Electrochemical Aspects of Electroosmotic Dewatering of Clay Suspensions

An attempt is made to elucidate the electrochemical aspects of the electroosmotic dewatering (EOD) of clays as reported in some recent work, especially that on interrupted DC power electroosmotic dewatering published by Rabie, Mujumdar and Weber (2). These authors showed that the dewatering by EOD stops after the DC power has been on for several minutes or hours; on interruption of their power and on short-circuiting of the electrodes, conditions can be created again for some further dewatering by DC power EOD. This discovery, of Rabie et al. is interpreted as a fuel cell effect and it is shown that it affords clues to several other electrochemical strategies for the possible enhancement of the efficiency of the EOD by DC power.

Further, the open circuit potentials observed by Rabie et al. (2) on the interruption of DC power are given an electrochemical interpretation which leads to quantitative estimates in agreement with the experimental values.     

Preparation and Properties of Sintering Additives Coated Si3N4 from Heterogeneous Nucleation Processing

The sintering additives such as Al2O3 and /or Y2O3 were coated on the surfaces of Si3N4 particles via heterogeneous nucleation processing using a buffered pH solution as the precipitation reagent .They nucleated and grew only on the surfaces of Si3N4 and did not form sol particles in solution by TEM observation .The isoelectric point(IEP) of coated Si3N4 was different from that of as-received Si3N4.The IEP of Al(OH)3-coated Si3N4 occurred at pH8.4, which is close to that of alumina .When Al(OH)3-coated Si3N4 particles were coated with Y(OH)3,the IEP of coated Si3N4 powder shifted from pH8.4 to pH9.2 ,similar to that of yttria.In addition ,the rheological data showed that Al2O3 and /or Y2O3 coated Si3N4 suspension is nearly Newtonian and that added Si3N4 suspension shows a shear rate thinning behavior.     

Ion irradiation—induced structure damage to botanic samples using the ion transmission energy spectrum

1 INTRODUCTIONThe new aPplications of low energy heavy ion beam in irradi4ted botanical materialswere studied in recellt yeaxs. The beaminduced mutation effect on crop seeds has causedthe attention of physicist and biologists.[1l:] FOr examPle, 1ow energy ions can induceremarkable mutation to rice seeds.[3] There are many special phenomena when heavyions bombard botanic sW1e due to its special structure. Some studies showed that tllepenetration depths of some ions were far larger than t…     

起重机吊钩拖动绕线电动机他励双高调速系统

本文提出励磁电流可自动控制的他励式双高调速系统设计方案。系统在提升特别是在下放重物时，具有较硬的机械性；在负载１０－１００％的变化范围内，可实现最大偏差Δｎｍａｘ／ｎｍｉｎ１００％≤１０％，调速范围Ｄ≥１０；在满载运行条件下，可节约电能８０％以上。     

国外离子束系统（IBS）发展概况

综述了国外离子束刻蚀和沉积系统的研究进展，指出了离子束系统在半导体技术研究，开发和生产中的重要性。     

Li2O在保护渣中的作用

采用在不同玻璃性的两种基渣中加入Ｌｉ２Ｏ为研究Ｌｉ２Ｏ对保护渣粘度，熔化温度及玻璃性能的影响，并对Ｌｉ２Ｏ改善保护渣玻璃性的机理进行了探讨，提出了寻找高速连铸保护渣中Ｌｉ２Ｏ的代用物的一种方法。     

离子注入对Cr12MoV钢表面组织结构和力学性能的影响

研究了Ｃｒ１２ＭｏＶ钢离子注入层的显微组织特征及其对表面性能的影响。结果表明，离子注入使Ｃｒ１２ＭｏＶ钢的表面硬度和耐磨性能得到显著改善，且存在着一个最佳的注入剂量，约为３×１０＾１＾７Ｎ＾＋／ｃｍ＾２左右。离了注入在Ｃｒ１２ＭｏＶ钢表面层中形成了大量细小弥散的第二相粒子，并使α－Ｆｅ晶格发生严重畸变，从而引起材料表面强化。     

关于Gibbs函数变关系式引出的探讨

本文推荐陈林根编著的《工程化学》对化学热力学基本公式△G=△H-T△S的引出方法,试探基础教学的改革。     

GIC－4117／HC1．7MV Tandetron上的MeV离子注入系统

利用通用离子公司（ＧＩＣ）的４１１７型１．７ＭＶＴａｎｄｅｔｒｏｎ离子束分析设备进行ＭｅＶ级离子注入。所注入的离子能量范围由５００ｋｅＶ到１０ＭｅＶ，离子的质量在２４０ｕ以下，某些元素的负离子束流强度在１５０μＡ以上。双向机械扫描技术可将离子均匀地注入样片。     

Calculation of second virial coefficients and gaseous viscosities of the refrigerants HFC-32 (CH2 F2), HFC-23 (CHF3), and HCFC-22 (CHC1F2)

The second virial coefficients of refrigerants HFC-32 (CH₂F₂), HFC-23 (CHF₃), and HCFC-22 (CHC1F₂) have been correlated on the bisis of site site model potential and have been compared with experimental results. The molecular interactions consisted of repulsion dispersion and electrostatic parts. From the site site potentials adjusted to the experimental second virial coefficients, spherically averaged potentials have been determined and a subsequent calculation of gaseous viscosity has been carried out. Agreement between measured and calculated values of second virial coellicients and gaseous viscosity is satisfactory. Calculated values of second virial coefficients and gaseous viscosity beyond available experimental data, therefore. can be assumed as a reliable extrapolation to lower and higher temperatures.