCD videocamera and subsequent digital image processing. This reduces the time effect required to obtain the results and allows one to average over disturbing surface oscillations. The specific problems of digital image processing, namely resolution and edge detection, are addressed and results on nickel are presented.Paper presented at the Fourth International Workshop on Subsecond Thermophysics, June 27–29, 1991, Köln, Germany.     

日本α－Al_2O_3粉体进展

综述了日本近１０多年来α－Ａｌ２Ｏ３粉体的发展状况。特别介绍了日本对α－Ａｌ２Ｏ３粉体的标准化工作。这对提高电子陶瓷等产品的质量是非常重要的。     

飞行人员骨密度与内分泌调节关系的探讨

对37名骨密度(BD)低下的飞行员(实验组)和BD正常的48名飞行员、100名地面人员(正常对照组)进行了BD和血清TT_3、TT_4、TSH IRMA、CT、PTH、E_2和T放射免疫测定。结果显示,实验组BD均值明显低于对照组(p<0.01),血清TT_3、TT_4、CT、E_2(女性)和T(男性)均值与对照组比较,大多数年龄存在着显著或非常显著差异(p<0.05或p<0.01)。同时对飞行人员BD与几种内分泌激素关系进行了探讨。     

光面爆破专用炸药的研究

文章分析了光爆炸药的性能特点，提出了制造光爆炸药新方法。该炸药密度（０．３５、０．７０ｇ／ｃｍ￣３）与爆速（１３００、２２００ｍ／ｓ）可调，贮存性能稳定；爆轰感度好，能满足不同硬度岩石尤其是软岩的光爆需要。     

Density of 1,1-dichloro-1-fluoroethane (HCFC 141b) as a function of temperature and pressure

The density of HCFC 141b has been measured at several temperatures between 260 and 320 K, Mid pressures up to 20 MPa, with a mechanical oscillator densimeter. The densimeter was calibrated with 2,2,4-trimethylpentane, whose density was obtained from a correlating cyuation with 0.3% uncertainty. The density data obtained for HCFC 14H) hits a reproducibility of 0.05% and an uncertainty of 0.3%. The data obtained were fitted to a Tait-type equation. which reproduced the experimental densities within 0.11 % and were compared with the data obtained in other works.Paper presented at the Twelfth Symposium on Thermophysical Properties, June 19–24, 1994, Boulder, Colorado, U.S.A.     

Evaluation of Serum Volume Losses During Long-Term Storage

Aliquots of serum collected in a large case-control study of cervical cancer were stored at −70°C for up to 4 years during implementation of the study. When 500 μL serum aliquots were thawed in preparation for carotenoid and vitamin A assays, volumes were noticeably variable and fell below 500 μL in the majority of the samples. We were concerned about evaporation/sublimation during storage of the samples because loss of water would concentrate the analytes of interest. We evaluated the use of density and sodium ion concentration measurements to confirm its occurrence. We found that serum density was an unreliable indicator of extent of volume loss since the anticipated increases in density due to evaporation were of the same magnitude as inter-individual variation in serum density. In contrast, Na⁺ concentration is tightly regulated and would rise if water had been lost from the samples. In a representative sample of serum aliquots from the case-control study, 24 of 25 vials contained less than 500 μL of serum. The mean sodium ion concentration (138.1 ± 3.6 mmol/L) was within the normal range for human serum of 136–145 mmol/L, and no correlation was observed between serum volume and Na⁺ concentration. These results strongly suggest that the observed low volumes were not due to evaporative losses. Instead, the variably low volumes of serum aliquots were probably due to pipetting errors in the initial aliquotting resulting from the use of air-displacement pipettes.     

PbO－Bi_2O_3－B_2O_3－SiO_2系重金属氧化物玻璃的结构与光学性

通过密度、可见光光谱、红外吸收光谱、Ｃｏ－６０辐照损伤试验及荧光光谱的测试，研究了ＰｂＯ－Ｂｉ２Ｏ３－Ｂ２Ｏ３－ＳｉＯ２玻璃系的光学性能与结构．密度最高可达８．４６４ｇ／ｃｍ３其紫外吸收达截止波长随Ｐｂ２＋及Ｂｉ３＋含量升高而红移．玻璃熔化温度低达８５０℃．在ＰｂＯ－Ｂｉ２Ｏ３－Ｂ２Ｏ３系玻璃中加人ＳｉＯ２可使玻璃结构更致密．室温下该系统玻璃在３６０ｎｍ有一个宽的激发峰，能产生４１８ｕｍ及４３８ｕｍ两个弱的发射峰．该系统玻璃的结构是由［ＳｉＯ４］４－、［ＢＯ３］３－、［ＢＯ４］５－、［ＰｂＯ４］６－及［ＢｉＯ６］９－构成．其中部分Ｐｂ２＋及Ｂｉ３＋以网络外体进入玻璃．     

Decisive arrival law parameters and a general finite capacity queueing problem

This paper addresses the problem of finding the parameters of the arrival law which most significantly influence expected occupation and loss of a finite capacity queue. The input process is supposed to be ergodic and wide sense stationary. We show that it is mostly possible to fit an MMPP(2) to the decisive parameters of observational data. Numerical examples illustrate the importance of the decisive parameters, called key parameters, and also show the accuracy of the proposed fitting procedure. Finally, in the appendix we present the solution of the finite capacity queueing problem with Special Semi Markov Process (SSMP) arrivals and a general service strategy.     

三脉冲不等强度激光片光源的研制及应用

本文报道了最近研制成功三脉冲不等强度调Q红宝石激光片光源系统.利用小颗粒对片光源90°方向的散射光对动态颗粒场进行高速摄影,从底片中能够精确直观地判断微小颗粒的瞬时分布、运动方向、速度和加速度情况.