Analysis of polarization plane rotation characteristic in 2D photonic crystal waveguide with chiral medium by condensed node spatial network

Using the photonic band gap in photonic crystals, the fundamental waveguide structures for the light wavelength range have been developed. Based on the fine structure of these many functional devices have been proposed by analytical or numerical simulation methods and the experiments of trial manufacture. In this paper, the treatment of chiral dielectric in the Condensed Node Spatial Network for the vector potential is explained, and we show the polarization plane rotation property in air‐hole and pillar type photonic crystal waveguide structures with the chiral medium substrate. Then, we show the fundamental advantage of the air‐hole type photonic crystal waveguide structure in application to a mode converter. © 2005 Wiley Periodicals, Inc. Electr Eng Jpn, 152(1): 7–14, 2005; Published online in Wiley InterScience ( www.interscience. wiley.com ). DOI 10.1002/eej.20098     

坐标测量机激光非接触式测头的研制

本文介绍适用子精密大型测试仪器──坐标测量机的激光非接触式测头的研制。该测头采用ＰＳＤ作为敏感元件并采用单片机技术完成对测量数据的处理。     

高温超导红外探测器的电极工艺探讨

介绍了高温超导红外探测器电极材料的选择和制备。选用先蒸、后蒸金，再合金化的电极工艺。芯片装配成器件后，器件性能稳定，膜层牢固，接触电阻小。     

掺饵光纤放大器用1480 nm/1550 nm波分复用器的优化设计

以组合波导理论为基础，分析了1480/1550 nm波分复用器的耦合区横截面形状和尺寸与偏振灵敏度的关系。着重比较了矩形截面和椭圆形截面二种波分复用器的偏振性能，并发现当椭圆截面的短轴与长轴之比为1:1.88时，器件性能几乎与偏振无关。研制成功的1480/1550 nm波分复用器的波长隔离度大于20 dB,偏振灵敏度小于0.1 dB,附加损耗小于0.5 dB。     

Terahertz detectors based on superconducting hot electron bolometers

Low noise terahertz(THz)heterodyne detectors based on superconducting niobium nitride(NbN) hot electron bolometers(HEBs)have been studied.The HEB consists of a planar antenna and an NbN bridge connecting across the antenna’s inner terminals on a high-resistivity Si substrate.The double sideband noise temperatures at 4.2 K without corrections have been characterized from 0.65 to 3.1 THz.The excess quantum noise factor β of about 4 has been obtained,which agrees well with the calculated value.Allan variance of the HEB has been measured,and Allan time up to 20 s is obtained using a microwave feedback method.Also,the intermediate frequency gain bandwidth(GBW)was measured using two dierent methods,resulting in same GBW value of about 3.5 GHz.     

Macrophage Polarization in Cardiac Tissue Repair Following Myocardial Infarction

Cardiovascular disease is the leading cause of mortality and morbidity around the globe, creating a substantial socio-economic burden as a result. Myocardial infarction is a significant contributor to the detrimental impact of cardiovascular disease. The death of cardiomyocytes following myocardial infarction causes an immune response which leads to further destruction of tissue, and subsequently, results in the formation of non-contractile scar tissue. Macrophages have been recognized as important regulators and participants of inflammation and fibrosis following myocardial infarction. Macrophages are generally classified into two distinct groups, namely, classically activated, or M1 macrophages, and alternatively activated, or M2 macrophages. The phenotypic profile of cardiac macrophages, however, is much more diverse and should not be reduced to these two subsets. In this review, we describe the phenotypes and functions of macrophages which are present in the healthy, as well as the infarcted heart, and analyze them with respect to M1 and M2 polarization states. Furthermore, we discuss therapeutic strategies which utilize macrophage polarization towards an anti-inflammatory or reparative phenotype for the treatment of myocardial infarction.     

纳米Cr颗粒对Ni-Mo复合镀层性能的影响

为了研究纳米Cr颗粒对Ni-Mo复合镀层性能的影响,采用脉冲电沉积方法制备具有不同Cr含量的Ni-Mo复合镀层.利用扫描电子显微镜和X射线衍射仪分别观察和分析复合镀层的组织形貌及结构.采用电化学测试和X射线光电子能谱研究复合镀层的析氢性能和耐蚀性能.结果表明:随着镀液中纳米Cr颗粒含量的增加,镀层晶粒得到细化,析氢过电位增大,复合镀层析氢性能得到提高;当镀液中纳米Cr颗粒含量为20 g/L时,复合镀层表面钝化膜中MoO₃含量较高,且可与Cr产生协同效应,因而复合镀层具有较好的耐蚀性能;但随着镀液中纳米Cr颗粒含量的进一步增加,复合镀层中沉积的Cr元素含量降低,复合镀层的析氢性能和耐蚀性能均降低.因此,当镀液中纳米Cr颗粒含量为20 g/L时,复合镀层具有较好的析氢性能和耐蚀性能.     

氧化薄膜对锆-4合金表面性能的影响

为了研究氧化薄膜对Zr-4合金表面性能的影响,对样品分别进行了350℃和400℃各10 min,15 min,20 min和25 min氧化.结果发现,不同条件下氧化生成的样品表面呈现不同的颜色.小角掠射X射线衍射分析(GAXRD)表明,生成的氧化物为非化学计量的六方相氧化锆.样品在0.5 mol/L的H2SO4溶液中进行电化学试验发现,氧化后样品的耐电化学腐蚀性能有所提高.而用纳米压痕仪试验的结果表明,氧化后样品有较高的纳米硬度和较低的弹性模量,意味着氧化后样品可能有更好的耐磨性.400℃氧化样品对合金性能的提高优于350℃氧化样品.     

季辚盐对Al缓蚀作用的研究

用微分极化电阻和微分电容测量法研究3种季辚盐化合物在1mol·L-1MgCl2溶液中对Al的缓蚀作用及季辚盐分子结构对缓蚀效率的影响。结果表明,季辚盐化合物具有较好的缓蚀作用,链长的季辚盐比链短的缓蚀效率高。季辚盐在Al表面上吸附服从Langmuir吸附等温式,且为物理吸附。     

Corrosion-Electrochemical behavior of 13% chromium (Cr) martensitic stainless steel in hydrochloric acid (HCl) solutions

Corrosion-Electrochemical behavior of a commercial API5CT grade L80 type 13Cr tubing enriched with microalloying elements is studied in 6, 7.5, 9, 12 and 15% HCl solutions by electrochemical methods. The objective is to contribute to the comprehension of corrosion phenomena caused by HCl of similar concentrations, generally used in acidizing job. The corrosion morphology is examined by scanning electron microscopy (SEM) coupled with EDAX. The soluble corrosion products are analyzed by atomic absorption spectroscopy and colorimetric methods. General, as well as localized, corrosion is present. The severest general corrosion with a maximum rate of 26 mm/year is obtained at 15% HCl. The localized corrosion which morphologically differs as function of HCl concentrations is revealed by SEM investigation. In all the above HCl solutions, the commercial 13% Cr martensitic stainless steel tubing shows no passive state. Above 6% HCl, the microalloying elements promote forming a discontinuous film of the corrosion products. The corrosion rate slightly decreases in 15% HCl compared to the published data on a conventional 13% Cr martensitic stainless steel tubing. This is due to both the chemical composition (silicon, manganese and vanadium) and microstructural properties. Copper seems to additionally accelerate the corrosion of the alloy. Published in Russian in Zashchita Metallov, 2007, Vol. 43, No. 4, pp. 372–380. The article was translated by the authors in English.