转向柱管承载能力的试验研究

在分析转向柱管花键部位应力集中情况的基础上,通过对某厂生产的转向柱管扭转破坏的试验研究,得到如下结论:①转向柱管的承载能力与其外花键齿与方向盘中心内花键齿之间的非接触区长度有关,以花键端部过渡圆弧的直径大小为宜;②安装方向盘总成时所施加在安装螺母上的拧紧力矩在70N.m左右时,转向柱管的承载能力最大。     

Influence of Coherent Flow Structures on the Dynamics of Suspended Sediment Transport in Open-Channel Flow

The influence of suspended sediments on coherent flow structures has been studied by simultaneously measuring the longitudinal and vertical components of the instantaneous velocity vector and the instantaneous suspended particle concentration with an acoustic particle flux profiler. The measurements were carried out in clear water and in particle-laden open-channel flows. In both cases, they clearly show the predominance of ejection and sweep phases that are part of a burst cycle. The analysis further demonstrates the importance of the ejection and sweep phases in sediment resuspension and transport. Ejections pick up the sediment at the bed and carry it up through the water column close to the surface. It is shown that ejections and sweeps are in near equality in the near-bottom layer, whereas ejections clearly dominate in the remaining water column. The implications of these results for sediment transport dynamics are discussed.     

Procedure for Measuring Low Concentrations of H2 and H2S Above a Water Surface

A simple measuring procedure for low concentrations of H₂ and H₂S (at the level of ppm fractions) above the surface of water by using sensitive gas analyzers is suggested. The procedure is easily accomplished in conditions outside the laboratory (under field conditions).     

Increasing the corrosion resistance of equipment due to the use of film-forming amines

Results of a study of tube specimens cut from hot-water boilers show that film-forming octadecyl amine (ODA) used in the process of preservation removes deposition from the surface of the metal. An ODA film is preserved on the surface after repeated washing of the latter with hot water. The concentration of chlorides at the surface of the metal after treatment with ODA is lower than before the treatment. __________ Translated from élektricheskie Stantsii, No. 11, November 2005, pp. 15–18.     

Stress Concentration Factors for a Circular Hole in Curved Beams Under Bending Loads

Abstract: As a contribution to the field of stress concentration studies, the case of circular hole in curved bar elements under bending is hereby studied. Trend values of stress concentration factors (SCF) are presented based on selected variables of the problem for two critical hole locations. The results will help to identify an SCF law for practical use by applying the statistical method of regression analysis. Two approximations obtained by means of computational methods are compared with those obtained by photoelastic experimental method.     

The rate of corrosion of concrete reinforcement and possibilities of its mathematical modelling

The paper describes a method for the mathematical modelling of steel reinforcement corrosion rate. This method is based exclusively on experimental results and expression of the influence of significant corrosion factors in the form of functional relations. The method takes into account the reality of the effects of corrosion factors, their contigency and complexity, and various circumstances occurring in practice. It represents one way towards the development of methods for the prediction of service life of reinforced concrete and structures.     

VARIATIONS IN ALFALFA JUICE SOLUTE CONCENTRATIONS AS WATER IS EVAPORATED

Alfalfa juice was extracted from plants during the graving phases of the first and second crops. The alfalfa juice was dried and solute concentrations were measured periodically during the process using freezing point depression (FPD) as an indicator. Solute/solvent weight ratios were calculated from the freezing point depression of fresh unconcentrated 'uice extracted from both firsc and second crops. At the time of harvest, tie FPD was a function of this ratio. The first and second crops behaved distinctively different during the drying process, with the second having a larger soluce concentration and a greater FPD at a given moisture content. The appearance of preci itate during the drying process and the general1 large FPD makes this materiay a questionable product for drying vitg low temperature processes.     

A New Method for Comparing Orthonasal and Retronasal Olfaction.

Odors seem to be perceived differently when presented ortho- or retronasally. In this study, stimuli of controlled concentration and duration were applied in either the anterior nasal cavity or epipharynx by means of air-dilution olfactometry. Stimulus concentration was monitored in the olfactory cleft. In Experiment 1, odor thresholds to a food (chocolate) and a nonfood (lavender) odor were lower for orthonasal, compared with retronasal, stimulation. In Experiment 2, intensity ratings to suprathreshold odor concentrations were significantly higher for orthonasal than for retronasal stimulation with hydro- hydrogen sulfide, but not phenyl ethyl alcohol. Accordingly, amplitudes and latencies of olfactory event-related gen potentials to retronasal stimuli were found to be smaller and prolonged, respectively. This indicates differential processing of olfactory stimuli presented through the retronasal or orthonasal routes. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

乙烯裂解炉内传递和反应过程综合数值模拟Ⅱ.反应管内传递和反应过程的数值模拟

采用乙烯裂解炉传递反应过程综合数学模型中的反应管数学模型，对工业裂解炉反应管进行了系统的数值模拟，得到了反应管内流场、温度场和浓度场的详细信息，揭示了反应管内流动、传热、传质和裂解反应的基本特点。模拟结果表明，沿反应管轴向油气吸热升温，裂解反应加剧，产物产率逐渐发生变化；沿反应管径向存在明显的流体流速和温度的变化，而产物产率的变化不如流体流速和温度的变化明显。通过比较湍流粘度和分子粘度的大小，认为29．975～30mm的径向区域为层流层，层流层的存在使得临近管壁的区域内流体流速和温度变化显著。