华府大厦通风空调工程设计

从建筑概况、大楼空调设计标准、空调负荷、空调冷热源、空调冷冻水系统、空调风系统、空调自动控制方式、通风与防排烟设计方法等几个方面介绍了华府大厦通风空调工程设计。     

Quantitation of volatile compounds in heated triolein by static headspace capillary gas chromatography/infrared spectroscopy-mass spectrometry

Static headspace and capillary gas chromatography/infrared spectroscopy-mass spectrometry were used to collect, separate, identify and quantitate the oxidative and thermal decomposition products in heated triolein. Approximately 4 L of triolein was heated in a deep-fat fryer at 190°C for 12 h each day for a total of 60 h, until it contained>-20% polymeric material. The concentration of heptane and octane increased after 12 h heating, then decreased upon further heating, while the concentration of volatile aldehydes decreased gradually during heating. After 12 h of heating, the concentrations of the major volatiles changed as follows: heptane (16.36 to 30.17 ppm), octane (24.48 to 40.77 ppm), heptanal (21.68 ppm to 9.11 ppm), octanal (35.53 to 36.64 ppm), nonanal (68.95 to 43.16 ppm), (E)-2-decenal (135.00 to 89.00 ppm) and (E)-2-undecenal (88.50 to 61.00 ppm). After 60 h of heating, when the oil contained over 20% polymeric material, the concentrations of heptane, octane, heptanal, octanol, nonanal, (E)-2-decenal and (E)-2-undecenal were 5.16, 4.39, 5.45, 7.02, 18.07, 12.50 and 6.00 ppm, respectively.     

森林植被改善对鄱阳湖流域径流和输沙过程的影响

以河流基流为切入点,研究流域植被调节径流、水土保持等微观作用影响大中型河流湖泊径流过程和水沙过程宏观效应的机理。鄱阳湖流域60年来天然降水没有发生趋势性变化。流域森林覆盖率由34.73%上升到63.00%,植被质量改善,赣江等入湖河流基流增加83 m~3/s,河流输沙量减少。2000年以后和2000年以前相比较,枯水期降水径流系数增大,年流量过程平坦化,一定程度上减小洪灾风险,有利于水资源利用和生态环境保护。2001年以后进入鄱阳湖泥沙平均每年减少1 007×10~4t;出湖泥沙增加314×10~4t。因此,鄱阳湖入江水道由淤积转变为冲刷,但出湖流量过程没有趋势性变化。     

墩头超长实用堰泄洪安全分析及模型试验验证——以缅甸DAPEIN(Ⅰ)水电站工程为例

以缅甸DAPEIN(Ⅰ)水电站工程为例,论述了将WES实用堰的闸墩墩头向上游超长延伸之后,对泄洪安全所造成的影响。针对WES实用堰流量系数、堰面动水压力容易受边界因子影响的特点,对设计断面的堰顶布置和墩头形状进行了优化。根据堰面空化数计算公式及水流特性推导出计算的关键部位,对空化数进行计算。采用几何比尺为1∶60的物理模型对溢流堰的泄流能力和堰面动水压力进行了试验测试。试验结果表明:溢流堰的模型试验泄流能力和设计泄流能力非常相近。堰面动水压力除工况2的B4测点出现了-1.2 k Pa的微小负压值外,其余堰面时均压强值均大于0。从而,在泄流能力和堰面动水压力两方面都验证了这种设计方案的合理性。该工程所遇到的结构布置问题在中低溢流坝工程中属常见问题,解决思路可为今后类似工程建设借鉴参考。     

脉冲放电烟气脱硝的研究

对放脉冲电脱除烟气中的NO和NOx的实验研究与分析结果表明 ,烟气中的飞灰对NOx具有 2 %～ 4 %的吸附脱除作用 ,同时 ,对脉冲放电产生抑制导致脱除率降低。增加烟气含水量增强了飞灰粒子表面的化学吸附能力 ,使得在烟气含水量为 15 % (V V)和单位体积烟气注入能量小于 3W·h Nm3时 ,NO和NOx的脱除率提高 5 %～ 15 % ,烟气在反应器中停留时间 5 .9s、单位体积注入能量小于 4W·h Nm3时 ,NO和NOx的脱除率分别为 4 2 %和 2 9%。     

