Al2O3对唐钢高炉炉渣性能的影响

针对唐钢近2年提高进口矿配比后，Al2O3含量升高对炉渣流动性带来的不利影响，对唐钢高炉的炉渣性能进行了试验研究。并结合国内同行业的生产实践经验，从理论上分析了炉渣中Al2O3及MgO的适宜含量范围，着重论述了唐钢所处冀东矿区条件下降低Al2O3的主要途径及适应高Al2O3炉渣的具体措施。     

Effect of 3D lip deformations on elastohydrodynamic lip seals behaviour

The numerical simulation of comparative elastohydrodynamic lubrication between axisymmetrical and 3D elastic approaches on the radial lip seals is presented in order to determine the 3D effect of the elastic aspect of the seal lip. Indeed, the consideration of 3D model in other words the circumferential variation of the lip elastic deformation indicated a difference in the deformation distribution of the lip compared to the axisymmetrical approach. Consequently, the results show that the presence of the circumferential variation of the seal lip deformation has a significant effect on the pumping rate values.     

固体超强酸S_2O_8~(2-)/SnO_2-SiO_2催化合成环己酮1,2-丙二醇缩酮

采用沉淀-浸渍法制备了固体超强酸S2O28-/SnO2-SiO2,以它为催化剂催化环己酮和1,2-丙二醇合成了环己酮1,2-丙二醇缩酮;考察了带水剂种类及用量、酮醇摩尔比、催化剂用量、反应时间对产品收率的影响,并用正交实验对反应条件进行了优化。实验结果表明,适宜的反应条件为:n(环己酮)∶n(1,2-丙二醇)=1∶1.6、催化剂用量为反应物料总质量的2.0%、带水剂环己烷用量5.0mL、反应时间50min。在此条件下,环己酮1,2-丙二醇缩酮收率达到91.47%;催化剂的稳定性良好,在重复使用5次后环己酮1,2-丙二醇缩酮收率为82.20%,活性下降的主要原因为催化剂表面积碳和吸附了有机物;经傅里叶变换红外光谱和气相色谱质谱分析表明,产物为环己酮1,2-丙二醇缩酮,纯度为100%。     

Epitaxial growth of GaN on (0001) Al<Subscript>2</Subscript>O<Subscript>3</Subscript> via solution-cast seed layer formation process using Ga(mDTC)<Subscript>3</Subscript>

This paper reports an alternative method for the growth of GaN epitaxial layer on (0001) Al₂O₃ substrate by hot-wall vapor phase epitaxy technique. Tris (N,N-dimethyldithiocarbamato)-gallium (III), Ga(mDTC)₃ was introduced as a precursor material for the seed layer formation in the growth of GaN. Optimal growth conditions with seed layers formed by the Ga(mDTC)₃ concentration of 0.047 mol/L were identified: Growth temperature was found to be 850 °C, and optimal distance between the reactant outlet and substrate was determined to be 12.5 cm. Characterization results showed that this growth method produce high-crystallinity GaN epitaxial layers at a relatively lower growth temperature compared to the existing growth techniques and simplify the growth process.     

Response surface methodology applied for Orange II photocatalytic degradation in TiO2 aqueous suspensions

BACKGROUND: Heterogeneous photocatalysis is influenced by a number of parameters involving synergistic effects; hence, an experimental strategy design that considers interactions between the main variables is needed. The response surface methodology was applied for the investigation of photodegradation of 20 mg L^?1 Orange II in aqueous solutions and for optimization of color removal efficiency. Preliminary studies were performed to identify the parameters to be selected for optimization. RESULTS: The input variables considered for experimental design were: solution initial pH, oxidizing agent (H₂O₂) initial concentration and UV‐A irradiation time. The multivariate experimental design allowed the development of a quadratic response surface model to be used for the prediction of color removal efficiency over the full range of the experimental region. Under the optimum conditions established in the region of experimentation (pH = 6.9, [H₂O₂]₀ = 183 mg L^?1 and t = 32 min), a 100% color removal efficiency was obtained in experiments. CONCLUSIONS: It was found that the variables considered have important effects on color removal efficiency. The results demonstrate that the use of experimental design strategy is indispensable for successful investigation and adequate modeling of the process because the interdependence of the reaction parameters cannot be neglected. Copyright © 2008 Society of Chemical Industry     

Structural modelling of coprecipitated VTiO catalysts

A statistical study of the particle shape and size of pure V₂O₅ and TiO₂, and samples of coprecipitated V₂O₅---TiO₂ catalysts with different V/Ti ratios, has been performed. They were also characterized by XRD, EDAX, SEM and XPS. The results showed that pure vanadium pentoxide is compose by large square or needle-shaped particles, while pure titanium dioxide has small and rounded ones. VTiO samples presented an area and shape, depending on the V/Ti ratio.

These results and the spectroscopical characterization conducted to a particle model of the catalysts. Those VOTi samples with high V/Ti ratio would have large V₂O₅ crystals acting as support of a V/TiO₂ solid solution. In contrast, those samples with a low V/Ti ratio, would have the solid solution supporting vanadium pentoxide crystals.     

Al2O3—TiB2陶瓷刀具材料的高温氧化及其对刀具耐磨性能的影响

研究了Ａｌ２Ｏ３－ＴｉＢ２陶瓷刀具材料在１０００℃下的氧化行为，用ＸＲＤ、ＳＥＭ分析了氧化后的相组成及显微结构。结果表明：Ａｌ２Ｏ３－ＴｉＢ２陶瓷材料在１０００℃空气中氧化增重符合抛物线规律；随ＴｉＢ２含量的增加，该材料的抗氧化能力下降。     

2－重自补图论（Ⅲ）──计数理论

文中解决了２－重自补图的计数问题，获得了具有ｐ个顶点的２－重自补图的数目是其中Ｚ（Ａ）表示置换群Ａ的圈指标，Ｓ￣（２）＿ｐ表示ｐ次对称群的对群．