异步脑—机接口的空闲状态检测新方法*

提出一种新的空闲状态检测方法,以训练集中各类运动想象样本的类内散度和正确检测率为指标,结合接收机曲线确定分类阈值,设计最佳三分类器,并采用模糊化技术对预测标签进行处理。将该方法应用于2005年BCI竞赛数据IVc,测试的均方误差为0.278 7。实验结果验证了该方法的有效性。     

无定位图的预测误差差值扩展可逆数据隐藏*

将Tian差值扩展技术应用于彩色图像中,提出一种利用预测误差差值进行扩展嵌入的彩色图像可逆数据隐藏算法。针对传统差值扩展技术存在过分修改像素灰度值、须嵌入定位图等缺点,首先利用色彩分量间的相关性减小差值,并将差值扩展量分散到两个色彩分量中;其次,对直方图平移技术进行改进,使得同等嵌入率下图像质量达到最佳;最后由两个色彩分量中像素的预测值之和决定可用于扩展嵌入的像素,无须保存溢出定位图,提取端在提取信息时可无损地恢复原始图像。实验结果表明,与其他算法相比,该算法在同等嵌入率下可取得更好的图像质量,算法复杂度     

The design and analysis of unequal error protection fountain coding for multiple source networks over binary erasure channels

A novel network model of multiple source fountain coding is developed and a novel class of generic multiple source fountain codes with unequal error protection(UEP)property is proposed.The And–Or tree analysis technique is generalized to analyze the asymptotic performance of the proposed codes and a joint optimization method employing both linear and nonlinear programs is developed to optimize the degree distributions.Furthermore,we propose three basic methods to achieve UEP property and the performance of each method is discussed.We employ these analytical results and optimization method to design and discuss several UEP codes with two and four sources for different application scenarios.Simulation results verify that the proposed codes can be applied to the networks with any number of sources and can provide strong UEP property in various ways based on the proposed three basic methods.     

Multipath effects on vector tracking algorithm for GNSS signal

The vector tracking algorithm uses a single extended Kalman filter （EKF） to predict the time-delays and the Doppler deviations of the GNSS signal, while also estimating the user＇s position, velocity, and clock state. In this paper, the effects of multipath on the tracking performance of the vector delay / frequency lock loop （VDFLL） is studied for better application in the multipath environment. The error expressions of the measurements are given in theory. The tracking error caused by multipath is reduced by VDFLL, which is proved by the tracking error of VDFLL through a new iterating method. The theoretical analysis is verified by the Monte Carlo simulation.     

Effect of the Three Gorges Reservoir on vertical distribution of suspended sediment concentration and estimation accuracy of depth-average concentration in downstream reaches

The sediment regime in the middle Yangtze River has been significantly changed from quasi-equilibrium to nonequilibrium since the impoundment of the Three Georges Reservoir (TGR). To understand the effects of the TGR on vertical distribution of suspended sediment concentration (SSC) and estimation accuracy of mean concentration, vertical sediment concentration and flow velocity data at the Shashi and Jianli hydrological stations in the reach before and after the impoundment were collected. Comparisons and analysis of vertical profiles of SSC before and after the TGR impoundment show that after the impoundment of the TGR, due to the coarsening of sediment particle size, the reduction in sediment load, and the significant decrease in sediment saturation, the vertical distribution of SSC in the downstream reaches became more uneven under medium and low water flows, which was reflected in the vertical gradient and the fluctuation degree of SSC significantly increased. In addition, the depth-average sediment concentrations were calculated by the selected-point method and the mean values calculated by the “multi-point method” were regarded as the “true mean” to evaluate the accuracy of the mean value calculated by the “few-point method.” It was found that the relative errors for the selected-point method were mainly positive before impoundment but mainly negative after impoundment. Additionally, the correction factors of one-point, two-point, and three-point methods and the position of the near-bed substituted point for the five-point method were given to reduce the error when the point measurements were used to calculate the depth-average sediment concentration in the downstream reaches.     

实时洪水预报中基于岭估计的AR修正模型研究

为提高实时洪水预报精度,经常将水文模型与误差修正模型相结合,AR模型因其结构简单广泛应用于实时洪水预报误差修正。然而,实际应用显示,AR模型时常出现修正结果不稳定现象,表现为流量修正幅度过大,甚至出现“震荡”现象,严重影响修正效果。鉴于此,本文从矩阵特征值角度解释了AR模型出现不稳定现象的原因,并引入岭估计方法选择性利用流量信息更新自回归系数,使其更满足真实流量的涨落过程,增强该模型的稳健性。将新方法应用于蔺河口流域,结果显示岭估计方法显著提高了AR模型的稳健性,从而改善了模型修正效果,进一步提高了洪水预报精度。     

10 kV用无源电子式电压传感器的应用研究

针对传统技术中采用电磁式CT互感器存在的不足,提出了适用于10 kV的无源电子式电压互感器。根据电压互感器的工作原理,介绍了10 kV无源电子式电压互感器在电能表检定装置方面的意义。进一步分析了无源电子式电压互感器在电力设备中应用的重要性和必要性,该技术能够有效地避免传统技术在电力线路信号传输和处理时带来附加误差,大大提高电能计量、保护和测量系统的精度,推进了电力系统朝向数字化、电子化、自动化、网络化的方向发展。实验表明,采用10 kV的无源电子式电压传感器与传统CT互感器相比,误差精度提高了10%以上。     

基于解析解的四阶PDE曲面裁剪方法

该文提出了一种可以广泛应用于四阶PDE曲面的裁剪方法。利用PDE的参数域内的曲线在曲面上投影,得到所求裁剪曲面的边界曲线,然后通过边界曲线的导矢与曲面在边界曲线处的法向量得到边界曲线处的跨界导矢,最后以求得的裁剪曲面的边界曲线以及裁剪曲面在边界曲线处的跨界导矢为PDE曲面的边界条件,用四阶的PDE曲面方程求得PDE裁剪曲面。     

20CrMnTi螺旋锥齿轮中出现圆鼓泡问题的分析

在对机车转向架螺旋锥齿轮的粗、精加工中发现其表面鼓起许多小泡，将其剖开酸洗后呈现为小裂纹状，该现象在实际生产中较为罕见，对此进行分析，探讨，查找原因，确定这是钢材内气泡未能焊合的结果，为此制定了改进措施。     

A global cutter positioning method for multi-axis machining of sculptured surfaces

Traditional cutter positioning methods have defects of global errors and incomplete optimization. Because of using local differential geometry and focusing on the cutting contact point, these defects cannot be avoided and will deteriorate accuracy in precision machining. The authors presented the conception of actual cutting edge of a toroidal mill which was extended from cutting contact point, and pointed out its importance in programming. Instantaneous cutter position error (ICPE) was also investigated. A new global method based on the ICPE curve was presented. Taking the relationship between surface and cutter into consideration thoroughly, this global method shows many advantages which have been verified by simulation and cutting tests.