全文获取类型
收费全文 | 7689篇 |
免费 | 927篇 |
国内免费 | 577篇 |
专业分类
电工技术 | 356篇 |
综合类 | 372篇 |
化学工业 | 1961篇 |
金属工艺 | 624篇 |
机械仪表 | 381篇 |
建筑科学 | 55篇 |
矿业工程 | 298篇 |
能源动力 | 231篇 |
轻工业 | 220篇 |
水利工程 | 22篇 |
石油天然气 | 502篇 |
武器工业 | 25篇 |
无线电 | 1822篇 |
一般工业技术 | 1258篇 |
冶金工业 | 513篇 |
原子能技术 | 93篇 |
自动化技术 | 460篇 |
出版年
2024年 | 66篇 |
2023年 | 201篇 |
2022年 | 253篇 |
2021年 | 344篇 |
2020年 | 295篇 |
2019年 | 288篇 |
2018年 | 249篇 |
2017年 | 326篇 |
2016年 | 327篇 |
2015年 | 313篇 |
2014年 | 371篇 |
2013年 | 458篇 |
2012年 | 509篇 |
2011年 | 543篇 |
2010年 | 397篇 |
2009年 | 450篇 |
2008年 | 430篇 |
2007年 | 427篇 |
2006年 | 469篇 |
2005年 | 383篇 |
2004年 | 293篇 |
2003年 | 256篇 |
2002年 | 219篇 |
2001年 | 206篇 |
2000年 | 167篇 |
1999年 | 153篇 |
1998年 | 159篇 |
1997年 | 101篇 |
1996年 | 95篇 |
1995年 | 78篇 |
1994年 | 82篇 |
1993年 | 53篇 |
1992年 | 47篇 |
1991年 | 34篇 |
1990年 | 30篇 |
1989年 | 22篇 |
1988年 | 17篇 |
1987年 | 2篇 |
1986年 | 7篇 |
1985年 | 9篇 |
1984年 | 17篇 |
1983年 | 10篇 |
1982年 | 11篇 |
1981年 | 2篇 |
1980年 | 3篇 |
1979年 | 2篇 |
1978年 | 2篇 |
1964年 | 2篇 |
1957年 | 3篇 |
1951年 | 2篇 |
排序方式: 共有9193条查询结果,搜索用时 17 毫秒
61.
利用超声浸渍法分别制备了MnOx/TiO2和CeOx-MnOx/TiO2低温选择性催化还原(SCR)脱硝催化剂,并对其进行了SEM、EDS、BET及XPS等表征,在此基础上,研究了催化剂的低温SCR脱硝性能,重点考察了Mn负载量及Ce/Mn摩尔比对催化剂性能的影响,结果表明:当Mn负载量为15%时,催化剂具有较高的催化活性;Ce的掺杂有利于催化剂催化活性的提升,当Ce/Mn=0.8时,其催化活性最高,在180℃时达到了97.86%。另外,Ce的掺杂有利于提升催化剂的抗硫抗水特性,但仍有待进一步提升。 相似文献
62.
Cu-Fe-Cr原位复合材料的纤维相结构 总被引:3,自引:0,他引:3
通过感应熔炼和冷拔变形制备了Cu 16Fe 2Cr原位复合材料 ,将铜基体选择腐蚀后提取出了纤维 ,采用SEM和TEM观察分析了纤维相结构。在较低的应变量 (η =1.6 7)时 ,纤维不均匀 ,随着变形量的增大 (η =5 .42 ) ,纤维外形变得均匀。在 η =5 .42时 ,一个显著的特点是单根Fe Cr纤维分为一些由晶界隔开的平行亚单元 (宽度约为 10 0nm) ,通过亚单元共同的 [110 ]衍射获得了晶粒之间的相对取向 ,相邻晶粒的取向角在 3°~ 15°之间。 相似文献
63.
