A low noise CMOS RF front-end for UWB 6-9 GHz applications

An integrated fully differential ultra-wideband CMOS RF front-end for 6-9 GHz is presented.A resistive feedback low noise amplifier and a gain controllable IQ merged folded quadrature mixer are integrated as the RF front-end. The ESD protected chip is fabricated in a TSMC 0.13μm RF CMOS process and achieves a maximum voltage gain of 23-26 dB and a minimum voltage gain of 16-19 dB,an averaged total noise figure of 3.3-4.6 dB while operating in the high gain mode and an in-band IIP3 of-12.6 dBm while in th...     

20GHz镜频抑制谐波混频器

镜频抑制混频器能有效地抑制镜像频率,提高雷达和通信系统的抗干扰能力。介绍了一个20 GHz二次谐波镜频抑制混频器的设计与制作,该镜频抑制混频器采用两个相同的二次谐波混频器做为两路混频单元,两路射频输入和中频输出分别用90°的功分器/合路器与两路混频器相连,本征用威尔金森功分器等幅同相输入两路混频。借助于90°的功分器,两路混频器的镜频产物在中频90°合路器的输出端口反相抵消,有用中频在90°合路器的输出端口同相叠加。利用ADS和HFSS对该混频器进行了仿真设计,并对实际电路进行了加工测试。经测试,当中频固定在400 MHz时,射频在20～21 GHz内变频损耗小于10 dB,镜频抑制大于20 dB。     

基于UG的揉面机机构运动分析

揉面机运动学性能对机械性能有重要影响,通过动力学仿真能找出机构的各种参数曲线来分析机械性能,对机构或机构上某点的位移、速度、加速度能形象化表达。利用UG NX5.0进行虚拟样机的动力学模型的建立与求解,并运用UG NX5.0运动分析后处理模块进行解算结果的图形显示,得出揉面机动力学仿真结果,根据仿真结果能很好发现揉面机设计中缺陷并及时改正。     

Side-Tee混合器内微观混合行为研究

选用碘化物-碘酸盐体系,利用化学探针法对Side-Tee混合器在较高雷诺数下微观混合效率进行了研究。考察了不同影响参数(如雷诺数、体积流率比、反应物浓度、粘度、管径)对Side-Tee混合器微观混合性能的影响,并用离集指数来表征其微观混合特性。结果表明,雷诺数大于12 000后碘化物-碘酸盐反应体系对混合器内微观混合状况不敏感。基于团聚模型,估算出Side-Tee混合器在实验条件下的微观混合时间为3×10-5~3×10-4s。表明这一型式的反应器对于快速反应尤其是纳米材料制备过程具有替代传统搅拌槽反应器的优势。     

一种改性铵油炸药连续化生产中的均匀混合设备

文章介绍了改性铵油炸药连续化生产的关键性混合设备之一卧式多辊连续混合机,对该设备的结构特征、工作原理、混合过程及安全措施进行分析,认为该设备能充分适应改性铵油炸药连续化生产工艺要求,对改性铵油炸药连续化自动化生产和发展具有重大意义。     

A linearized and low noise CMOS mixer with B‐type amplifier‐based sub‐harmonic balun

A low noise and high linearity down‐conversion CMOS mixer for 2.4‐GHz wireless receiver is presented in this paper. Using a sub‐harmonic balun with a simple but effective B‐type amplifier, the local oscillator frequency required for this mixer has been reduced by half, and the input local oscillator signal could be single‐ended rather than differential, which simultaneously simplifies the design of local oscillator. A distortion and noise cancelation transconductor in association with current bleeding technique is employed to improve the noise and linearity of the entire mixer under a reduced bias current without compromising the voltage gain. Fabricated in a 0.18‐µm RF CMOS technology of Global Foundries, the mixer demonstrates a voltage gain of 15.8 dB and input‐referred third‐order intercept point of 6.6 dBm with a noise figure of 2.6 dB. It consumes 7.65 mA from a 1.0‐V supply and occupies a compact area of 0.75 × 0.71 mm² including all test pads. Copyright © 2016 John Wiley & Sons, Ltd.     

K波段环形平衡混频器的仿真设计

针对在毫米波段,由于波长较短,对3dB电桥结构来说,每臂太短且太宽,使电桥难于实现;而对环形结构来说,环的特性阻抗高,微带线窄,环的周长大,达到制造误差和设计误差都较小的目标。本文提出了一种K波段环形平衡混频器的设计方法,采用ADS的co-simulation工具对其进行了仿真,重点分析了隔离度、变频损耗和线性度方面的问题。文中给出了仿真测试数据,对数据进行了分析。并根据仿真结果可以得出该混频器具有较好的隔离度,变频损耗和线性度。     

A novel compact low-power direct conversion receiver for mobile UHF RFID reader

A novel direct conversion receiver with low cost and low power is implemented in a 0.18 μm 1P6M standard CMOS process for a Mobile UHF RFID reader.A highly linear active mixer with low flicker noise and low noise active load is proposed.An efficient and low cost on-chip DC offset voltage canceling scheme is adopted with a high-input-impedance four-input OPAMP to buffer the output of the DC offset canceller(DCOC) block.The receiver has a measured input 1 dB compression point of 2 dBm and a sensitivity of 72 dBm in the presence of the large leakage signal from the transmitter.Only occupying a silicon area of 2.5 mm 2 and consuming 21 mA from a 1.8 V supply,the receiver makes the mobile UHF RFID reader to communicate with a transponder in a distance of 1 m conveniently.     

混凝土外加剂的复配效应

对混凝土外加剂复配后的优良效果进行了分析，从外加剂的选择、复配的原则、测试方法几方面进行了论述，通过几种外加剂的复配达到了某一种外加剂所不能达到的效果。