Estimating discharge in gravel‐bed river using non‐contact ground‐penetrating and surface‐velocity radars

Discharge measurement is a critical task for gravel‐bed channels. Under high‐flow conditions, the elevation of the riverbed changes significantly by intensive torrential flow. The stage–discharge relations commonly used for stream discharge estimation may no longer be adequate. The contact‐type velocity measuring is also subject to measurement errors and/or instrument failures by the high‐flow velocities, driftwood, stumps, and debris. This study developed a new real‐time method to estimate river discharge in gravel‐bed channels. A systematic measuring technology combining ground‐penetrating radar and surface‐velocity radar was employed. The rating curves representing the relations of water surface velocity to the channel cross‐sectional mean velocity and flow area were established. Stream discharge was then deduced from the resulting mean velocity and flow area. The proposed method was examined in a steep gravel‐bed reach of the Cho‐Shui River in central Taiwan. The estimated stream discharge during three flood events were compared to the prediction by using the stage–discharge relation and the index‐velocity method. The proposed method of this study is capable of computing reasonable values of discharge for an entire flood hydrograph, whereas the other two methods tend to produce large extrapolation errors. Moreover, when the computed discharge is used in 2D flood flow simulation, the proposed method demonstrates better performance than the commonly used stage–discharge and index‐velocity methods.     

Torque Transmission Capabilities of Bonded Polygonal Lap Joints for Carbon Fiber Epoxy Composites

Although carbon fiber epoxy composite materials have excellent properties for structures, the joint in composite materials often reduces the efficiency of the composite structure because the joint is often the weakest area in the composite structure.

In this paper, the effects of the adhesive thickness and the adherend surface roughness on the static and fatigue strengths of adhesively-bonded tubular polygonal lap joints have been investigated by experimental methods. The dependencies of the static and fatigue strengths on the stacking sequences of the composite adherends were observed.

From the experimental investigations, it was found that the fatigue strength of the circular adhesively-bounded joints was quite dependent on the surface roughness of the adherends and that polygonal adhesively-bonded joints had better fatigue strength characteristics than circular adhesively-bonded joints.     

陶瓷材料断裂韧性测试新技术：静态爆破剂预制裂纹的研究

准确测试陶瓷材料断裂韧性Ｋ１Ｃ的关键是预制具有原生裂纹的试样。本文以单边切口梁法测试Ｋ１Ｃ为基础，提出了一种简便而有效的陶瓷材料原生裂纹的预制方法－静态膨胀法。研究结果表明：静态膨胀法中裂纹的扩展是稳态的；通过调节影响微裂纹产生与扩展的多种因素，可以准确地控制裂纹扩展的深度，预制出合适的原生裂纹，为准确评价结构陶瓷的断裂韧性提供了一种有效可行的方法。     

锌系工件的静电粉末涂装和工艺管理

讨论了锌系工件喷涂的相关工艺、现场管理、技术参数、质量检验和环境要求等。     

导静电乳液胶粘剂的研制

用多元乳液共聚法制备了用于粘贴导静电PVC地板胶粘剂,加入乙炔碳黑赋予乳液胶粘剂导静电性能。研究了影响胶接强度和初粘力的主要因素,确定m(VAc)/m(BA+VAc)较合适比为1∶3;研究了乳化剂和交联单体对乳液性能的影响,研究得出,适量加入AA和HMAM可以减少乳化剂的用量,提高乳液的性能;考查了影响导静电性能的因素,研究表明,导静电性能由乙炔碳黑决定,其加入量越大,导静电性能越好。得到的导静电乳液胶粘剂胶接强度达到0.51MPa以上,导静电可达到7.2×103Ω,两项指标均超过国家标准。