高质量的一级光栅1．55μmDFB激光器

本文详细叙述了ＤＦＢ激光器的设计要点和新的工艺。采用一级全息光栅和二步液相外延法批量研制出高稳定单纵模工作的１．５５μｍ分布反馈激光器（ＤＦＢ—ＬＤ）。外延片成品率＞４０％。器件特性：２５℃时阈值电流２０ｍＡ，单面光功率＞１０ｍｗ，主边模抑制比ＳＭＳＲ达４３ｄＢ（λ／４相移光栅），谱线宽度△ν－２０ｄＢ＝０．３ｎｍ，调制速率＞１．８ＧＨｚ。可靠性测试显示：高温监测光谱稳定，２５°Ｃ时阈值退化率△Ｉｔｈ／ｔ＜０．３ｍＡ／ｋｈ，对应器件预估寿命将超过１０万ｈ。     

康山金矿地质地球化学特征及其成因

康山金矿产在豫西熊耳山古隆起区的结晶基底太华群和盖层中元古界熊耳群地层接触界面附近，矿体严格受构造破碎蚀变带控制。流体包裹体，稳定同位素等研究表明，成矿物质来自太华群变质岩，成矿流体的性质与变质热液截然不同，而与花岗岩浆热液相近似。该矿床的形成与燕山期发生的同构造－花岗岩浆期热液活动有关，金沉淀成矿阶段有大气水的混入。     

Isolation and preliminary characterization of Pichia pinus mutants insensitive to glucose repression

A new method for the isolation of glucose repression-insensitive mutants in the methylotrophic yeast Pichia pinus was developed. The method is based on screening of small suspension samples derived from 2-deoxyglucose-resistant colonies for alcohol oxidase activity. Alcohol oxidase activity was evaluated by determination of formaldehyde excreted by cells. Mutants with glucose non-repressible alcohol oxidase and catalase synthesis were obtained. All mutants grew poorly on D -xylose compared to the wild type, whereas growth on L -arabinose was similar to the wild type. Changes in the glucose transport system were suggested to be responsible for altered growth characteristics and defective glucose repression.     

对我国酱油酿造几项新技术应用之浅见

本文概述了三十年来我国酿造酱油工业开展研究的六项新技术在现阶段的投产可行性，及进一步研究方向的看法。     

Application of SiC-Si functionally gradient material to thermoelectric energy conversion device

Because of its high–temperature chemical stability, SiC ceramic is a promising material for high-temperature device applications such as thermoelectric energy converters. However, the electrical conductivity of SiC ceramic is too low for it to be used as a thermoelectric energy converter at the cold junction. Therefore, we propose a SiC-Si functionally gradient material (FGM) in order to improve the electrical conductivity of the SiC ceramic at the cold junction. An SiC rod was fired in a temperature gradient furnace. One end of the SiC rod was maintained at 2473 K and the other end was maintained at 1973 K for 30 min. After firing, the porous SiC edge fired at 1973 K was dipped into molten Si in order to infiltrate molten Si into the porous SiC. The microstructure of the FGM is classified into three regions: the SiC-Si composite material; the porous SiC ceramic; and the densified SiC ceramic. The electrical conductivity, the Seebeck coefficient and the thermal conductivity for each region of SiC-Si FGM was measured at 300 K; a figure of merit was calculated. The figure of merit of the SiC-Si FGM at the cold junction, at room temperature, was 10⁸ times higher than that of a nongradient SiC ceramic.     

多孔粒状铵油炸药在边坡预裂爆破中的应用

通过工程实践，介绍了利用多孔粒状铵油炸药进行边坡预裂爆破的设计原理及施工工艺。该技术能确保预裂爆破质量。简化施工工序，大幅度降低爆破成本。技术经济指标优越。     

Extraction of penicillin G from simulated media by an emulsion liquid membrane process

The extraction of penicillin G from simulated media was performed by water/oil/water (w/o/w) emulsion liquid membranes (ELMs) and studied under various operational conditions in a batch system. The degree of extraction achieved was between 80% and 95% under specific conditions. A concentration of greater than nine times the initial concentration of penicillin G in the external phase was obtained in the internal phase. The pH of the internal aqueous solution, containing a basic salt, was theoretically calculated on the basis of the amount of penicillin G transported into the internal phase. The calculated results agreed with the experimental data well and were used to select a suitable type and concentration of a basic salt in the internal phase to give a pH within the range 5 to 8 where penicillin G was stable after the termination of extraction. The extraction of penicillin G was successfully performed by the ELM process with sodium carbonate in the internal phase.     

THE STICKY ISSUES OF DRYING

Unconrolled agglomeration of particles and adhesion of the particulate mass to wall surfaces are common severe problems in many drying operations. This paper reviews the mechanisms of interparticle and particle-surface attraction as well as the theory and the existing tests for characterising powders in terms of internal strength, wall friction and adhesion. The usefulness of the information obtained from these tests in dryer design and operation is critically reviewed. The importance of powder stickiness in various types of dryers is discussed and established methods of combating the problem are presented Recommendations an made for further research in the area of powder cohesion and adhesion.     

岳飞《满江红》爱国情结的当代审视

岳飞《满江红》词在中国诗歌史上享誉千古,其豪迈壮烈的艺术张力和悲壮的魅力,震撼并感染了无数国人,铸就了一代代中华儿女的爱国情怀。作为爱国诗篇,其爱国情结与忠君理念相伴共生,今天我们对之作当代审视和解读,应突破狭隘的爱国范畴,将其升华为中华复兴的精神动力。     

Ti-silicalite as catalyst for gas-phase ammoximation of cyclohexanone with molecular oxygen

The catalyst behaviour of titanium silicalite, which was found the most active and selective catalyst for liquid-phase ammoximation of cyclohexanone to the corresponding oxime with hydrogen peroxide, was investigated in the gas-phase ammoximation with molecular oxygen in and compared with those of pure silicalite and samples of vanadium and chromium silicalites. The results showed that Ti-silicalite is a selective catalyst not only in the reaction with hydrogen peroxide but also in the reaction with molecular oxygen. However, a big limitation was found in the poor activity of the silicalites which do not allow to reach high oxime yields.