Continuous formation of slurry ice by cooling water–oil emulsion in a tube

Water-silicone oil emulsion with an additive, (C₂H₅O)₃SiC₃H₆NH₂, was examined as a heat storage material. A spiral tube used as a heat exchanger was immersed in a low temperature bath and the emulsion was circulated in the tube to make ice continuously. Ice was separated from the ice–liquid suspension in an outlet tank. The amount of formed ice, the temperatures of the inlet and the outlet of the heat exchanger, and the temperatures in the tube wall were measured and the overall heat transfer coefficient and the heat flux through the tube were calculated. Experiments were carried out, varying the flow rate, the temperature of cooling brine, and the thickness of tube wall. The condition under which slurry ice was formed continuously without adhesion of ice to the cooling wall was clarified. Though decrease in the thermal resistance of the tube increased the rate of ice formation or raised the brine temperature, it narrowed the range of the flow rate and of the brine temperature in which slurry ice was formed continuously.     

固液相变蓄能的数学模型和自然对流换热系数的实验研究

引入自然对流换热系数 ,将固液蓄能数学模型简化为仅用能量方程加以描述。并通过实验测得相变过程的实际温度场 ,证明了自然对流固液相变换热的影响不可忽略 ,验证了固液相变界面移动速率随自然对流换热系数的增大而增大的定性关系     

微重力落塔电磁悬吊、释放技术研究

论述了微重力落塔电磁悬吊、释放、提升机构的关键技术,电磁释放过程的特性分析以及微重力落塔实际试验的情况。分析说明:悬吊、释放性能的好坏决定了试验落舱的微重力水平,也是微重力落塔试验能否成功的关键技术。     

A novel robust current control approach using adaptive line enhancer for three‐phase current‐source active power filter

An effective system control method is presented for applying a three‐phase current‐source PWM converter with a deadbeat controller to active power filters (APFs). In the shunt‐type configuration, the APF is controlled such that the current drawn by the APF from the utility is equal to the current harmonics and reactive current required for the load. To attain the time‐optimal response of the APF supply current, a two‐dimensional deadbeat control scheme is applied to APF current control. Furthermore, in order to cancel both the delay in the two‐dimensional deadbeat control scheme and the delay in DSP control strategy, an Adaptive Line Enhancer (ALE) is introduced in order to predict the desired value three sampling periods ahead. ALE has another function of bringing robustness to the deadbeat control system. Due to the ALE, settling time is made short in a transient state. On the other hand, total harmonic distortion (THD) of source currents can be minimized compared to the case where ideal identification of the controlled system can be made. The experimental results obtained from the DSP‐based APF are also reported. The compensating ability of this APF is very high in accuracy and responsiveness although the modulation frequency is rather low. © 2004 Wiley Periodicals, Inc. Electr Eng Jpn, 150(1): 50–61, 2005; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/eej.20014     

GaAs器件工艺中等离子刻蚀及计算机辅助监控技术研究

用Ｎ２气和ＮＦ３反应气体，在较低的刻蚀功率下实现了用薄正性光刻胶ＡＺ１５１８作掩模，均匀、快速刻蚀ＳｉＯ２，ＳｉＯＮ，Ｓｉ３Ｎ４，ＷＮ，Ｗ等材料的等离子刻蚀技术。利用到蚀过程中射频参数的变化和计算机技术，将射频参数的变化在计算机屏幕上实时显示，实现了计算机辅助监控和终点检测技术。     

任意型一维FIR数字滤波器设计新方法

本文介绍了一种设计任意型（宽带、窄带、低阶、高阶、低通、高通、带通、带阻）一维FIR数字滤波器新方法．给出设计不同类型滤波器的统一方法。各种类型滤波器脉冲响应的设计公式简单、计算方便。该方法消除了Gibbs现象．不仅克服了优化设计中收敛速度、设计精度及初值选取等问题，而且减少设计高阶滤波器的时间。最后，本文给出了各种类型滤波器设计的仿真结果。     

Nd：MgO：LiNbO3晶体的荧光光谱及其双晶体腔内互倍频实验

采用激光感生荧光技术测量了Ｎｄ：ＭｇＯ：ＬｉＮｂＯ３晶体的偏振荧光光谱，简要地说明了Ｎｄ：ＭｇＯ：ＬｉＮｂＯ３双晶体腔内互倍频的基本原理，并在实验中用染料激光作泵浦源实现了其双晶体腔内互倍频运转；得到５４３ｎｍ横模倍频绿光单端输出约ＹＭＷ，腔前泵浦阈值约３８ＭＷ，总转换效率约为１．３％。     

攀钢高炉焖砂口试验

分析了高炉冶练钒钛磁铁矿炉前砂口损坏的原因。对新型砂口泥进研制，同时改进了套砂口工艺，满足了攀钢高炉焖砂口的需要。攀钢高炉采用闷砂口工艺后，从根本上解决了铁水带渣问题，提高了铁水的洁净度。     

储层横向相变对剩余油分布的影响

处在构造边部、低部位的商５－５井，在改注水井排液中发现不含水的高产这种非常规现象，由此引起对地质因素的分析。浅湖相沉积的主体是滩砂微相，它可细分为“滩脊”和“滩侧”，其中“滩脊”砂体的泥质含量低，孔隙度、渗透率都较高，而“滩侧”则泥质含量高，物性差。在从“滩脊”砂体向“滩侧”过渡时，极易形成类似于砂体尖灭的岩性封堵，造成剩余油富集，而“滩脊”不一定就在构造的高部位。陆相沉积的砂体非均质性很强，孔隙度和渗透率在横向上的变化很大，高部位的油层水淹，低部位的油层不一定就高含水，这是因为砂体横向上的非均质性，使同一时间单元沉积的砂体很可能不连通。基于这些分析，地质工作者不妨运用沉积微相的原理在构造的低部位或边部寻找剩余油富集区，商５－５井的现实给了我们很好的启示。     

IC—V100电台锁相环频率合成器

本文从频率合成器的结构、功能入手,详细阐述了频率编程的原理及方法。