电解电容器铝箔纯交流腐蚀工艺影响因素的研究 总被引:2,自引:0,他引:2
对电解电容器铝箔交流腐蚀体系中各影响因素的研究结果表明,在电流密度为0.5A/cm2,温度为47±2℃;控制腐蚀液中Al(3+)含量及适量添加表面保护剂和辅助添加剂的条件下,可获得最大比电容。通过循环伏安曲线测试,探讨了各因素影响腐蚀的机理及相互关系。 相似文献
64.
STUDY ON Ni-Cr SYSTEM SOLAR SELECTIVE THIN FILMS PREPARED BY MAGNETRON REACTIVE SPUTTERING PROCESS 总被引:1,自引:0,他引:1
B. W. Wang H. Shen Guangzhou Institute of Energy Conversion The Chinese Academy of Sciences Guangzhou China 《金属学报(英文版)》2002,15(2):203-206
1. IntroductionSolar selective thiIl solid fil1us are the key part for solar heat collect'ors. But ll1ostfactories still produced solar absorptive filn1s by traditional tecIl11ology sucl1 as pai1ltillga1ld electrocl1eluical process that nlust result in po… 相似文献
65.
采用恒电流E-t曲线与旋转盘环电极方法研究了α黄铜(Cu32Zn)在酸性Na2SO4和HNO3稀溶液中的阳极溶解行为,得到的典型E-t曲线上存在几个特征区,证明在较低电流密度条件下的初始阶段只存在Zn的选择性溶解。用恒电位法研究了Cu32Zn选择性溶解过程,得到了按抛物线衰减的暂态扩散曲线,由i-t-1/2直线关系求得了不同介质中Cu32Zn中Zn的固相扩散系数D在10-16~10-13cm2·s-1数量级,发现中性介质中测出的D值比酸性介质中要大两个数量级。 相似文献
66.
67.
68.
离子溶液中快速传递及反应动力学过程的跟踪研究在实验上较为困难 ,为此基于离子选择性电极建立溶液中离子活度即时采集系统 ,并结合活度系数模型准确计算离子浓度 .该方法测定速度快 ,最小间隔为 1s,且所得离子浓度最大偏差小于 2 % .用此方法测定了硫酸钾溶解过程以及钛酸钾离子交换反应过程中钾离子浓度的变化 ,获得传统方法难以测定的数分钟内相关动态过程受溶剂、pH值的影响结果 .该方法可推广应用于研究其他各种动态过程 (如溶解、结晶、沉淀、离子交换、吸附和扩散等过程 ) 相似文献
69.
A new method of preparing CuO solar selective absorbing coating for medium temperature is presented. After pretreatment, brass
was overlaid with CuO by chemical plating. The effects of reactant concentration, reaction temperature and reaction time on
the absorptivity of CuO coating were investigated. The optimized condition of preparing CuO coating was obtained. The CuO
coating was analyzed with X-ray photoelectron spectroscopy (XPS) and scanning electron microscopy (SEM). In order to prolong
the period of use, the CuO coating was protected by TiO2. The experiment shows that the TiO2/CuO coating is more heat-resistant, acid-resistant, and wear resistant than CuO coating, without losing absorptivity markedly.
The TiO2 coating can reduce emissivity and protect the CuO coating.
Translated from Journal of Tianjin University, 2006, 39(12): 1485–1489 [译自: 天津大学学报] 相似文献
70.
Refractive index increments and density increments have been measured at 307.6K for polystyrene in binary solvents of 1,2,3,4-tetrahydronaphthalene (tetralin, TET) and cyclohexane over the whole range of solvent composition. Comparison of these increments with the corresponding values obtained at dialysis equilibrium (i.e. at constant chemical potential of low molecular weight species) yielded the coefficients of selective adsorption (γ1) of TET by the polymer. Positive values of γ1 were exhibited at solvent compositions up to 78% (v/v) of the thermodynamically better solvent, TET. Theoretical curves of γ1 vs. composition were calculated on the basis of, firstly, relevant interaction parameters and, secondly, interaction parameters in conjunction with solubility parameters. Both procedures afforded self-consistent results, which were, however, uniformly lower than the experimental values of γ1. 相似文献