徐州地区采暖教室内CO2污染影响因素分析

在徐州市采暖季节期间，实测3所高校3栋教学楼典型教室的室内CO2浓度、室内人员密度、室外空气流速等参数，分析不同状态的教室、不同的人员密度和不同的室外空气流速对室内CO2浓度的影响，提出改善采暖教室内CO2浓度的措施。     

遇见另一种GPS——最时尚车载导航系统连连看

说到车载GPS，你如果仍认为只是那块行车导航用的地图屏幕，那你的脑袋该Update了。现在USB外接影像、语音控制、测控酒精浓度、数字电视、汽车防盗、记录车祸日志等功能都被集成到那块屏幕里了。这一期，我们就要带你去遇见另一种车载GPS……     

红外碳硫仪中绘图软件及其应用

介绍了LECO CS-444红外碳硫仪微机操作系统中绘图软件,分析了不正常碳(硫)释放曲线产生原因并制定了解决办法,举例说明碳(硫)含量平均值控制图、碳(硫)含量值控制图的使用方法.     

Study on Luminescence Properties of High-Density Phosphors BiTaO4：Pr^3＋ and BiTaO4

The photoluminescence properties of BiTaO4:Pr^3 and BiTaO4 at room temperature were studied, and the infrared transmission and diffusion reflection spectra of BiTaO4 were measured. The photoluminescence spectrum of BiTaO4 peaks at about 420, 440 and 465nm. There has an obvious excitation band from 330 to 370nm. The photoluminescence spectrum of BiTaO4:Pr^3 consists of the characteristic emission of Pr^3 , and its main peak is at 606 nm from ^3P0→^3H6 transition of Pr^3 . Its excitation spectrum consists of the wide band with maximum at 325nm, the wide band in the range of 375-430nm, and the characteristic excitation of Pr^3 .The bands at 325nm and 375-430nm may be from the absorption of the charge transfer transition of the tantalate group and defect energy levels in its forbidden band, respectively.There is energy transfer from host to Pr^3 . Because both the host density and photoluminescence peak intensity of BiTaO4:Pr^3 are superior to PbWO4, BiTaO4:Pr^3 may be a potential heavy scintillator.     

IF板与08Al板的成形性能研究

通过模拟成形性试验，对新型超深冲用IF钢板和传统冲压用08Al钢板的冲压成形性能进行了研究．结果表明：IF板的拉深性能、扩孔性能、胀形性能以及“拉深-胀形”复合性能等均优于08Al板，其中，扩孔性能和平面各向异性的改善最为显著；各项试验中，IF板的成形力普遍小于08Al板。     

CaO-BaO - Al2O3系二元化合物及三元化合物的热动力学性能

为下列化合物CaAl12O19、Ca2BaAl8O15、CaBa3Al2O7及CaBaAl4O8计算了在文献中尚未见到的热动力学常数△H^0 298、△S^0 298、△G^0 298，以及热容量与温度之间的关系式Cp=f(T)，并且确定了所研究的CaO—BaO—Al2O3系统中元素三角图中的相对面积及结线长度。     

电子材料

提升OLED发光效率磁性掺杂技术显神威；康宁扩充在华光纤生产厂；国产新型12英寸无位错硅单晶生长设备研制成功；中科院物理所合作建立国内首条碳化硅晶片中试生产线；NEC小型薄型高频砷化镓开关IC用于高速无线通信……     

Study on Effect of Flux on CeMgAl11O19：Tb^3＋ Phosphor

High calcination temperature is an important factor in the preparation process of CeMgAl11O19:Tb^3 . To decrease the temperature, different fluxes (H3BO3, MgF2 and AlF3) were tested in order to compare their influence on the luminescence property and particle size distribution of CeMgAl11O19: Tb^3 . The result shows that when the content of MgF2 is 0.1 mol/mol, the intensity of luminescence can attain a maximum. Furthermore, MgF2 can improve the particle size quality of the phosphor. So MgF2 can take the place of the conventional flux H3BO3 to prepare high quality CeMgAl11O19:Tb^3 phosphor. In addition, the relation between phosphor property and content of AlF3 was also studied. The crystal structure of the phosphor was analyzed by XRD method. The phase composition analysis shows that the reason of decrease of the brightness of CeMgAl11O19:Tb^3 phosphor is the emergence of TbAlO3 and α-Al2O3 during the preparation process.     

喷射沉积SiCP/Al复合材料及6066铝合金热挤压工艺的研究

作者应用喷射共沉积工艺制备 6 0 6 6 / Si Cp复合材料和 6 0 6 6铝合金锭坯 ,在不同的挤压比、挤压温度下挤压成　　型 ,用金相显微镜观察材料的显微组织 ,并测试了材料的力学性能。结果表明 :Si C/ Al复合材料喷射沉积状态的组织很疏松 ,存在许多的间隙 ,其密度约为理论密度的 86 % ,Si C颗粒在复合材料中分布不均匀 ,喷射沉积铝合金基体的致密度可达 90 % ;挤压过程使 Al/ Si Cp复合材料的大多数空隙消失 ,致密程度随挤压比的增大而增大 ,挤压比超过 14 .7后不会明显变化 ,而铝合金基体的致密程度与挤压比的变化关系不明显 ;挤压温度对材料的致密程度影响不大 ;Al/ Si Cp复合材料性能在挤压比超过 14 .7后变化不大 ;铝合金的性能不受挤压比变化的影响 ;而挤压温度过高使材料性能下降     

复合脱氧剂在我厂应用浅谈

通过使用含钡复合脱氧剂提高脱氧效果，改善钢中夹杂物数量、形态、分布，以提高冶炼质量，在大生产中可以更广泛的应用到对Al2O3夹杂，[Al8]有要求的CrNiMo等钢种。同时复合脱氧剂的使用可减少用铝量，节约成本，获得经济效益。