利用Love波特性计算地基动力响应

本文利用Love波弥散特性在频域上对地基出平面振动及扭振问题进行了研究。在计算区域内结构将采用有限单元划分,而在边界上则根据Love 面波特性使用传递边界有限单元。本文同时讨论了不同模态波对结构动力响应的贡献。本文方法也适合于静力分析。     

波浪力计算中的一个新边界元方法

本文就波浪与结构物作用问题，提出了一个新的高阶边界元方法。较之Ｅａｔｏｃｋ Ｔｏｙｌｏｒ和Ｃｈａｕ的方法，本文在体内附助积分方程中应用了满足刚性水面条件和弱刚性底面条件的简单格林函数。计算速度相应地有所提高；漂浮结构的积分方程更为简洁；计算结果与Ｅａｔｏｃｋ Ｔａｙｌｏｒ和Ｃｈａｕ的方法具有几乎相同的精度和收敛速度。     

用于疏通油水井的脉冲放电技术

评价了各种不同的解堵技术，指出冲击波解堵是一种很有发展前途的技术。介绍了液中脉冲放电产生冲击波的基本原理，并由此研制出了一套井下脉冲放电油水井处理设备样机。通过现场试验，表明用冲击波疏通油井能较好地解除油井污染，提高采收率。     

Low-cycle fatigue behavior of Sn-Ag, Sn-Ag-Cu, and Sn-Ag-Cu-Bi lead-free solders

Low-cycle fatigue (LCF) tests on as-cast Sn-3.5Ag, Sn-3Ag-0.5Cu, Sn-3Ag-0.5Cu-1Bi, and Sn-3Ag-0.5Cu-3Bi solders was carried out using a noncontact strain-controlled system at 20°C with a constant frequency of 0.1 Hz. The addition of Cu does not significantly affect the fatigue life of eutectic Sn-Ag solder. However, the fatigue life was significantly reduced with the addition of Bi. The LCF behavior of all solders followed the Coffin-Manson relationship. The fatigue life of the present solders is dominated by the fracture ductility and can be described by the ductility-modified Coffin-Manson’s relationship. Steps at the boundaries of dendrite phases were the initiation sites for microcracks for Sn-3.5Ag, Sn-3Ag-0.5Cu, and Sn-3Ag-0.5Cu-1Bi solders, while for Sn-3Ag-0.5Cu-3Bi solder, cracks initiated along both the dendrite boundaries and subgrain boundaries in the dendrite phases. The linking of these cracks and the propagation of cracks inside the specimen occurred both transgranularly through eutectic phases and intergranularly along dendrite boundaries or subgrain boundaries.     

CTS-26型超声探伤仪典型故障的分析与排除

在简要介绍CTS-26型超声探伤仪工作原理及组成的基础上。对其几种典型故障作了具体的分析和处理。     

Method of increasing the output signal-to-noise ratio in passive multi-element antenna arrays

A method of processing complex signals in passive multi-element antenna arrays based on an analysis of the natural values of the correlation matrix of the signal is considered. By means of the method it is possible to substantially increase the output signal-to-noise ratio. An iterational process by means of which optimal estimators of both the signal and the amplitude-phase distribution may be obtained, is proposed. Theoretical estimators of the efficiency of the method are given. It is proved that, in terms of the efficiency, the approach considered in the article comes close to the technique of matched filtration. Results of statistical modeling that confirm the statistical results are presented.     

Nondestructive evaluation of pavements using spectral analysis of surface waves in the frequency wave-number domain

The potential of using Spectral analysis of surface waves (SASW) for nondestructive testing of pavement and soil sites has been demonstrated in several publications. The usual SASW field testing and data analysis procedures and the assumption of a single propagation mode yield accurate results when there are no sharp changes in the stiffness of the site with depth. When this is not the case, however, difficulties arise in the interpretation of experimental data due to the participation of more than one mode in the wave field. In an earlier study, the multiple filter/crosscorrelation technique was suggested for analyzing multi-mode SASW signals. This technique, however, may not yield accurate results when propagation modes are closely spaced. A more general method using spectral analysis in the frequency wave-number domain is presented in this paper. Formulas are presented for determining a reasonably small number of surface measurements, and the accuracy of this method in resolving experimental dispersion curves is demonstrated for a pavement site.     

连续运转的掺钛蓝宝石激光器

本文报导一种连续波氩离子激光泵浦的掺钛蓝宝石激光器。在氩离子激光功率(全谱线)为10.45瓦且仅用一组腔镜时,获得最大平均功率超过1000mW、调谐范围750～850nm的掺钛蓝宝石激光输出。     

高频声表面波滤波器用单指换能器

报道两种带宽极窄的采用单指换能器制作的声表面波滤波器。一种是利用单指换能器声同步频率与反射频率之间的相位叠加与相消来制作的体积极小（芯片面积只有采用双指换能器的三分之一不到）的高频极窄带声表面波滤波器，其３ｄＢ带宽的相位变化只１２０°；另一种是采用合理布局的单指无内反射换能器制作的高频极布带声表面波滤波器，其幅频特性同采用双指换能器制作的同类型的声表面波滤波器一样。最后给出了这两种声表面波滤波器的较详细的理论分析和实验结果。关键词     

声表面波可程序抽头延迟线研究

报道声表面波可程序抽头延迟线的研制情况。对该器件的总体结构，电路原理框图、声表面波可程序抽头延迟线结构作了一个扼要的概念。同时分别报道了我所研制的各类声表面波可程序抽头延迟线器件性能指标及相应的图片说明，最后对该器件仍存在的一些问题作了探讨。